gas controllers Equipment in Australia

Served | Office inNear
655 Results found
  • Category: Air & Climate ×

  • Subcategory: Air Pollution Control ×

  • Keyword: gas controllers ×

  • Location: Australasia ×

  • Location: Australia ×

Crowcon - Model F-Gas - Infrared Fixed-Point Detector

by Crowcon Detection Instruments Ltd     based in Milton Park, UNITED KINGDOM

A high quality infrared fixed-point detector that delivers dependable detection of freon gases. Available for detecting a range of different refrigerant gases and also sulphur hexafluoride (SF6), the Crowcon F-Gas Detector can be connected to any control system that accepts an analogue signal. Housed within an IP54 rugged enclosure, the F-Gas ...

SmartTrak - Model 100 Series - Compod Programmable Control Module

by Sierra Instruments, Inc.     based in Monterey, CALIFORNIA (USA)

With its advanced mass flow sensor capabilities, the Compod™ control valve, coupled with Sierra’s SmartTrak 100 mass flow meters (MFM’s) or controllers (MFC’s) greatly simplifies air flow control systems and permits networking of multiple instruments using open-source MODBUS RTU protocol. Compod™ also monitors the ...

Varec - Model 180 Series - Double Port Pressure Regulators

by Varec Biogas     based in Cypress, CALIFORNIA (USA)

The Varec family of 180 Series Double Port Pressure Regulators have been designed for use on vapor recovery systems where sensitive control at low pressures is required. Models include the 180, 181, 186 and 187 regulators for upstream and down-stream control. Flow curves are provided to assist you in selecting the proper size for your vapor ...

Side-Trak - Model 840 - Analog Gas Mass Flow Controller

by Sierra Instruments, Inc.     based in Monterey, CALIFORNIA (USA)

Get accurate, reliable mass flow control with Sierra’s SideTrak® Model 840 analog mass flow meter and controller. With precise primary standard calibration to measure any clean, dry gas under with low pressure drop – including oxygen, mixtures, toxics, corrosives and combustibles – the SideTrak flow meter has proven ...

DIA.NE - Gas Engine Control

by Clarke Energy     based in Liverpool, UNITED KINGDOM

DIA.NE is a user-friendly engine management system. A colour graphic display provides a clear overview of all information. This diagnostic instrument features an effective alarm management system with all error messages date stamped and clearly presented in tabular form to identify the sequence of events.

LEANOX - Combustion Technology

by Clarke Energy     based in Liverpool, UNITED KINGDOM

LEANOX is a lean-mixture combustion control. It was developed by GE Jenbacher and has been patented worldwide.

Touchpoint - Model 4 - Controller

by Honeywell Analytics     based in Hegnau, SWITZERLAND

A controller providing protection from flammable, toxic and Oxygen gas hazards, with up to 4 points of detection. The Touchpoint 4 controller provides protection of personnel and plant from flammable, toxic and Oxygen gas hazards when used with up to four Sensepoint gas detectors. Self-contained, fully user configurable and wall mounted, a ...

Model CP-60 1, 2 or 3 - Channel Wall Mount Controller

by ENMET Corporation     based in Ann Arbor, MICHIGAN (USA)

The CP-60 controller is designed for monitoring remote 4-20 mA gas sensor/transmitters or similar devices. The instrument provides 24 VDC power, audio/visual alarms, alarm relays and other features.

MX-Series Enguard Controllers

by ENMET Corporation     based in Ann Arbor, MICHIGAN (USA)

These instrument control modules can be used to power and monitor a variety of 24 Vdc, 4-20 mA, sensor/transmitters. They can be connected to any combination of up to four(MX-42A) oxygen, toxic or combustible gas sensor/transmitters.

QEL - Model QAS-200 Series - Dual Channel Controllers

by Quatrosense Environmental Ltd. (QEL)     based in Richmond, ONTARIO (CANADA)

The QAS-200 Series Dual Channel Controller is a microprocessor based unit that monitors input signals and provides relay outputs for alarm and control. The units are switch selectable for either 4-20 mA DC input (standard) or broad spectrum solid state sensor inputs for hazardous gas detection.

Need help finding the right suppliers?

Let the XPRTs do the work for you