Calibration Systems Equipment in Mississippi

Serving Mississippi | Office in MississippiNear Mississippi
803 Results found
  • Category: Monitoring & Testing ×

  • Subcategory: Calibration Systems ×

  • Location: USA ×

  • Location: Mississippi ×

Dynacalibrator - Model 500 - Calibration Gas Generators

by VICI Metronics     based in Poulsbo, WASHINGTON (USA)

This innovative design features two separate permeation chambers with independent temperature control systems. The chambers can be used independently, or together to combine concentrations of trace components. Separate solenoid valves allow the carrier flows to be switched from the dilution flow to a vent port.

Model G-Calibrator - Calibration Gas Generators

by VICI Metronics     based in Poulsbo, WASHINGTON (USA)

G-Calibrators are rugged portable units specifically designed to be used with our patented Series 23 G-Cal permeation devices to generate known concentrations (ppb to ppm) of various gases and liquid vapors. This combination offers the easiest method of calibrating toxic gas detection equipment, gas analyzers, and chromatographs commonly used in ...

Dynacalibrator - Model 230 - Calibration Gas Generators

by VICI Metronics     based in Poulsbo, WASHINGTON (USA)

With a flexible flow metering system to maintain a constant carrier flow through the permeation chamber, the Model 230 allows the dilution flow to be varied over a wide range, generating the spectrum of concentrations required for checking analyzer linearity. Like all Dynacalibrators, its large permeation chamber is big enough to accomodate ...

Dynacalibrator - Model 340 - Calibration Gas Generators

by VICI Metronics     based in Poulsbo, WASHINGTON (USA)

The Model 340 adds a front panel mode control switch to select among zero, span, or remote calibration modes. In the zero mode, scrubbed air is delivered to the stream outlet. In the remote mode, the Model 340 can be externally programmed to deliver a zero and a span reference on command.

Dynacalibrator - Model 120 - Calibration Gas Generators

by VICI Metronics     based in Poulsbo, WASHINGTON (USA)

Standard features on Model 120 include a glass or PTFE permeation chamber with screw cap access, solid state proportional temperature controller with digital readout of set point and chamber temperature, heater switch with LED indicator, flowmeter and flow control valve, span and overflow outlets, 12 VDC internal pump, activated charcoal scrubber, ...

Model 306 Series - Ozone Calibration Source

by 2B Technologies     based in Boulder, COLORADO (USA)

The 2B Technologies Model 306 Ozone Calibration Source is a portable source of ozone that allows you to calibrate any ozone monitor - not just those manufactured by 2B Tech. The instrument scrubs ozone from ambient air and produces any mixing ratio of ozone in the range 30 to1,000 ppbv. The desired ozone concentration is chosen from the ...

Model 408 Series - Nitric Oxide Calibration Source

by 2B Technologies     based in Boulder, COLORADO (USA)

The Model 408 Nitric Oxide Calibration Source is a portable source of nitric oxide that allows one to calibrate any nitric oxide monitor.  The instrument scrubs NO from ambient air and produces either zero air or air having a mixing ratio of NO in the range 10-1,000 parts-per-billion by volume (ppbv).  The desired NO concentration is ...

Humidity Calibration

by ROTRONIC AG     based in Bassersdorf, SWITZERLAND

Calibration of humidity instrumentation is essential to maintain accurate and reliable measurements.  Unlike other measurement sensors for parameters such as temperature and pressure, humidity sensors must be in direct contact with the environment to be measured.  As such, humidity sensors are therefore more likely to have their performance ...

Dwyer Adjustable Flow Meter

by EMLab P&K     based in San Bruno, CALIFORNIA (USA)

This adjustable flow meter is standard on our high volume pumps. The flow meter features and adjustable knob to change pump flow rates. With a scale of 5-30LPM this flow meter is a perfect fit for the IAQ Professional.

Environics - Model Series 6100 - Computerized Multi-Gas Calibration System

by Environics, Inc.     based in Tolland, CONNECTICUT (USA)

The Environics Series 6100 Computerized Multi-Gas Calibration System is a computer controlled, state-of-the-art instrument for dynamic multi-point gas calibration of ambient air analyzers. The Series 6100 automatically performs zero, precision, span and multi-point calibrations using NO, NO2, SO2, CO, 03, hydrocarbons and other gases of interest. ...

Need help finding the right suppliers?

Let the XPRTs do the work for you