emissions standards Equipment in Malawi

Serving Malawi | Near Malawi
78 Results found
  • Category: Air & Climate ×

  • Subcategory: Emissions Management ×

  • Keyword: emissions standards ×

  • Location: Africa ×

  • Location: Malawi ×

StakGard - Tribo Electric Indicative Dust Monitor

by Codel International Ltd     based in Bakewell, UNITED KINGDOM

The StakGard uses the well-proven tribo-electric effect to directly measure mass particulate concentration by sensing the frictional charge created when particles collide with a conductor. The advanced electronics of the StakGard detect this signal and present it to the operator via a modulating LED display. The StakGard indicative particulate ...

Model VCEM5000 - Flue Gas Flow Monitor

by Codel International Ltd     based in Bakewell, UNITED KINGDOM

Continuous emission monitoring often only considers the density of the emissions (e.g mg/Nm3) In order to obtain a measurement of total emissions for pollution monitoring (e.g kg/hr) it is necessary to either calculate or measure flow within the gas stream. The VCEM5000 provides non-contact measurement of gas velocity using a time-delay ...

Land - Model 4500 MkIII - Opacity and Dust Emissions Compliance Monitor

by Land Instruments International     based in Dronfield, UNITED KINGDOM

The Land Model 4500 MkIII has reset the industry standard on compliance opacity and dust concentration measurement. Combining the unique features of three patented technologies, the 4500 MkIII achieves the highest available specification for the principal performance parameters, as defined by the internationally recognized ASTM Standard D 6216-07.

GRAPHITE - Model 52M - Heated FID Total Hydrocarbon (HC) Analyzer

by Environnement S.A     based in Poissy, FRANCE

Heated FID Total Hydrocarbon (HC) Analyzer.-MCERTs and TÜV certified-Complies with EN 12619 & 13 526 standards (with He/H2 fuel)-Fitted with FID for continuous and simultaneous measurement of Total Hydrocarbons (THC), Non-methanic Hydrocarbons (NmHC) and Methane (CH4) in compliance with EN 12619

Model MIR 9000H - Continuous Stack Emission Monitoring Gas Analyzer

by Environnement S.A     based in Poissy, FRANCE

Continuous stack emission monitoring gas analyzer available in 2 versions for the simultaneous and continuous measurement of:  NH3 and H2O, CO, CO2, NO, NO2, SO2, HCl, HF, O2 in addition of the NH3 and the H2O.  Designed to measure wet and corrosive sample. TÜV certified as compliant to the European standard EN15

Land - Model FGA 900 Series - Range of Stack Gas Emissions Analysers

by Land Instruments International     based in Dronfield, UNITED KINGDOM

The FGA range of analyzers use dual sensor technology to measure the levels of Nitrogen Oxides, Carbon Monoxide and Oxygen in flue gas. O2, CO, NO, NO2, NOX.

Babbitt - Model FT4100 - Dust Emission Flow Transmitter

by Babbitt International, Inc.     based in Houston, TEXAS (USA)

The FT4100 is designed to sense dust emissions passing through a filter in a dust collector or bag house. This very sensitive device allows the user to continuously monitor the level of emission, and record the data.

Babbitt - Model FS10000 - Dust Emission Flow Switch

by Babbitt International, Inc.     based in Houston, TEXAS (USA)

Emissions from dust collectors and bag houses has become a major environmental issue. Babbitt has two products which monitor these processes, and assist in reducing the level of dust emissions. The FS10000 Flow Switch is able to alarm and/or shut down a dust collector when a weak filter is detected BEFORE it becomes a major failure and source of ...

Procal - Model 5000 - UV Emissions Analyser

by Parker Procal     based in Peterborough, UNITED KINGDOM

Procal 5000 is an ultra-violet (UV), continuous emission monitoring analyser, designed for in situ analysis of gas-phase emission components. Using absorption spectroscopy, Procal 5000 stores and analyses the full UV spectrum and calculates the gas emission concentrations. A typical system comprises an in situ analyser, an integral calibration ...

AppliTek - Beta Absorption Analyzers

by AppliTek NV - Environmental Analysis Division     based in Nazareth, BELGIUM

The Beta absorption analyzer of the AppliTek CEM portfolio is designed for the real-time measurement of particulate emissions from stationary sources such as stacks, incinerators, furnaces. Isokinetic sampling assures that the sample flow rate within the analysis stage is equal to that of the flue gas stream in the stack, and results in reliable ...

Need help finding the right suppliers?

Let the XPRTs do the work for you