explosion protection Equipment in Connecticut

Serving Connecticut | Office in ConnecticutNear Connecticut
88 Results found
  • Category: Health & Safety ×

  • Subcategory: Emergency Management ×

  • Keyword: explosion protection ×

  • Location: USA ×

  • Location: Connecticut ×

Explosion Protection Valve

by ATEX Brand- und Explosionsschutz GmbH     based in Moehnesee, GERMANY

The explosion protection valve prevents the dust explosion from expanding beyond the place where it is fitted. The valve acts as a flame barrier at the same time. In the event of an explosion, the valve detects the event through the kinetic energy preceding the pressure wave, and closes of the affected area. It is primarily used in clean air ...

NFPA 68: Standard On Explosion Protection Using Deflagration Venting

by Fenwal Protection Systems (FPS)     based in Ashland, MASSACHUSETTS (USA)

NFPA 68: Standard on Explosion Protection by Deflagration Venting products offered by FENWAL Protection Systems. Deflagration is a combustion that propagates through a gas or along the surface of an explosive at a rapid rate driven by the transfer of heat. FENWAL Protection Systems are designed to comply with NFPA 68 and to detect and contain ...

Ashcroft - Model A-Series - Miniature Explosion Proof Pressure Switch

by Ashcroft Inc.     based in Stratford, CONNECTICUT (USA)

The Ashcroft A-Series miniature pressure switches are designed for tough applications where conventional designs often don't measure up. A rugged 316 SS enclosure gives uncompromising protection. Materials of construction have been selected for long life. Precision snap acting micro switches are featured and fully encased to prevent moisture from ...

Elvex ARC-Shield Face Protection

by Elvex Corporation     based in Bethel, CONNECTICUT (USA)

An arc flash hazard is a dangerous condition associated with the release of energy caused by an electric arc. This explosive condition includes a broad spectrum of electromagnetic energy, plasma, fragments and a spray of molten materials. Key Benefits: Protection value (ATPV) for Elvex FS-18ARC10 Shield is 8 cal/cm². Protection value (ATPV) ...

Lift-Gard - Flat Venting System

by Elfab Limited     based in North Shields, UNITED KINGDOM

ATEX approved Lift-Gard is the only flat venting system that combines an integral frame and detection system in one unit.Designed for use in protecting Vertical Bucket Elevators from harmful explosions, Elfab's Lift-Gard offers a low cost, easy to install and maintenance free solution to help comply with latest regulatory developments.

ATEX - Nozzle Systems

by ATEX Brand- und Explosionsschutz GmbH     based in Moehnesee, GERMANY

ATEX offers a variety of nozzle systems, so that the required functionality of the explosion suppres-sion pressure system can be ensured in each individual case. The choice of the right system, however, is always made in the light of the particular process concerned. The ATEX nozzle systems are particu-larly used in fields where hygienic ...

CP MICROTHERM - Model C - Electric Heater

by INTERTEC-Hess GmbH     based in Neustadt/Donau, GERMANY

The very versatile MICROTHERM line consists of electric heaters designed to heat the air in the enclosure by convection.Wherever possible, a heater designed for temperature class T3 should be selected. A temperature fuse is integrated in the heater that cuts off the power in case of a technical failure or excessive heating resulting from an ...

Intrinsic Safety

by HafcoVac     based in Midland Park, NEW JERSEY (USA)

HafcoVac explosion proof industrial vacuums are suitable for use in Class I, Class II, and Class III environments, Division 1 and 2.

Explosion Vent Systems Protect

by Fenwal Protection Systems (FPS)     based in Ashland, MASSACHUSETTS (USA)

Explosion vent panels are designed to minimize damage to process vessels, ducts, and other industrial structures, in the event of a deflagration involving combustible materials. These explosion vent panels are designed to ruptures at a predetermined pressure, to allow the fireball and explosive pressure to vent into a safe area. FENWAL Explosion ...

Explosion Diverter

by ATEX Explosion Hazards Ltd.     based in Lymm, UNITED KINGDOM

The TV Explosion Diverter from Atex is a mechanical explosion isolation device which protects ductwork and attached vessels by venting flame and pressure to a safe area.

Need help finding the right suppliers?

Let the XPRTs do the work for you