epa method 25a Equipment

65 Results found
  • Category: Monitoring & Testing ×

  • Subcategory: EPA Methods ×

  • Keyword: epa method 25a ×

XENOSEP SPE Systems for EPA Method 1664A

by Xenosep Technologies LLC

Extract Samples 5 Times Faster, Distill Samples 3 Times Faster, and Significantly Lower Cost Per Test... Step 1 Extract 1 L Sample17 seconds is all it takes to filter a 40 mg/L* OPR and achieve 98% recovery. That’s 50 times faster than a typical single layer SPE filter with 89% recovery. In addition, triple layer Xenosep SPE Filters have 5 ...

EPA Method 5 System - Determination of Particulate Emissions from Stationary Sources

by Keika Ventures, LLC (KV)

Persons using this method should have thorough knowledge of at least the following additional test methods: Method 1, Method 2, and Method 3. For those unfamiliar with these other methods, you might want to take a theoretical course offered through our training division, www.eduwhere.com, on Method 1 - 5.

Ozone Monitor - Model 202 Series - EPA Federal Equivalent Method (FEM)

by 2B Technologies

The 2B Technologies Model 202 Ozone Monitor is designed to enable accurate and precise measurements of ozone ranging from low ppb (precision of ~1 ppb) up to 100,000 ppb (0-100 ppm) based on the well established technique of absorption of UV light at 254 nm.

SPADNS 2 (Arsenic-free) Fluoride Reagent AccuVac Ampules, Pkg of 25

by Hach Company

Now you have the option of choosing a truly green chemistry, without sacrificing performance! Arsenic-free means no hazardous waste disposal requirements. EPA Compliant for use in Drinking Water and Wastewater reporting programs and equivalent to the EPA reference method SM 4500-F D. Identical performance to Hach SPADNS - use same Hach ...

Ozone Monitor - Model 205 Series - Dual Beam - EPA Federal Equivalent Method (FEM)

by 2B Technologies

The Model 205 Ozone Monitor makes use of two detection cells to improve precision, baseline stability and response time.  In the Dual Beam instrument, UV light intensity measurements Io (ozone-scrubbed air) and I (unscrubbed air) are made simultaneously. Combined with other improvements, this made it possible to reduce the time between ozone ...

DeltaCal - Model DC1/DC100 - Calibrator for Federal Reference Method Samplers

by Keika Ventures, LLC (KV)

BGI's DeltaCal is the first and only continuous volumetric flow calibration/audit device which gives a direct indication of volumetric flow rate, standard flow rate, barometric pressure (both mm/Hg & mb), ambient temperature and filter temperature in one instrument. It was developed for use with U.S. EPA PM2.5 designated samplers and their PM10 ...

The Gas Sniper - Portable Gas Detector - VOC Leak Detector (EPA Method 21)

by Chrysalis Scientific Technologies Inc.

The Gas Sniper features PPM , %LEL or %Volume measurement capability to address a wide range of monitoring requirements. The Gas Sniper detects and monitors a wide range of standard gases including many toxic gases (refer to Gas Sensor Selection Table). In addition, the Gas Sniper’s ability to simultaneously detect up to ‘6’ ...

Model Series 4000 - Computerized Gas Dilution System

by GOLDEN Specialty, Inc.

Dilution Systems from Environics, Functions: Precise generation of calibration gas standards; Methods:EPA Method 10, EPA Method 25A, EPA Method 3A, EPA Method 6C, EPA Method 7E.

frmOMNI - Ambient Air Sampler (Filter Reference Method)

by Keika Ventures, LLC (KV)

Saturation monitoring has generally been accomplished at low flow rates in order to keep the cost and weight of the equipment down. BGI has brought this approach to its ultimate development with the addition of a true 5 lpm inlet. The US Environmental Protection Agency (EPA) encourages state and local air monitoring groups to conduct short-term ...

Model MP101M (CPM option) - Ambient Suspended Particulates Analyzer

by Environnement S.A

The standard Beta gauge measurement Method ISO 10473 of the MP101M analyzer allows, whenused with the patented optical technology of the CPM module, the continuous and simultaneousmeasurement of fine dust.The instrument is compliant with the European Standards EN 12341 for PM10, EN 14907for PM2.5 and was approved as a designated Federal Equivalent ...

Related Terms for epa method 25a

Need help finding the right suppliers?

Let the XPRTs do the work for you