Combustion Equipment in India

Serving India | Office in IndiaNear India
756 Results found
  • Category: Energy & Renewables ×

  • Subcategory: Combustion ×

  • Location: Asia & Middle East ×

  • Location: India ×

Gasification

by PacWest Global, LLC     based in Beaverton, OREGON (USA)

Gasification allows us to safely transform wasted resources into clean energy while reducing the volume of waste by over 90%.

Air-cooled Grate For Grate Systems

by Hitachi Zosen Inova     based in Zurich, SWITZERLAND

The air-cooled grate with its robust design has proven to be very reliable. Depending on the waste properties, it is the most favourable solution in terms of capital and maintenance costs. With conventional air-cooled systems, the primary air is used for the combustion process and for the cooling of the grate bars.

Model HTS - High Temperature Flare Stack

by Biogasmart     based in Gadesco Pieve Delmona, ITALY

HT-S Type are high-performance enclosed ground flare stacks where biogas combustion temperature, flame retention time and destruction efficiency are the results to be achieved. Combustion occurs inside the base refractory combustion chamber and is completed in the upper cylindrical chamber lined with fiberceramic, under a controlled environment.

Model HE - High Efficiency Biogas Flare Stack

by Biogasmart     based in Gadesco Pieve Delmona, ITALY

HE-Type is an enclosed ground flare; combustion takes place within a cylindrical chamber lined with fiberceramic and this causes a higher destruction efficiency of the biogas in comparison to open flares. Enclosed combustion also makes flame and noise less perceptible and for this reason these flares are normally selected for installation in ...

Combustion

by VAS Energy Systems Ges.m.b H.     based in Großgmain, AUSTRIA

The VAS technology enables the construction of complex firing systems for the combustion of all kinds of wood as fuel as a basis for cogeneraion or hot water plants. By using a special emergency chimney placed on the combustion chamber VAS ís guaranteeing a high safety standard in every heat or cogeneration plant.

Laboratory Gas Burners to DIN 30665 with DVGW Approval

by JUCHHEIM Laborgeräte GmbH     based in Bernkastel Kues, GERMANY

Juchheim's D series (= DIN) of laboratory burners are manufactured and tested according to DIN 30665. Among other matters, the standard requires that the gas flow cannot be completely shut off. This is achieved through the specially shaped jet needle. In this way the flame can be controlled between minimum and maximum levels, but cannot be shut ...

Model ST 35 - Burner

by Nu-way     based in Droitwich, UNITED KINGDOM

This burner is suitable for use with both light oil and kerosene with single stage on/off operation. Available for both conventional and ducted air options and is typically suitable for domestic and commercial hot water boilers, air heaters. Sterling oil and gas burners are commonly used by many boiler manufacturers including Worcester Bosch, ...

Model HTV Support - High-Temperature Flares

by C-nox GmbH & Co. KG     based in Neumünster, GERMANY

High-Temperature Flares for environmentally compatible combustion, lean gases require added support gas, such as natural gas or propane. Here again, the controlled gas/air ratio ensures the required combustion temperature of >1000 °C inside the combustion chamber. As a variation from the standard technology, in this flare type the required ...

Combustible Cabinet

by Shanghai SYSBEL Industry & Technology Co., Ltd.     based in shanghai, CHINA

• SYSBEL safety cabinets are used for storing flammable, combustible and corrosive materials.• Various sizes and volumes are available.• All SYSBEL flammable cabinets accord with OSHA 29 CFR 1910.106 & NFPA CODE 30 standards• Flammable cabinets have double fireproofing steel plates.The insulate temperature space between two plates is 38mm• 1mm ...

KINEDIZER - Model LE - Burner

by Maxon Corporation- a Honeywell Company     based in Muncie, INDIANA (USA)

Field proven low emissions. State-of-the-art low NOx firing - adjustable for application flexibility. Lower NOx and less excess air than standard KINEDIZER® burners. Rugged design for oxidizers, process heaters, kilns, furnaces, dryers, waste incineration and other high temperature applications. Available in a wide range of capacities, each ...

Need help finding the right suppliers?

Let the XPRTs do the work for you