explosion protection Equipment in Mississippi

Served | Office inNear
116 Results found
  • Category: Health & Safety ×

  • Subcategory: Fire Safety ×

  • Keyword: explosion protection ×

  • Location: USA ×

  • Location: Mississippi ×

Chemical Explosion Isolation

by Fike UK     based in Maidstone, UNITED KINGDOM

Chemical Explosion Isolation is achieved through a rapid discharge of a chemical explosion suppressant to prevent the flame from continuing through to other areas of your process system. An explosion detector initiates the release of the extinguishing agent when it detects a deflagration pressure or flame front – preventing the propagation ...

A.YITE - Model GE-316 - Paddle Flow Switch (Anti Explosion Proof)

by A.YITE Technology     based in Shanghai, CHINA

Smart flow switch, explosion proof, GE-316 Paddle Flow Switch is specially designed for the Flow Monitoring of Water Source, Water-Loop Heat Pump Air Conditioning Systems and Heat Pump Water Heater..This paddle water flow switches is produced as the Explosion Proof standard, could be used in the anti explosion environment. International ...

Explosion Proof BeamSafe

by Scientific Technologies, Inc     based in Fremont, CALIFORNIA (USA)

10 m (32 ft.) range Compact size Alignment indicator Reverse polarity and short circuit protected Sensitivity control Controller DIN-rail mount controller 24 VDC power Manual or automatic reset Red-Green LEDs flash to indicate error codes Indicator LEDs for controller and safety output status BeamSafe III-C is designed in accordance with IEC ...

Explosion-, Spark and Flame Isolation

by Rembe GmbH Mess- und Regeltechnik     based in Brilon, GERMANY

The EXKOP® system provides safe, economic and easy explosion-, spark and flame front isolation. The quench valves protect interconnected equipment by high speed closure of a fast acting pinch valve. The quench valve is triggered by a 100 % reliable signal from the maintenance free triple-section bursting disc, the Q-Rohr®-3 or by IR- ...

xWatch - Model X7050 - Explosion-Proof Camera

by Det-Tronics - Detector Electronics Corporation     based in Bloomington, MINNESOTA (USA)

The xWatch explosion-proof surveillance camera provides a high-resolution color image, real-time viewing, and pre/post event analysis. The xWatch camera is designed specifically for remote, high-risk, and hard-to-access areas.

Lift-Gard - Flat Venting System

by Elfab Limited     based in North Shields, UNITED KINGDOM

ATEX approved Lift-Gard is the only flat venting system that combines an integral frame and detection system in one unit.Designed for use in protecting Vertical Bucket Elevators from harmful explosions, Elfab's Lift-Gard offers a low cost, easy to install and maintenance free solution to help comply with latest regulatory developments.

Explosion Proof MS4600-EP-30

by Scientific Technologies, Inc     based in Fremont, CALIFORNIA (USA)

ATEX Certified 14 mm (0.55 in.), 19 mm (0.75 in.) or 30 mm (1.18 in.) resolution 13.5 m (45 ft.) range Protected heights from 263 to 1219 mm (10.4 to 48 in.) Simple 'two-box' design - no separate control box required No cable required between transmitter and receiver Two PNP safety outputs designed to directly switch machine primary control ...

Ashcroft - Model A-Series - Miniature Explosion Proof Pressure Switch

by Ashcroft Inc.     based in Stratford, CONNECTICUT (USA)

The Ashcroft A-Series miniature pressure switches are designed for tough applications where conventional designs often don't measure up. A rugged 316 SS enclosure gives uncompromising protection. Materials of construction have been selected for long life. Precision snap acting micro switches are featured and fully encased to prevent moisture from ...

Model One Series Ex d - Explosion-Proof Electronic Pressure Switches

by United Electric Controls     based in Watertown, MASSACHUSETTS (USA)

The One Series electronic pressure switches and electronic temperature switch set the standard for solid-state digital process monitoring. With a fully adjustable set point & deadband and 0.1% repeatability, the One Series is suitable for a wide variety of harsh and hazardous applications. Available in Type 4X enclosures for explosion-proof ...

GreCon - Model BS 7 - Spark Detection and Extinguishment Systems

by GreCon Greten GmbH & Co. KG     based in Alfeld-Hannover, GERMANY

In many different industries where bulk materials are processed, fires and dust explosions occur again and again worldwide with far-reaching consequences. Interruptions of the production process that are caused this way lead to substantial follow-up costs – quite apart from the direct damage to persons and property. With GreCon spark ...

Need help finding the right suppliers?

Let the XPRTs do the work for you