sampling chambers Equipment in Togo

Served | Office inNear
116 Results found
  • Category: Monitoring & Testing ×

  • Subcategory: Environmental Sampling ×

  • Keyword: sampling chambers ×

  • Location: Africa ×

  • Location: Togo ×

HI-Q - Model MK-30 - Sample Anaysis Monitoring Chamber

by HI-Q Environmental Products Company     based in San Diego, CALIFORNIA (USA)

The MK-30 Sample Analysis Monitoring Chamber is used with a PC computer to provide measurements of swipe (smear) samples, evaporation samples, and air filters. The MK-30 has a shielded chamber to reduce background and increase measurement sensitivity. Various detectors can be used, for specific applications such as beta,gamma, and alpha/beta ...

ChemScan - Sample Circulation Chamber (SCC)

by Applied Spectrometry Associates (ASA Analytics)     based in Waukesha, WISCONSIN (USA)

For coarse screening. Algae screening protects analyzer inlet screens and reduces maintenance. Typical applications include post secondary clarifier. TSS is less than 150 mg/L, NTU is less than 60. Run is greater than 20 ft. Lift is greater than 5 ft. Maximum of Eight Sample Lines. External Pump(s) Required - Provided by ASA or Others 3-10 GPM

Rakoraf - Model CEE - Truck Samplers

by Pfeuffer GmbH     based in Kitzingen, GERMANY

The Rakoraf CEE Core Sampler is the fastest and easiest method to take an accurate sample from an open trailer. The sample is taken while the trailer is still on the weighbridge. The telescopic arm with the core tube can be extended or retracted, be turned horizontally 0 to 350 degrees, and can also be raised or lowered vertically.When the core ...

Flow-Through Sample Chamber

by Teledyne Isco     based in Lincoln, NEBRASKA (USA)

The Isco flow-through chamber makes 'dipper' type samplers obsolete, and is ideal for large treatment plants with multiple sampling points spread over a large area. This patented device (Patent # 5,341,690) allows you to eliminate time-consuming trips to retrieve samples from remote monitoring points. By installing flow-through chambers on ...

Model MC100 - Microcell

by Strathkelvin Instruments Ltd.     based in Motherwell, UNITED KINGDOM

For PO2 measurement of blood or other fluids, or for microflowcell use. The all-glass sample chamber has a capacity of approximately 70µl. Samples are injected into the chamber via a 1 mm stainless steel tube fitted with a fine p.v.c needle-locating collar.

Photoreactor - Model LZC-4V - LZC4-14 lamp photoreactor

by Luzchem Research Inc.     based in Ottawa, ONTARIO (CANADA)

rsatile and cost effective. Six top and 8 side lamps, provided with 2 complete sets of lamps. 14 UVA (350 nm) and 14 UVC (254 nm) lamps, (28 lamps total) safe exhaust system, safety goggles, installed drive motor, carousel for liquid samples (“merry-go-round”), turntable for solid samples, recessed magnetic stirrer and UVA/VIS power meter. Now ...

Model TC500 - Tucker Cell

by Strathkelvin Instruments Ltd.     based in Motherwell, UNITED KINGDOM

The oxygen content of blood can be measured accurately and quickly by the method of Tucker (1967). A small sample of blood is introduced into the chamber containing a solution of ferricyanide. The resulting release of bound oxygen produces an increase in PO2 which is detected by the oxygen electrode. The oxygen content can be calculated from the ...

OdoFlux - Sampling Chamber For Odours & Volatile Chemicals

by Odotech Inc.     based in Montreal, QUEBEC (CANADA)

Sampling chamber for odors & volatile chemicals from surface sources.

Vertek ConeSipper - Simultaneous In-line Sampling Module

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

Simultaneous In-line Sampling -The Vertek ConeSipper module attaches directly behind a standard CPT cone to obtain gas or water samples as the CPT probe is advanced, saving substantial money and time by eliminating duplicate soundings. Developed and patented by Westinghouse Savannah River Corporation (WSRC) and Applied Research Associates, Inc., ...

Gasmet Portable Sampling System

by Gasmet Technologies Oy     based in Helsinki, FINLAND

Gasmet Technologies also manufactures sampling units and calibrators - all engineered to suit our gas analyzers perfectly. In addition to the sampling units and accessories mentioned here, we can also supply customer specific solutions.

Need help finding the right suppliers?

Let the XPRTs do the work for you