gas monitoring Equipment in Guam

1272 Results found
  • Category: Air & Climate ×

  • Subcategory: Air Monitoring ×

  • Keyword: gas monitoring ×

  • Location: Asia & Middle East ×

  • Location: Guam ×


Boreal Laser - GasFinder2 - Open Path Gas Monitor

by Boreal Laser Inc.

GasFinder2 is a portable, battery-powered open path gas monitor providing one second response and broad dynamic range. Permanently calibrated, GasFinder2 is a small and light (less than 5kg) hand held solution. GasFinder2 response does not depend on path length, so a series of paths of different lengths (between 1m and 1000m) can be measured in ...

HORIBA - GA-360E Series - Trace Gas Monitor

by HORIBA Europe GmbH

The GA-360E/F360E Series is a line up of units that provide ultrahigh sensitive, highly accurate, continuous monitoring of trace amounts of impurities contained in gases (N2, O2, He, Ar, H2, and Air) used in the semiconductor manufacturing process. Utilizing a cross-modulation method, GA-360E/F360 Series units have no zero drift due to the ...

VCEM5000 - Flue Gas Flow Monitor

by Codel International Ltd

Continuous emission monitoring often only considers the density of the emissions (e.g mg/Nm3) In order to obtain a measurement of total emissions for pollution monitoring (e.g kg/hr) it is necessary to either calculate or measure flow within the gas stream. The VCEM5000 provides non-contact measurement of gas velocity using a time-delay ...

VCEM5100 - Flue Gas Flow Monitor

by Codel International Ltd

Continuous on-line analysis often only considers the density of the emissions (e.g mg/Nm3) In order to obtain a measurement of total emissions for pollution monitoring (e.g kg/hr) it is necessary to either calculate or measure flow within the gas stream. The VCEM5100 provides non-contact measurement of gas velocity using a time-delay correlation ...


DynOptic - DSL-240 MkIII - Single Pass Dust Monitor For Monitoring Dust Emissions using DDP

by DynOptic Systems Ltd

The DSL-240 Dust Monitor is an optical instrument designed to measure the concentration of dust or particulate matter in the exhaust gas passing through a duct, stack or flue.The DSL-240 uses the innovative Dynamic Detection Principle (DDP) in which a light beam emitted from the Transmitter passes across the stack to the Receiver, which measures ...

LaserGas - II - Open Path (OP) Monitor for High Performance Gas Analyser

by Neo Monitors AS

NEO Monitors LaserGas II Open Path (OP) Monitor is s a compact, high performance gas analyser for long distance monitoring in ambient air. Measurement lengths of up to 1000 m one way are possible. The OP Monitor utilizes a transmitter / reflector configuration to measure the average gas concentration along the optical line-of-sight. As option a ...


HORIBA - APNA-370 - Ambient NOx Monitor

by HORIBA Europe GmbH

The APNA-370 continuously monitors atmospheric NOX, NO2, and NO concentrations using a cross-flow modulated semi decompression chemiluminescence method. The APNA-370 employs an independent, internal dry-method sampling device to achieve the highest levels of sensitivity and accuracy. The dry method, due to its minimal maintenance requirements and ...

LaserGas - II - Multipass (MP) Cabinet Monitor

by Neo Monitors AS

The LaserGas II Multipass (MP) Monitor employs a multipass (Herriott) cell concept to combine long measurement path lengths with a compact analyser design. The long path will enhance the detection limit. Thus, the MP is the analyser of choice for measurement of trace levels of gases, offline in a controlled environment. It is also applicable for ...

Guardian - NG - Infrared Gas Monitor

by Edinburgh Instruments Ltd

The NEW range of Guardian infrared gas monitors supplied by Edinburgh Sensors offer near-analyser quality, continuous sampling, measurement and display of target gas concentrations. The ‘Guardian NG’ range provides high accuracy detection and measurement of either CO2 or CH4 gases, where detection level ranges of between 0 – ...

LaserGas - II - Single Path (SP) Monitor for In-Situ Measurement

by Neo Monitors AS

Single Path Monitors are designed for in-situ measurement in stacks, ducts, or reactors with typical path lengths in the range 0.5 to 20 meters. By-pass and extractive configurations are also possible. The monitors’ compact design comprises the transmitter unit with laser module; collimating optics, and main electronics and the receiver unit ...

Need help finding the right suppliers?

Let the XPRTs do the work for you