pump stations Articles

527 Results found
  • Keyword: pump stations ×

Puny drain pumping station

by Bedford Pumps Ltd  (Jun. 25, 2011)

Bedford Pumps Ltd has recently completed the installation of the Mechanical and Electrical plant at a new pumping station at Puny Drain. The drain which is controlled by the East of Ouse, Polver and Nar IDB’s, drains an area of low lying land to the south of Kings Lynn. The recent redesign of the drainage system in the area necessitated the ...

North Creek pumping station, King County, WA

by Morris Pumps  (May 11, 2011)

The new North Creek Pumping Station in King County, Wash., had to maintain the Department of Natural Resources' national reputation for outstanding reliability. To make sure it did, the design team applied the most advanced pump technology and vibration prevention methods. And the designers and utility put extra attention on meeting operations and ...

Pump Station Biotrickling Filter Odor Control

by Lantec Products, Inc.  (Jan. 12, 2007)

Odor Complaints Eliminated at Florida Lift StationEffective Control of Odor Surges to 800 ppmv H2S$50,000 Savings IntroductionNumerous cities and counties in central Florida are experiencing explosive growth. Examples abound in articles in Florida newspapers. Population is growing “by leaps and bounds” per the Seminole Chronicle (6/9/06) ...

Mono nov munchers clear up pumping station blockages

by NOV Mono - Mono Pumps Ltd  (Feb. 26, 2010)

Broadbottom pumping station in Manchester was built in 1991 to deliver an average daily flow of 70 megalitres ofdomestic sewage to Hyde Waste Water Treatment Works, five miles away. Before the installation of the Muncher twin shaft grinders to protect the three sets of duty, assist and standby pumps - six pumps in total - there were serious ...

Rehab or build new? A comprehensive approach to lift station analysis

by Water Environment Federation (WEF)  (Oct. 13, 2007)

An existing wastewater lift station was evaluated for feasibility of rehabilitation and continued use as an influent pump station for a future wastewater treatment plant. The lift station was evaluated on structural reliability, on-site storm equalization, pumping capacity, location, and cost. These data were compared with the preliminary design ...

Pumping Station Modifications to Comply with ANSI/HI 9.8 Improve Performance While Lessening O&M Requirements --- Two Case Studies

by Water Environment Federation (WEF)  (Oct. 21, 2006)

Oversized wet wells in wastewater pumping stations lead to the accumulation of grit, sludge and floatable materials. Trench-type wet wells in compliance with ANSI/HI 9.8, the American National Standard for Pump Intake Design, minimize wet well volume and facilitate wet well cleaning through periodic pump down operations. Two pumping stations, the ...

Landis sewerage authority lift station monitoring case study

by Mission Communications, LLC  (Apr. 16, 2012)

Landis Sewerage Authority (LSA) serves the greater Vineland, New Jersey area. LSA was facing some typical problems monitoring their 23 lift stations. “Phone line problems with our autodialers were increasing almost as fast as Ma Bell's prices,” says Sam Hess, Collection System Plant Manager for the 8.2 MGD authority. ...

There’s No Use Crying Over Spilled Sewage: Using Standby Lift Station Pumps to Prevent SSOs before They Happen

by Water Environment Federation (WEF)  (Oct. 21, 2006)

Power outages and unforeseen mechanical failures create the potential for system distress and sanitary sewer overflows (SSOs) in wastewater collection and treatment systems. In accordance with a lawsuit initiated by Mobile Bay Watch (Mobile, Alabama), the Mobile Area Water and Sewer System (MAWSS) chose to install an automatic dry priming backup ...

Suwanee Creek pumping station, Gwinnett County, GA

by Morris Pumps  (May 11, 2011)

That's high head," says Roger Toebben, P.E., about the 350 feet of total dynamic head handled by the Suwanee Creek Pumping Station, which has been up and running since January 2001. "There are a few sewage pumping stations like this, but they're not real common." Very high static head and a long force main (42,500 feet) led to the notably elevated ...

East hull pumping station case study

by Castings Services Group (CSG)  (May 30, 2013)

Client: Yorkshire Water CSG provided two 1200mm Hydraulic Cylinder Gate Valves as part of the East Hull Pump Station overhaul. CSG worked in partnership with Pacific Valves Ltd on the £16m flood prevention project commissioned by Yorkshire Water. Due to the low ground levels in and around Hull flooding can often be an issue. The new pumping ...

Need help finding the right suppliers?

Let the XPRTs do the work for you