Environmental Standards Equipment in Djibouti

Served | Office inNear
712 Results found
  • Category: Monitoring & Testing ×

  • Subcategory: Environmental Standards ×

  • Location: Africa ×

  • Location: Djibouti ×

GasBadge Pro

by Industrial Scientific Corporation     based in Oakdale, PENNSYLVANIA (USA)

Built to Industrial Scientific’s highest quality and reliability standards, GasBadge Pro provides a lifetime of gas hazard protection with more features than any other single gas monitor available. Interchangeable “smart” sensors enable the GasBadge Pro to be quickly adapted to monitor unsafe levels of oxygen or any one of the ...

GA - Model Series 350-W - Air Cushioned Outside Lever & Weight Swing Check Valve

by GA Industries LLC     based in Cranberry Township, PENNSYLVANIA (USA)

The Figure 350 Air Cushioned Outside Lever & Weight Swing Check Valve is standard with ductile iron body and cover rated for 250 PSI (1,274 kPa) working pressure from 3” (DN80) to 30” (DN750) size, bronze body seat, stainless steel hinge shaft and rubber faced ductile iron disc for drop tight shutoff. A side-mounted totally ...

DeltaCal - Model DC1/DC100 - Calibrator for Federal Reference Method Samplers

by Keika Ventures, LLC (KV)     based in Chapel Hill, NORTH CAROLINA (USA)

BGI's DeltaCal is the first and only continuous volumetric flow calibration/audit device which gives a direct indication of volumetric flow rate, standard flow rate, barometric pressure (both mm/Hg & mb), ambient temperature and filter temperature in one instrument. It was developed for use with U.S. EPA PM2.5 designated samplers and their PM10 ...

Clinical

by LGC Standards     based in Teddington, UNITED KINGDOM

LGC Standards offer products specifically targeted towards clinical diagnostics including higher order certified reference materials, which combine the highest level of metrological traceability with the lowest attainable measurement uncertainty. Aimed at IVD manufacturers and reference laboratories, these materials facilitate compliance with the ...

BioPROtect - Air Containment Unit Accommodates High-Throughput Robotic Systems

by The Baker Company     based in Sanford, MAINE (USA)

This Class II style walk-in clean air and containment enclosure is designed for high-volume robotic and automated equipment applications. The popularity of robotically assisted technologies has resulted in the continuing development of the BioPROtect Series of walk-in and reach-in biological safety enclosures. Through the innovative use of robotic ...

5600 SERIIES Rechargeable Batteries

by High Sierra Electronics, Inc.     based in Grass Valley, CALIFORNIA (USA)

The 5600 Series of valve-regulated batteries set the standard for quality and excellence in rechargeable leadacid battery technology. These batteries feature a lead-lead dioxide system with a suspended dilute sulfuric acid electrolyte. Excessive pressurebuild up due to overcharging is avoided with special one-way valves that allow dry gas to ...

Dust / Dust Sampling System

by CleanAir Europe     based in La Penne-sur-Huveaune, FRANCE

This manual system can continuously sample dust from a gas duct under isokinetic conditions. This means that a representative sample of the flow in the chimney can be obtained at the sampling point. Particles are collected on heated filtration media.

Model CB_000648 - Indoor Air Standard, 50 Component

by Sigma-Aldrich/Supelco     based in Bellefonte, PENNSYLVANIA (USA)

100 μg/mL in methanol: water (19:1), analytical standard.

Model 49149-U - Indoor Air Standard, 50 Component

by Sigma-Aldrich/Supelco     based in Bellefonte, PENNSYLVANIA (USA)

High Concentration, 1000 μg/mL each component in methanol: water (97:3), analytical standard.

Model 48950-U - EPA 502 - Internal Standard Mix Analytical Standard

by Sigma-Aldrich/Supelco     based in Bellefonte, PENNSYLVANIA (USA)

EPA 502 Internal Standard Mix 2000 μg/mL each component in methanol, analytical standard.

Need help finding the right suppliers?

Let the XPRTs do the work for you