exhauster Equipment in Belarus

Serving Belarus | Near Belarus
514 Results found
  • Category: Air & Climate ×

  • Subcategory: Exhaust ×

  • Keyword: exhauster ×

  • Location: Europe ×

  • Location: Belarus ×

HI-Q - Sample & Return Exhaust Lines

by HI-Q Environmental Products Company     based in San Diego, CALIFORNIA (USA)

Many air sampling procedures call for remote site sampling where the vacuum source (air sampling pump) cannot be conveniently located in the same area where sampling is required. This may be due to a variety of reasons including explosive sampling environments, inaccessibility, and noise level restrictions. For this reason, HI-Q has developed two ...

HORIBA - Model MEXA-1400QL-NX - Exhaust Gas Analyzer

by HORIBA Europe GmbH     based in Leichlingen, GERMANY

The MEXA-1400QL-NX is an exhaust gas analyzer for four nitrogen compounds simultaneously,i.e. NO, NO2, N2O and NH3, utilizing mid-infrared Quantum Cascade Laser technology. By using the high power, high resolution lasers, the analyzer can measure each component accurately,even in low concentrations, with minimum interference from other components ...

Exhausters With Pre-Inlet

by Aerzener Maschinenfabrik GmbH     based in Aerzen, GERMANY

For pre-inlet cooling the housing is equipped with an additional third socket on the suction side. The lube oil supply is effected by splash oil lubrication. The conveying chamber is sealed by a sealing system. Driving shaft by double radial seal rings with grease barrier. Direction of flow vertically from top to bottom. The drive can be effected ...

Sierra - Model ExhaustTrak - Raw Exhaust Mass Flow Meter

by Sierra Instruments, Inc.     based in Monterey, CALIFORNIA (USA)

Discover the benefits of direct in-situ exhaust measurement with ExhaustTrak. With our roots in flow measurement and automotive test, Sierra has developed ExhaustTrak, an innovative spin on a centuries old flow meter technology that solves one of today’s greatest flow measurements challenges.

Exhaust Back Pressure Control Valve

by Sierra Instruments, Inc.     based in Monterey, CALIFORNIA (USA)

Our exhaust back pressure control and simulation package centers around our proprietary exhaust back pressure valve, a fast-acting ALL stainless steel butterfly valve controlled by an electronic actuator. The valve adjusts to accurately simulate the effective back pressure of a full vehicle exhaust system, but on a closed test bed ...

Carbon Dioxide Scrubbers

by Clarke Energy     based in Liverpool, UNITED KINGDOM

Although the utilisation of gas is one of the cleanest types of fuel during combustion there are some trace contaminants in the raw exhaust which would make it unsuitable for the above applications. Typically selective catalysts can be utilised in order to remove different contaminants from the raw exhaust gas.

CL.AIR - Exhaust After-Treatment System

by Clarke Energy     based in Liverpool, UNITED KINGDOM

The CL.AIR Exhaust After-Treatment System for GE’s Jenbacher gas engines is a thermal regenerative post-combustion system for engine exhaust gases. Since no catalytic reactions take place during the thermal treatment of the exhaust, as it is insensitive to impurities in the fuel gas, the CL.AIR system is particularly suitable for use with ...

Tecam - Ventilation Air Methane (VAM) Treatment in Coal Mines

by Tecam Group     based in Llinars del Vallès, SPAIN

Coal extraction requires forced ventilation in mine galleries to evacuate the methane toward the exterior to make air quality healthy for workers. That mine air contains large quantities of methane that must be treated before being issued into the atmosphere. The best technology to treat VAM (Ventilation Air Methane) is Regenerative Thermal ...

GE - Selective Catalytic Reduction (SCR) for CHP Plants

by Clarke Energy     based in Liverpool, UNITED KINGDOM

Along with the supply of a GE Jenbacher cogeneration plant,  Clarke Energy can provide exhaust gas catalysts for the scrubbing of exhaust gases. Exhaust gas purification systems are able to reduce harmful exhaust gases by up to 95%. The exhaust gas purification system can consists of up to three consecutive stages, depending on the ...

Tecam - Catalysers for Combustion Gas and NOx Treatment

by Tecam Group     based in Llinars del Vallès, SPAIN

Tecam Group can help our customers’ reduce civil work machinery NOx emissions, such as: Hoisting Machinery. Public Works Machinery. Diesel Machinery. Solution Designed for: Reducing civil work machinery NOx emissions. Advantages. Easy to install in mobile machinery to ensure they comply with current legislation requirements.

Related Terms for exhauster

Need help finding the right suppliers?

Let the XPRTs do the work for you