opacity Equipment in Andorra

Serving Andorra | Near Andorra
16 Results found
  • Category: Air & Climate ×

  • Subcategory: Air Monitoring ×

  • Keyword: opacity ×

  • Location: Europe ×

  • Location: Andorra ×

Opsis - Opacity Meter

by Opsis AB     based in Furulund, SWEDEN

Opacity metering instruments are supplied and integrated in the CEM system.

Model 445 - Compliance Opacity Monitoring System

by Thermo Scientific - Air Quality Instruments     based in Franklin, MASSACHUSETTS (USA)

The Model 445 is a robust dust concentration monitor for a broad range of applications. The instrument features automatic check cycles, built-in 4 point linearity check and contamination correction.

Integrated Emissions & Monitoring Systems

by Procal - Parker Hannifin Corp     based in Peterborough, UNITED KINGDOM

To comply with the specification of many CEMS it is necessary to monitor and report, not only the gas emissions, but also properties such as particulates or opacity. In addition to generating reports in formats acceptable to environmental agencies, it is often necessary to monitor Oxygen and Velocity. The Procal solution enables this data to be ...

OFS - Model 2000-W - Emissions/Air Flow Sensor

by Optical Scientific Inc. (OSi)     based in Gaithersburg, MARYLAND (USA)

OSi's patented Optical Flow Sensor (OFS) makes driftfree measurements across the entire stack, duct or pipe diameter and calculates a true average flow reading. The OFS 2000-W model is equipped with Automatic Gain Control (AGC) to compensate for variations in opacity caused by particulate matter or moisture carried in the stack flow. The OFS uses ...

Model OFS-2000C - Optical Flow Sensor (OFS) - Combustion Air Flow

by Optical Scientific Inc. (OSi)     based in Gaithersburg, MARYLAND (USA)

The OFS 2000C model is enhanced with temperature and pressure sensors to provide data for mass flow measurement. This latest development of our renowned air flow sensor offers operators more accurate control* of the combustion process resulting in increased efficiency, fuel cost savings and reduction of greenhouse gas emissions.

ADC - Model DSL-3000 - Advanced Particulate Monitor

by Toragon AB     based in Umea, SWEDEN

The DSL-3000 is an advanced particulate monitor that offers high accuracy measurements with virtually zero drift and very low maintenance. Using our Dynamic Detection Principle (DDP), sometimes known as scintillation, the DSL- 3000 is immune to the long term drift seen in traditional opacity monitors (caused by a build up of dirt or dust on the ...

Continuous Emission Monitoring Systems

by Advanced Control Systems, Inc.     based in Bellingham, WASHINGTON (USA)

ACS designs and builds custom continuous emission monitoring systems to fit your needs. These systems are configured to comply with 40CFR Part 60 and Part 75. Systems can include monitoring for 02, C02, NOx, CO, S02, Total Hydrocarbons, Air Toxics, Flow, and Opacity. We can also provide you with custom data acquisition and control packages or ...

Model G1000 - Smoke Density Monitor

by Green Instruments A/S     based in Bronderslev, DENMARK

The G1000 Smoke Density Monitor is primarily used to monitor smoke emissions from all kinds of combustion but also to monitor the soot contamination of inert gas. Our patented technology transfers the light source from the smoke stack directly to the monitoring cabinet contrary to traditional opacity monitors used on land. It provides a prompt and ...

Model EMS611 - Dust Monitor

by Environmental Monitor Service, Inc.     based in Yalesville, CONNECTICUT (USA)

The EMS611 provides continuous, low maintenance, precision measurement of dust (mg/m3(N), Optical Density and Opacity. It is designed for monitoring visible smoke and particulate concentrations in the exhaust gas of industrial combustion or air filtration processes. The EMS611 dust monitor utilizes dual beam measurement and the highest quality ...

WinDAC - Data Acquisition System

by Total Air Pollution Control Pty Ltd. (TAPC)     based in Unanderra, AUSTRALIA

BHA's WinDAC data acquisition, monitoring and control system is an exciting new development in precipitator operating technology. Compatible with Microsoft Windows XP or Windows Me, WinDAC is the most powerful, easiest to use tool for gathering and trending data relevant to your process. WinDAC not only monitors the operation of your precipitator, ...

Need help finding the right suppliers?

Let the XPRTs do the work for you