calibration systems Equipment

378 Results found
  • Category: Monitoring & Testing ×

  • Subcategory: Calibration Systems ×

  • Keyword: ×

Model 408 Series - Nitric Oxide Calibration Source

by 2B Technologies     based in Boulder, COLORADO (USA)

The Model 408 Nitric Oxide Calibration Source is a portable source of nitric oxide that allows one to calibrate any nitric oxide monitor.  The instrument scrubs NO from ambient air and produces either zero air or air having a mixing ratio of NO in the range 10-1,000 parts-per-billion by volume (ppbv).  The desired NO concentration is ...

Model 2021FG/FGS/FS - Fixed-Orifice Flowmeters

by ORANGE RESEARCH INC.     based in Milford, CONNECTICUT (USA)

Our flowmeters are designed for those applications where a rotameter is not appropriate. Consider the inherent problems of rotameters--they are difficult to read, especially with dirty or opaque fluids, have low pressure ratings and allow vertical orientation only. Orange Research low flow flowmeter models have large dials with bold markings and ...

Model 502500 - Flowmeter

by Knauer-Wissenschaftliche Gerätebau     based in Berlin, GERMANY

The Flowmeter model 502500 is specifically designed for monitoring of the flow rate in chromatography systems. It periodically displays the current flow rate on a large LC display and simultaneously records the measured value to a RS-232 controller. This enables PC supported data processing. It operates with a one point calibration. 115 Volt ...

Owlstone - Model OVG-4 - Calibration Gas Generator

by Owlstone Nanotech, Inc.     based in Norwalk, CONNECTICUT (USA)

The Owlstone Vapour Generator (OVG-4) is a compact, cost effective calibration gas system, which can generate NIST traceable, precise, repeatable and accurate concentrations of chemicals and calibration gas standards. Designed for calibration of industrial and scientific gas sensors, the OVG-4 incorporates permeation tube technology and can ...

Sonimix - Model 3022 - Multigas Calibrator

by LNI Schmidlin SA     based in Chatelaine-Geneva, SWITZERLAND

The multigas calibrator with GPT, ozone and self re‐generable zero air generator, Sonimix 3012/3022, is an instrument designed to calibrate manually or by remote control up to 6 monitors installed in an air pollution monitoring station, such as SO2, HC, BTX, CO, NOx and O3.

Dynacalibrator - Model 120 - Calibration Gas Generators

by VICI Metronics     based in Poulsbo, WASHINGTON (USA)

Standard features on Model 120 include a glass or PTFE permeation chamber with screw cap access, solid state proportional temperature controller with digital readout of set point and chamber temperature, heater switch with LED indicator, flowmeter and flow control valve, span and overflow outlets, 12 VDC internal pump, activated charcoal scrubber, ...

FieldCAL - Hand-Held AE Signal Generator

by Physical Acoustics Corporation(PAC)     based in Princeton Jct, NEW JERSEY (USA)

So how do you make sure all your new and existing Acoustic Emission products are calibrated and performing at maximum capacity –- the FieldCAL. MISTRAS' low-cost, hand-held AE signal generator is battery-powered and can produce all the necessary AE signals to verify the correct operation of AE sensors, preamplifiers and AE systems -– ...

Dynacalibrator - Model 500 - Calibration Gas Generators

by VICI Metronics     based in Poulsbo, WASHINGTON (USA)

This innovative design features two separate permeation chambers with independent temperature control systems. The chambers can be used independently, or together to combine concentrations of trace components. Separate solenoid valves allow the carrier flows to be switched from the dilution flow to a vent port.

Model 300 - Temperature Calibrator

by Anville Instruments Ltd     based in Lanarkshire, UNITED KINGDOM

Temperature Calibrator 300 For thermocouple sensor calibration of the complete EaziVal system the temperature of the thermocouples must be maintained in a stable state. EaziVal provides multi-point calibration at 'high', 'low' and 'check-point' temperatures with the scale and offset values automatically calculated for each sensor. The Anville 300 ...

Felix - Rain Gauge Test Equipment

by Felix Technology Inc.     based in Concord, ONTARIO (CANADA)

The new mobile Rain Gauge Test Equipment is able to simulate rain in various intensities. The second generation of the Rain Gauge Test Equipment has a new and improved special pump inside. With almost no noise rain gauges can be tested easily in the field or in the lab.

Need help finding the right suppliers?

Let the XPRTs do the work for you