Topics

Sections

DNAPLs Equipment in Utah

44 Results found
Order by:
Recommended | 
Alphabetical

2” DNAPL Recovery Pump

by Xitech Instruments, Inc.

This 2” Smart Pump was designed to recover low viscosity DNAPLs like TCE. The 2” Smart Pump is completely resistant to all solvents, easily fits into a 2” schedule 40 well or larger, has a pumping rate up to 12 GPH, operating well depth of 200 feet, and requires no above ground controls to operate. Maximum air requirements are .5 CFM @ 125 PSIG, ...

4” DNAPL Recovery Pump

by Xitech Instruments, Inc.

This 4” Smart Pump was designed to recover high viscosity DNAPLs like Coal-Tar. The 4” Smart Pump is completely resistant to all solvents, easily fits into any 4” well or larger, has a pumping rate up to 60 GPH, operating well depth of 200 feet, and requires no above ground controls to operate. The maximum air requirements are .5 CFM @ 125 PSIG, ...

Emulsified Zero-Valent Iron (EZVI) - In-Situ DNAPL Remediation

by TEA, Inc.

EZVI is an emulsion of powdered zero-valent iron, surfactant, oil, and water that reductively dehalogenates halogenated hydrocarbons (e.g. PCE, TCE, CFC, VC). Because EZVI uses an emulsion to deliver reactive iron, it has the ability to mix with DNAPLs present in the subsurface environment. Thus, EZVI is a 'source area remediation' technology.

EZVI - Emulsified Zero Valent Iron In-Situ DNAPL Remediation

by RemQuest

EZVI is an emulsion of zero-valent iron, surfactant, oil, and water that reductively dehalogenates halogenated hydrocarbons (e.g. PCE, TCE, CFC, VC). Because EZVI uses an emulsion to deliver reactive iron, it has the ability to mix with DNAPLs present in the subsurface. Thus EZVI is a “source area' remediation technology.

Xitech - 4 - DNAPL / Total Fluids Pump

by Geotechnical Services, Inc

Xitech Total Fluids pumps are designed for DNAPL recovery. Using a compressor or bottled air these pumps efficiently bring your sinking product up to your collection tank. Controllers and solar systems are available for remote locations and automatic shutoff for full tanks. If you have a well with sinking product, this is the recovery pump for ...

Olio-D-Sep™ - Oil/Water Separators for LNAPL & DNAPL

by Environmental Remediation Equipment Inc. (ERE)

The ER-DN-SS Coalescing Oil/Water/DNAPL Separator will remove DNAPL contaminant and all non-emulsified oil from waste water that has a minimum of suspended solids.

Hydrasep - RCT DNAPL Model Separators

by Hydrasep, Inc.

RCT DNAPL models are specifically designed for the treatment of process water or groundwater where the oils and other contaminants are heavier than water or for the removal of water & solids upon vegetable or petroleum based oils.

GCW-DNAPL

by IEG Technologie GmbH

With a GCW it is possible to remove non-miscible liquids of higher density than water (DNAPL) from an aquifer. In order to remove dense non aqueous phase liquids (DNAPL) that have accumulated on the bottom of the aquifer, the GCW is operated in standard mode. The DNAPL is removed by means of a sensor-controlled, pneumatically-driven ...

Emulsified Zero-Valent Iron (EZVI)

by Carus Corporation

EZVI is a surfactant-stabilized, biodegradable emulsion that forms emulsion droplets consisting of an oil-liquid membrane surrounding zero-valent iron (ZVI) particles in water. EZVI capitalizes on the ability of food-grade surfactant, biodegradable vegetable oil, water, and zero-valent Iron to form hydrophobic emulsion droplets (micelles) that ...

Spill Buddy - Compact Skimming System

by Clean Earth Technology, Inc.

The Spill Buddy is a compact, manual, free product skimming system, designed to operate on site to skim quantities of product (LNAPL or DNAPL). The Spill Buddy’s operation is based on the state-of-the-art ALPHA-ARRAY™ sensors in the probe that detect the interface between the product and the water. An audible feedback signals the user ...


Air & ClimateEnergy & RenewablesEnvironmental ManagementHealth & SafetyMonitoring & TestingSoil & GroundwaterWaste & RecyclingWater & Wastewater