ambient air sampling Equipment in Iran

Serving Iran | Office in IranNear Iran
25 Results found
  • Category: Monitoring & Testing ×

  • Subcategory: Environmental Sampling ×

  • Keyword: ambient air sampling ×

  • Location: Asia & Middle East ×

  • Location: Iran ×

HORIBA - Model APHA-370 - Ambient THC Monitor / Ambient Air Monitor

by HORIBA Europe GmbH     based in Leichlingen, GERMANY

The APHA-370 continuously monitors atmospheric THC, NMHC, and CH4 concentrations using a cross-flow modulated selective combustion type method combined with a hydrogen ion detection method. The APHA-370 employs an independent, internal dry-method sampling device to achieve the highest levels of sensitivity and accuracy.

HORIBA - Model APNA-370 - Ambient NOx Monitor

by HORIBA Europe GmbH     based in Leichlingen, GERMANY

The APNA-370 continuously monitors atmospheric NOX, NO2, and NO concentrations using a cross-flow modulated semi decompression chemiluminescence method. The APNA-370 employs an independent, internal dry-method sampling device to achieve the highest levels of sensitivity and accuracy. The dry method, due to its minimal maintenance requirements and ...

Tekran - Model 1110 - Synchronized - Two Port Sampling System

by Tekran Instruments Corporation     based in Knoxville, TENNESSEE (USA)

The Tekran Model 1110 Synchronized Two Port Sampling System gives the Model 2537 Mercury Vapor Analyzer the ability to sample two unique sources. Switching between the two sources is synchronized with the instrument sampling cycle and is fully programmable by the user. This is particularly useful for flux chamber studies to measure inlet and ...

Tekran - Model 1115 - Synchronized Multi-Port Sampling System

by Tekran Instruments Corporation     based in Knoxville, TENNESSEE (USA)

The Tekran Model 1115 Synchronized Multi-Port Sampling System works in a similar fashion to the Model 1110, but the Model 1115 allows sampling of up to eight separate input sources. Switching between the sources is synchronized with the instrument sampling cycle. The number of sampling cycles in each position is programmable by the user. The Model ...

HI-Q - Model PM-10 Series - High Volume Air Sampling Systems

by HI-Q Environmental Products Company     based in San Diego, CALIFORNIA (USA)

The EPA Clean Air Act of 1987 established a measuring standard to evaluate and monitor the health effects of thoracic inhaleable particles. The standard was set that in order for an environment to be healthy, in terms of these particles, it must have a concentration of less than 150 mg/m3 of particles with aerodynamic diameters less than 10 ...

Radiello - Model RAD196 - Outdoor Shelter

by Sigma-Aldrich Co., LLC     based in Bellefonte, PENNSYLVANIA (USA)

A polypropylene protective outdoor shelter is available for housing up to four Radiello samplers during outdoor/ambient air sampling. The shelter allows for adequate ventilation while simultaneously protecting the samplers from harsh weather conditions. The shelter can be mounted to a variety of fixtures including lamp posts, traffic lights, and ...

Gasmet - Multipoint Sampling System (MSS)

by Gasmet Technologies Oy     based in Helsinki, FINLAND

The MSS is designed for continuous monitoring of multiple measuring points. It’s designed to work as an integral part of the FCX measuring system. The MSS is used for on-line measurements. It is an ideal tool to measure components of interest in ambient conditions from several measuring points. The sample pump, valves, filter and sample ...

MCZ - Calibration System for Sampling Probes and Sampling Piping

by Umwelttechnik MCZ GmbH     based in Bad Nauheim, GERMANY

Mobile calibration system as transfer standard to determine the correction values for losses along the sampling path. A gas bag is used to add the known span gas concentration at the sampling of the measuring station. The analysis system can be calibrated to compensate for the losses due to sampling.

Sabio - Model 1002/1004 - Heated Sample Manifolds

by Sabio Instruments, a division of Sutron Corporation     based in Georgetown, TEXAS (USA)

Collecting and distributing homogenous ambient air samples for gas analysis is easy with the Sabio Model 1002 and 1004 heated Sample Manifolds. Able to work equally well in dry or humid and salty environments, the manifold is well-suited for collecting reactive air toxic data.

Model AAC150-160 - Ambient Air Cooler

by AquaGas Pty Ltd     based in CURRUMBIN, AUSTRALIA

Ambient coolers are designed to be used in applications where the sample outlet dew point is not necessary to be stable at a specific temperature (. all Ankersmid electrical coolers are set to +4°C). By lowering the temperature of a sample gas, condensate liquid will be formed while passing through the heat exchanger. Condensed drops will be ...

Related Terms for ambient air sampling

Need help finding the right suppliers?

Let the XPRTs do the work for you