Level Monitoring Equipment in Ohio

Serving Ohio | Office in OhioNear Ohio
985 Results found
  • Category: Monitoring & Testing ×

  • Subcategory: Level Monitoring ×

  • Location: USA ×

  • Location: Ohio ×

Vibrating Level Switches

by Hycontrol Limited     based in Worcester, UNITED KINGDOM

Switches for Solids ApplicationsThe design of a vibrating level switch for solids must be fundamentally different to the design described for liquids. If two large parallel blades were used on powders or solids it would be too easy for product to build-up and become lodged between the blades causing the oscillations of the switch to stop ...

Conductivity Level Switch

by Hycontrol Limited     based in Worcester, UNITED KINGDOM

This unit is designed for simple pump control or alarm indication. The electrodes are mounted on the tank top via their holders (EA18) and St/St rod is fitted to suit the required switch points. The electronic level controls together with resistive probes are suitable for the control and monitoring of the levels of conductive liquids. The ...

Acu-Trac - Model NEMA4 - Ultrasonic Liquid Level Sensors

by SSI Technologies Inc. - Controls Division     based in Janesville, WISCONSIN (USA)

Acu-Trac® NEMA4 Ultrasonic Liquid Level Sensors are non-contact sensors that are a direct replacement for level senders on tanks with depths up ≤ 1.5 meters (59 inches). The NEMA4 ultrasonic liquid level sensors offer a choice of outputs (analog current loop, ratiometric voltage or non-ratiometric voltage). The NEMA's RS-485 bus ...

Model i-Log-GW - GPRS Water Level Datalogger

by GeoPrecision GmbH     based in Ettlingen, GERMANY

The i-Log-GW is designed for the reliable monitoring and storage of water level and temperature for the water management. The ground water level datalogger permit therefor a worldwide online data access via internet. No use of special equipment or software is herfore required.

PumpPro - Model 6150 - Advanced Liquid Level Sensor

by Environmental Systems & Services     based in Richmond, AUSTRALIA

The pumppro 6150 combines an integrated air compressor module and levelpro 6100 advanced liquid level sensor to form a fully self contained hydrostatic pressure sensor designed to measure water and liquid levels reliably and accurately. Featuring a Teflon lubricated precision piston air compressor, the 6150 contains all other components required ...

Sensaphone - Model 2800 - Wireless Monitoring System

by Sensaphone, Inc.     based in Aston, PENNSYLVANIA (USA)

Now you can monitor critical conditions at remote locations without running wires. Introducing the new Sensaphone 2800 with Wireless Sensor Technology.Based on proven Sensaphone remote monitoring methods, the 2800 adds the ability to read sensor status from wireless sensors. And not just simple on/off status, or open/closed conditions. The ...

Optomax LLC - Liquid Level Sensors

by SST Sensing Ltd     based in Coatbridge, UNITED KINGDOM

The Optomax LLC Digital Range is a comprehensive range of fully protected, cost effective, solid state digital fluid level sensors with a variety of housings, termination and electrical outputs. Now available in high temperature -40 to +125DegC. SST has introduced some new features to this range such as high temperature reduced power consumption ...

Heron - Model dipper-T - Water Level Meter

by HERON Instruments Inc.     based in Dundas, ONTARIO (CANADA)

Heron's top selling water level meter, #1 for accuracy, reliability and value. The dipper-T water level meter has been designed to provide a long and reliable service life; we back up our claims with a 5-year warranty. Accuracy begins with a top quality, heavy duty tape. Each tape is tested by the manufacturer to ensure compliance with appropriate ...

Heron - Model Little Dipper - Water Level Meter

by HERON Instruments Inc.     based in Dundas, ONTARIO (CANADA)

A small, low-cost water level meter with all the quality features of the larger units. The fully submersible standard 5/8 inch (16 mm) diameter probe makes it an ideal instrument for narrow piezometers, direct push equipment and standpipes. The compact size and light weight of the little dipper is an advantage for carry in sites where portability ...

Model LMK 358 H - Ceramic Sensor

by BD SENSORS GmbH     based in Thierstein, GERMANY

The separable stainless steel probe LMK 358H has been designed for level measurement in waste water, waste and higher viscosity media. Basic element is a capacitive ceramic sensor. In order to facilitate stock-keeping and maintenance the transmitter head is plugged to the cable assembly with a connector and can be changed easily.

Need help finding the right suppliers?

Let the XPRTs do the work for you