thermal power generation Equipment

33 Results found
  • Category: Energy & Renewables ×

  • Subcategory: Energy Consulting ×

  • Keyword: thermal power generation ×

Thermal Power

by Leme Engenharia     based in Belo Horizonte, BRAZIL

The need to expand the energy matrix in Brazil and Latin America implies the diversification of energy sources. Thermal Power is a feasible technical and economical alternative for expansion of the local power generation systems, as it offers power stability and provides safe operational features for the electrical systems. Being aware of this, we ...

Ocean Thermal Energy Conversion

by Ocean Thermal Energy Corporation (OTEC)     based in Lancaster, PENNSYLVANIA (USA)

Ocean Thermal Energy Conversion (OTEC) is a base-load renewable energy production process particularly suited for tropical zones. This proven technology uses the ocean's temperature differential between the warm surface water and the cold deep water to generate both electricity and potable water. This 24/7 energy production technology does not ...

Ocean Thermal Energy Conversion (OTEC)

by Makai Ocean Engineering, Inc.     based in Kailua, HAWAII (USA)

Ocean Thermal Energy Conversion (OTEC) is a process that can produce electricity by using the temperature difference between deep cold ocean water and warm tropical surface waters. OTEC plants pump large quantities of deep cold seawater and surface seawater to run a power cycle and produce electricity. OTEC is firm power (24/7), a clean energy ...

JFE - Waste Heat Recovery Power Generation (WHRPG) System

by JFE Engineering America Inc.     based in Long Beach, CALIFORNIA (USA)

JFE Engineering’s Waste Heat Recovery Power Generation (WHRPG) system is capable of efficiently recovering thermal energy from the hot exhaust gases produced by various industrial processes such as waste incineration, gas turbine power generation, steel-making, cement production, etc. and transforming it into electric power.

Solar Thermal Power Generation

by Hiro Energy-Tech Limited     based in Mumbai, INDIA

Solar thermal power plants produce electricity in much the same way as conventional power stations. The difference is that they obtain their energy input by concentrating solar radiation and converting it to high temperature steam or gas to drive a turbine or engine. Four main elements are required: a concentrator, a receiver, some form of heat ...

SEMCO - Model FV Series - Fresh Air Ventilator

by SEMCO LLC     based in Columbia, MONTANA (USA)

The SEMCO FV (Fresh Air Ventilator) Series of outdoor air pre-conditioners have been specifically designed to reduce the energy required to heat or cool outdoor air by up to 80 percent. The FV pre-conditioner allows the HVAC system to effectively and economically accommodate the three-to-four-fold increase in outdoor air quantities, which is ...

Solar Power

by Sun & Climate     based in Miami, FLORIDA (USA)

Solar power is a renewable energy that allows to reduce the dependency on dirty combustible sources, such as nuclear and thermal energies, with and added benefit to the environment. Besides being a clean type of energy, it also is an endless source, as opposed to other sources, such as oil and coal. The use of solar power contributes to reducing ...

Ligentoplant - Power-Heat Cogeneration for Use the Power of the Wood

by Ligento green power GmbH     based in Nuremberg, GERMANY

The production process of the modern plants of the Ligento green power GmbH is based on power-heat cogeneration. Heat and electricity are produced from natural and renewable resources such as wood. For this purpose, Ligentoplant converts wood chips through thermochemical processes into clean, energy-rich generator gas. This gas is then burnt in an ...

JASC - Thermal Relief Valve

by Jansens Aircraft Systems Controls (JASC) Inc.     based in Tempe, ARIZONA (USA)

Thermal Relief Valve is a passive valve designed to relieve fuel pressure build-up due to fuel heating. (Thermal expansion yet the Thermal Relief Valve remains closed during normal liquid fuel system operation).

Met-Pro Systems - Direct Fired Thermal Oxidizers

by Met-Pro Environmental Air Solutions (A Subsidiary of Met-Pro Corporation)     based in Owosso, MICHIGAN (USA)

The Met-Pro Systems brand provides thermal oxidizers of virtually every design. These thermal oxidizers, also called enclosed flares, afterburners, or incinerators, can include heat recovery systems such as recuperative and regenerative thermal oxidizers. They can also include steam production through the use of waste heat boilers (WHB or HRSG). ...

Related Terms for thermal power generation

Need help finding the right suppliers?

Let the XPRTs do the work for you