flow modeling Equipment in Jordan

Served | Office inNear
15 Results found
  • Category: Environmental Management ×

  • Subcategory: Environmental Modeling ×

  • Keyword: flow modeling ×

  • Location: Asia & Middle East ×

  • Location: Jordan ×

Pipeline Simulator for Gas

by ATMOS International Ltd.     based in Didsbury, UNITED KINGDOM

ATMOS SIM models the hydraulic behaviour of both gas and liquid pipelines accurately. SIM Offline supports the planning and design analysis of pipeline networks, SIM Online gives the pipeline operators a view into the un-instrumented areas of the pipeline to assist them in running their pipelines. The same configuration applies to ATMOS SIM ...

Pipeline Simulator for Liquid

by ATMOS International Ltd.     based in Didsbury, UNITED KINGDOM

ATMOS SIM models the hydraulic behaviour of both gas and liquid pipelines accurately. SIM Offline supports the planning and design analysis of pipeline networks, SIM Online gives the pipeline operators a view into the un-instrumented areas of the pipeline to assist them in running their pipelines. The same configuration applies to ATMOS SIM ...


Tekran - Model 2537X - Automated Ambient Air Analyzer

by Tekran Instruments Corporation     based in Knoxville, TENNESSEE (USA)

The Tekran 2537 performs continuous long-term, unattended analysis of gaseous elemental mercury with unmatched accuracy, sensitivity, and reliability. The Tekran 2537 is easy to setup, use, and maintain and has long been known for its stable performance in rugged conditions. Our instruments have been installed at both Polar Regions, on ocean ...

Shallow Draft Rotomite - Model SD110 - Self Propelled Dredges

by SRS Crisafulli, Inc.     based in Glendive, MONTANA (USA)

A major feature of SRS Crisafulli’s hydraulic dredges is their ability to pump dredgedsludges and slurries over substantial distances to remote disposal sites. The actualdistance in a particular application depends on several variables including: thenature of the slurry – i. e., the specific gravity, weight, and concentration of solids inthe ...

Side-Trak - Model 840 - Analog Gas Mass Flow Controller

by Sierra Instruments, Inc.     based in Monterey, CALIFORNIA (USA)

Get accurate, reliable mass flow control with Sierra’s SideTrak® Model 840 analog mass flow meter and controller. With precise primary standard calibration to measure any clean, dry gas under with low pressure drop – including oxygen, mixtures, toxics, corrosives and combustibles – the SideTrak flow meter has proven ...

Grundfos - Complete Pressure Boosting System (Hydro MPC)

by Grundfos Pumps Corporation     based in Bjerringbro, DENMARK

The Grundfos Hydro MPC booster systems are made to the very highest standards. Thanks to the CU 352 controller, they handle even the most difficult boosting jobs with ease and accuracy. All components have been combined with focus on quality and efficiency. The Grundfos Hydro MPC booster systems are designed to last: sturdy, compact units with ...

Grundfos - Model SQ 3 - Submersible Pumps

by Grundfos Pumps Corporation     based in Bjerringbro, DENMARK

The Grundfos SQ 3' submersible pumps offer a wide performance range, making it easy to find a model that will suit your individual requirements. The SQ is a compact, 3' multistage centrifugal pump that can be installed in a borehole no larger than the pump itself. With their built-in electronics, SQ pumps are very easy to install and operate. They ...

Model BX-750 - Deep Sea Geochemical Box Corer for Marine Geological Sampling

by Ocean Instruments, Inc.     based in San Diego, CALIFORNIA (USA)

The BX-750-AL Deep Sea Geochemical Box Corer is the largest corer in the BX-7 series and is used primarily at deep ocean depths. The corer is manufactured in two configurations which differ only in the ability to remove the sample box. The Model BX-750(A) carries a sample box 30cm x 30cm x 90cm with an ability to remove the entire sample box, ...

Model 001 & 002 - Open Channel Flow Meters

by Valeport Ltd.     based in Totnes, UNITED KINGDOM

The Valeport ‘Braystoke’ Model 001 and Model 002 flow meters provide a cost effective and reliable method of monitoring flow in a variety of environments, including salt, fresh and effluent water, from shallow streams to tidal waterways. The meters benefit from the design of the impeller bearings, which give low threshold velocity and ...

Constant Monitoring System: Model CMS 600

by Environmental Equipment Engineering, Inc.     based in Mechanicsville, VIRGINIA (USA)

Pollutants like milk, wine and acids or alkaline products are water-soluble and can be extremely harmful to the environment. By monitoring the run-off from your site you can prevent the potential penalties associated with a spill of these products. The Fox CMS600 system is designed to allow site run-off to flow to the stormwater network while ...

Related Terms for flow modeling

Need help finding the right suppliers?

Let the XPRTs do the work for you