Aerosols Equipment in USA

Served | Office inNear
184 Results found
  • Category: Air & Climate ×

  • Subcategory: Aerosols ×

  • Location: USA ×

NUCON - Model SN-10 - Aerosol Generator

by NUCON International, Inc.     based in Columbus, OHIO (USA)

The NUCON Model SN-10 produces a uniform particle size distribution aerosol and can be used with a variety of challenge agents. Volumetric output is linear and particle size distribution is constant over a 10-100 psig input pressure range. The SN-10 is the perfect upgrade of the 'Laskin Nozzle' aerosol generator.

Aerosol Neutralizer - Model EAN 581 - Bipolar Electrostatic Discharger

by Topas GmbH     based in Dresden, GERMANY

The mechanical interaction of particles, especially solid ones, may cause undesirable levels of electrostatic charge. Test dusts must be generated with a high degree of reproducibility for instance when evaluating aerosol separation techniques such as cyclones, filters or impactors. Comparable results can only be obtained at controlled and similar ...

Diffusion Dryer - Model DDU 570 - Diffusion Dryer

by Topas GmbH     based in Dresden, GERMANY

The Diffusion Dryer DDU 570 has been developed mainly as additional equipment for the Aerosol Generators produced by Topas GmbH. The diffusion dryer consists of an Acryl tube with 2 caps on its ends and tube connectors. In the operation status the dryer is filled with Silica gel. The aerosol to be dried is streaming through 3 screen pipes which ...

Aerosol Spectrometer - Model LAP 322 - Aerosol Particle Size Spectrometer

by Topas GmbH     based in Dresden, GERMANY

The new developed Aerosol Particle Size Spectrometer series LAP 322 is based on optical single-particle measurements by means of scattered light measurement. It provides the determination of aerosol particle size distributions (0.2...40µm) and particle concentrations. By dint of high number of provided particle size classes a high particle sizing ...

Filter-Check SubMicron Aerosol Spectrometer/Filter Efficiency Monitor

by Grimm Technologies     based in Douglasville, GEORGIA (US) (USA)

The requirement for filter efficiency measurement (contamination control) has been outlined for years by ASHRAE 52.1 as a classical gravimetric method. Since the concentration of smaller particulate in ambient air is dramatically increasing, new methods need to be developed for air cleaning devices to study the removal efficiency by particle size. ...

Wide Range Aerosol Spectrometer

by Grimm Technologies     based in Douglasville, GEORGIA (US) (USA)

Gravimetric measurements have shown that the entire part of the mass of fine dust below 0.5 µm makes up less than 1%. But if the particles are counted, 80% below the size range of 0.5µm. It is not obvious if the particle number or the particle mass has a greater effect on the human health. Therefore it would be useful to have a device ...

Portable Aerosol Spectrometer

by Grimm Technologies     based in Douglasville, GEORGIA (US) (USA)

Grimm is a leading engineering technology provider undertaking research and design and production of different aerosol spectrometers for research as well as indoor and outdoor air quality monitoring. This powerful instrument gives the user the ability to continuously measure in real time particles in 31 different size channels and present the data ...

Model 3076 - Aerosol Generator

by TSI Incorporated     based in Shoreview, MINNESOTA (USA)

Aerosol Generator Model 3076 is a Collison-type atomizer that generates aerosols of constant particle size in concentrations over 107 particles/cm3. Its nominal aerosol flow rate is 3.0 L/min. Stainless-steel components make it suitable for the specialized applications listed below, in additon to basic aerosol research.

Model 3079 - Aerosol Generator

by TSI Incorporated     based in Shoreview, MINNESOTA (USA)

Aerosol Generator 3079 is a rugged, compact atomizer generates particles in concentrations up to 108 particles/cm3 and offers an adjustable flow rate from 1.0 to 4.2 L/min. A built-in, low-noise compressor provides compressed air, and the atomizer head is made entirely of stainless steel. Operating components are protected by a hood, making this ...

Topas - Model SAG 420 - Dust Disperser with Control Unit

by Particle Instruments, LLC     based in Vadnais Hights, MINNESOTA (USA)

A device for generating stable aerosols with options for precise aerosol mass flow and mass dosing. The SAG 420 can provide dosing ranges from 6 g/hr up to 12 kg/hr. Filling during operation is possible.

Need help finding the right suppliers?

Let the XPRTs do the work for you