Combustion Equipment

815 Results found
  • Category: Energy & Renewables ×

  • Subcategory: Combustion ×


by ENETEX GmbH     based in Steinau a. d. Str., GERMANY

The ENETEX burner is a special innovation for TOS and COS systems and air heaters. The oxygen required for combustion is taken directly from the preheated exhaust gas or from the process air before heating. The temperature-resistant design and special formation of the fuel lance and burner basket are responsible for the long service life of our ...

Eurotherm - Burner

by SAACKE GmbH     based in Bremen, GERMANY

When short, uncomplicated planning and commissioning is important for standard applications or compact process firing systems (for example support firing systems with waste incineration plants), your first choice is the EUROTHERM series of pressure atomizers. With an integrated fan, optimized air flow and integrated fuel fittings, these burners ...

EM-GROUP - Combustors

by EM GROUP BV     based in BB Geleen, NETHERLANDS

Combustors combine a combustion room with an internal (multy) fuel burner(s). Such a design brings the advantage of a preheat section for the combustion air by means of a triple combustor wall; this preheated air (400 – 600 o C.) enhances the combustion process considerably.

Wood Pellet Burner

by McAree Engineering Ltd     based in County Monaghan, IRELAND

The V-Mac Wood Pellet Burner and Pellet Store Cabinet is an economical and easy way of protecting your Wood Burner. The cabinet is comprised of a separate wood burner compartment and wood pellet store. Wood pellets can easily be augered into the wood burner.  There is a removable access hatch on the roof and the back enclosure can be unbolted ...


by DCR, Incorporated     based in West Fargo, NORTH DAKOTA (USA)

A sealed-in burner with a 120 degree temp raise so even on cold days a contractor can meet production rates. All sand heaters are set to run on natural gas, or vapor propane with optional Fuel Oil. The direct drive blower with 12 oz pressure uses less horsepower with more heat retained in the rotary drum. Burner control sys-tem strokes burner from ...

Enclosed Flares

by Pollution Systems     based in Houston, TEXAS (USA)

An Enclosed Flare is a thermal oxidizer specially configured to handle high VOC streams. The Oxidizer is typically designed to accommodate the high energy process discharge stream with excess air for combustion. The heat value of the process stream is significant and can potentially be able to provide most of the necessary temperature / energy for ...


by VAS Energy Systems Ges.m.b H.     based in Großgmain, AUSTRIA

The VAS technology enables the construction of complex firing systems for the combustion of all kinds of wood as fuel as a basis for cogeneraion or hot water plants. By using a special emergency chimney placed on the combustion chamber VAS ís guaranteeing a high safety standard in every heat or cogeneration plant.

UltraBurn - Combustion Catalyst System

by Emissions Technology, Inc. (ETI)     based in Houston, TEXAS (USA)

UltraBurn Combustion Catalyst Systems can reduce fuel consumption by up to 20%. The system has been field-tested on more than 2,500 engines since its commercial introduction. Many of these customers have conducted their own before/after tests. The results vary by application and engine type, but are always significant enough to warrant continued ...

Vapor Combustor Unit (VCU)

by Anguil Environmental Systems, Inc.     based in Milwaukee, WISCONSIN (USA)

Thermal flaring technologies used for the destruction of Hydrocarbons, Volatile Organic Compounds (VOCs) or Hazardous Air Pollutants (HAPs) are designed in two basic configurations; open and enclosed flame burners. Recent regulations on visible emissions, vapor radiation, Greenhouse Gases (GHGs) and noise pollution have driven industry away from ...

Totally Enclosed Ground Flare

by Callidus Technologies - a Honeywell Company     based in Tulsa, OKLAHOMA (USA)

The Callidus TEGF flare system consists of a refractory lined cylindrical flare structure designed to have combustion take place within the cylinder. This type of enclosed flare system was originally designed to eliminate the light and noise from the flaring of waste gases. This flare has been used extensively in the combustion of waste gases from ...

Need help finding the right suppliers?

Let the XPRTs do the work for you