air sampling Equipment in Portugal

1688 Results found
  • Keyword: air sampling ×

  • Location: Europe ×

  • Location: Portugal ×

HI-Q - Air Sampling & Equipment Tripods

by HI-Q Environmental Products Company

HI-Q's TR-1, TR-1000B, & TR-2000A are Light, Medium, & Heavy Duty Air Sampling & Equipment Tripods capable of extended sampling heights over 58 inches. For lightweight instrumentation, 12 pounds or less, HI-Q recommends the TR-1. For tripod applications which must be capable of supporting up to a 15 pound workload capacity, HI-Q offers ...

Crowcon - Air Aspirator Sampling Systems

by Crowcon Detection Instruments Ltd

Designed for use in Zone 1 or Zone 2 hazardous areas, the air aspirated system uses a compressed air driven vacuum generator to draw a gas sample from a single point. Explosion- proof gas detectors are fitted to monitor for flammable gases, toxic gases or oxygen. Each detector provides a 4-20mA output. An intrinsically safe flow-fail device warns ...

HI-Q - Sample & Return Exhaust Lines

by HI-Q Environmental Products Company

Many air sampling procedures call for remote site sampling where the vacuum source (air sampling pump) cannot be conveniently located in the same area where sampling is required. This may be due to a variety of reasons including explosive sampling environments, inaccessibility, and noise level restrictions. For this reason, HI-Q has developed two ...

HI-Q - Model PM-10 - Sampling Inlet

by HI-Q Environmental Products Company

HI-Q Environmental Products Company's High Volume PM-10 Size Selective Inlet samples suspended particulate in the air at a flow rate of 40 CFM through its omnidirectional head. The air is then accelerated through multiple internal nozzles toward a greased collection plate. Due to their larger momentum, particles greater than 10 microns cannot ...

HI-Q - Model PM-10 Series - High Volume Air Sampling Systems

by HI-Q Environmental Products Company

The EPA Clean Air Act of 1987 established a measuring standard to evaluate and monitor the health effects of thoracic inhaleable particles. The standard was set that in order for an environment to be healthy, in terms of these particles, it must have a concentration of less than 150 mg/m3 of particles with aerodynamic diameters less than 10 ...

HI-Q - Sample Saver Covers For Filter Holders

by HI-Q Environmental Products Company

Anti-Static plastic cover for HI-Q combination cartridge & filter paper holders. Ideal for transporting filter holders to and from the field & laboratory without cross-contamination or particle loss. Fits all HI-Q open faced, combination type, filter holders.

Air-O-Cell - Sampling Cassette

by Zefon International, Inc.

The Air-O-Cell is a unique air sampling cassette specifically designed for the rapid collection of a wide range of airborne aerosols including mold spores, pollen, insect parts, skin cell fragments, fibers (e.g. asbestos, fiberglass, cellulose, clothing fibers, etc.) and inorganic particulate e.g. ceramic, fly ash, copy toner, etc.). The ...

Tekran - Model 1110 - Synchronized - Two Port Sampling System

by Tekran Instruments Corporation

The Tekran Model 1110 Synchronized Two Port Sampling System gives the Model 2537 Mercury Vapor Analyzer the ability to sample from two separate input sources. Switching between the two sources is synchronized with the instrument sampling cycle. The number of sampling cycles in each position is user programmable.

Buck LinEair - Model 40 LPM, 230 VAC - Air Sampling Pump

by A. P. Buck Inc.

The BUCK LinEair 40 Sample Pump is a 5 - 35 LPM linear piston air sampling pump with long life motor providing impressive power, compact size and ultra quiet operation and low current drain for a wide range of sampling applications. With the BUCK LinEair 40, you can use filters, PUF samplers, sorbent tubes, charcoal cartridges, cascade impactors, ...

Sensidyne - Model Gilian BDX-II - Economical Air Sampling Pump

by TnA Safety

The Gilian BDX-II is an economical air sampling pump designed specifically for abatement and lead applications. It is a compact and rugged air sampling pump optimized for sample methods between 500 cc/min and 3000 cc/min. The BDX-II is powered by a rechargeable NiCd battery that provides up to 10 hours of operation on a single charge. Rugged and ...

Need help finding the right suppliers?

Let the XPRTs do the work for you