ASTM D516 - 11 standard test method for sulfate ion in water

0.511.522.533.544.55 (0 votes)

The determination of sulfate is important because it has been reported that when this ion is present in excess of about 250 mg/L in drinking water, it causes a cathartic action (especially in children) in the presence of sodium and magnesium, and gives a bad taste to the water.

1. Scope

1.1 This turbidimetric test method covers the determination of sulfate in water in the range from 5 to 40 mg/L of sulfate ion (SO4−−).

1.2 This test method was used successfully with drinking, ground, and surface waters. It is the user's responsibility to ensure the validity of this test method for waters of untested matrices.

1.3 Former gravimetric and volumetric test methods have been discontinued. Refer to Appendix X1 for historical information.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
D1066 Practice for Sampling Steam
D1129 Terminology Relating to Water
D1192 Guide for Equipment for Sampling Water and Steam in Closed Conduits
D1193 Specification for Reagent Water
D2777 Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
D3370 Practices for Sampling Water from Closed Conduits
D5847 Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis
E60 Practice for Analysis of Metals, Ores, and Related Materials by Molecular Absorption Spectrometry
E275 Practice for Describing and Measuring Performance of Ultraviolet and Visible Spectrophotometers

Index Terms

drinking water; ground water; sulfate; surface water; turbidimetric: Inorganic compounds--water; Sulfate content--water;

ICS Code

ICS Number Code 13.060.50 (Examination of water for chemical substances)

DOI: 10.1520/D0516-11

ASTM International is a member of CrossRef.

MOST POPULAR RELATED SEARCHES

Post a New Comment

0 Comments

No comments were found for ASTM D516 - 11 standard test method for sulfate ion in water. Be the first to comment!

Environmental XPRT is part of XPRT Media All Rights Reserved
Subscribe