opacity monitoring Equipment in Slovakia

Serving Slovakia | Near Slovakia
14 Results found
  • Category: Air & Climate ×

  • Subcategory: Air Monitoring ×

  • Keyword: opacity monitoring ×

  • Location: Europe ×

  • Location: Slovakia ×

Opsis - Opacity Meter

by Opsis AB     based in Furulund, SWEDEN

Opacity metering instruments are supplied and integrated in the CEM system.

Model EMS611 - Dust Monitor

by Environmental Monitor Service, Inc.     based in Yalesville, CONNECTICUT (USA)

The EMS611 provides continuous, low maintenance, precision measurement of dust (mg/m3(N), Optical Density and Opacity. It is designed for monitoring visible smoke and particulate concentrations in the exhaust gas of industrial combustion or air filtration processes. The EMS611 dust monitor utilizes dual beam measurement and the highest quality ...

OFS - Model 2000-W - Emissions/Air Flow Sensor

by Optical Scientific Inc. (OSi)     based in Gaithersburg, MARYLAND (USA)

OSi's patented Optical Flow Sensor (OFS) makes driftfree measurements across the entire stack, duct or pipe diameter and calculates a true average flow reading. The OFS 2000-W model is equipped with Automatic Gain Control (AGC) to compensate for variations in opacity caused by particulate matter or moisture carried in the stack flow. The OFS uses ...

ADC - Model DSL-3000 - Advanced Particulate Monitor

by Toragon AB     based in Umea, SWEDEN

The DSL-3000 is an advanced particulate monitor that offers high accuracy measurements with virtually zero drift and very low maintenance. Using our Dynamic Detection Principle (DDP), sometimes known as scintillation, the DSL- 3000 is immune to the long term drift seen in traditional opacity monitors (caused by a build up of dirt or dust on the ...

Integrated Emissions & Monitoring Systems

by Procal - Parker Hannifin Corp     based in Peterborough, UNITED KINGDOM

To comply with the specification of many CEMS it is necessary to monitor and report, not only the gas emissions, but also properties such as particulates or opacity. In addition to generating reports in formats acceptable to environmental agencies, it is often necessary to monitor Oxygen and Velocity. The Procal solution enables this data to be ...

Model 445 - Compliance Opacity Monitoring System

by Thermo Scientific - Air Quality Instruments     based in Franklin, MASSACHUSETTS (USA)

The Model 445 is a robust dust concentration monitor for a broad range of applications. The instrument features automatic check cycles, built-in 4 point linearity check and contamination correction.

Teledyne - Model ML675 - Dilution-Extractive System

by Teledyne Monitor Labs, Inc.     based in Englewood, COLORADO (USA)

The Teledyne ML675 dilution-extractive system can be used in 40CFR75, 40CFR60, and process control applications. In this system, sample is prepared for analysis by diluting stack gas with clean, dry instrument air at the probe location. Since no moisture is removed with dilution, measurements for SO2, NOx, CO, THC and CO2 are made on a wet basis.

IntelliCEMS - Model IC Series - Straight Extraction Or Dilution Extraction Systems

by Cemtrex Inc.     based in Farmingdale, NEW YORK (USA)

The IC Series IntelliCEMSTM include straight extraction or dilution extraction systems complete with sample probes, heated sample bundles, sampling systems, analyzers, and Data Acquisition Systems (DAS). Our CEMS are pre-engineered and packaged to measure a wide range of gases and pollutants for compliance with state and federal EPA regulations ...

Altech - Custom CEMS Systems

by Altech Environment USA     based in Geneva, ILLINOIS (USA)

Altech's custom system design services will provide a system to meet the clients' requirements. Altech custom CEMS systems employ the make and model instruments and peripheral equipment specified, or we can assist with determining equipment needs.

OSI - Model OFS-2000 - Emissions/Air Flow Sensor

by Optical Scientific Inc. (OSi)     based in Gaithersburg, MARYLAND (USA)

OSi's patented Optical Flow Sensor (OFS) makes drift-free measurements across the entire stack, duct or pipe diameter and calculates an accurate average flow reading. It is the only flow sensor that gives a true non-contacting cross-stack flow measurement of the process. The OFS uses our EPA Method 14 approved optical scintillation technology. The ...

Need help finding the right suppliers?

Let the XPRTs do the work for you