mercury vapor Equipment in Kentucky

Served | Office inNear
322 Results found
  • Keyword: mercury vapor ×

  • Location: USA ×

  • Location: Kentucky ×

Mercury - Model VM-3000 - Vapor Detector

by Mercury Instruments USA     based in Littleton, COLORADO (USA)

The VM-3000 Mercury Vapor Monitor measures the elemental mercury vapor concentration in air and other gases continuously. It is used in the laboratory or can be installed at places where mercury has to be monitored. Industry people use the VM 3000 Mercury Sniffer as well as university researchers or safety people. It is a great tool for plenty of ...

Mercury - Model 3000 IP - Portable Mercury Vapor Monitor

by Mercury Instruments USA     based in Littleton, COLORADO (USA)

Direct reading mercury sniffer. Lightweight, with ergonomic shoulder strap and dismountable probe. Integrated battery for 6 hours operation. Shock proof and corrosion resistant. 3 mercury measuring ranges .1-100 / 0-1000 / 0-2000 µg/m³. 0-10; 0-100; 0-200 ppb. High resolution 0.0001 mg. Data logger integrated. No need for constant ...

Tekran - Model 2537Xi - Mercury Vapor Analyzer

by Tekran Instruments Corporation     based in Knoxville, TENNESSEE (USA)

The Tekran Model 2537Xi mercury vapor analyzer is built specifically for measurement of stack gases and other elevated-Hg source gases. The 2537Xi is the cornerstone of the Tekran Series 3300Xi Mercury CEMs which has been installed at over 200 sites in the U.S. The 2537Xi has proven accurate, stable, and reliable under the most remote and rugged ...

Ohio Lumex - Method 30B Vapor-Spiked Sorbent Traps for Total Mercury Testing

by Ohio Lumex Co., Inc.     based in Twinsburg, OHIO (USA)

Method 30B Sorbent Traps at a variety of spike levels are available for evaluations and RATA. These 10mm extra durable 2-section sorbent traps are typically used from a few hours to one day sampling and can be used when pulling up to 2 liters per minute flow. Custom spiking at any value you need is available.

Mercury Analysis - Hydra AA

by Teledyne Leeman Labs     based in Hudson, NEW HAMPSHIRE (USA)

The need to measure mercury levels in a wide variety of samples has become increasingly important. The most commonly used technique for mercury analysis is cold vapor atomic absorption spectrometry (CVAAS).Hydra AA is a fully automated mercury analyzer that achieves a 1-2 ppt detection limit while employing EPA compliant cold vapor atomic ...

Hydra AF

by Teledyne Leeman Labs     based in Hudson, NEW HAMPSHIRE (USA)

The Hydra AF is a fully automated, cold vapor atomic fluorescence analyzer designed to fit your analytical needs and budget. The Hydra AF has been developed to meet all performance and QC requirements of EPA method 245.7. Analytically, this system is capable of detection limits of less than 0.2 ppt and a dynamic range that extends to nearly 100 ...

Mercury Sorbent Traps

by Apex Instruments, Inc.     based in Fuquay-Varina, NORTH CAROLINA (USA)

PS 12B specifies sampling, and analytical, and quality-assurance criteria and procedures for the performance-based monitoring of vapor-phase mercury (Hg) emissions in combustion flue gas streams, using a sorbent trap monitoring system. The principle employed is continuous sampling using in-stack sorbent media coupled with analysis of the ...

MercSampler - Model XC-6000EPC-W - Automated Sorbent Trap Monitoring System

by Apex Instruments, Inc.     based in Fuquay-Varina, NORTH CAROLINA (USA)

The automated XC-6000 EPC MercSampler for Sorbent Trap Monitoring Systems is designed for continuous dual sampling of vapor-phase mercury emissions from stationary combustion sources, in accordance with the U.S. EPA MATS published in 40 CFR, Part 60-63, Appendix A, Subpart UUUUU and is MATS compliant. Performance Specification 12B: Specifications ...

MERX - Model EPA 1631 - Automated Total Mercury Configuration System

by Brooks Rand Labs, LLC     based in Seattle, WASHINGTON (USA)

At Brooks Rand, we firmly believe that obtaining the highest quality data is essential, but also recognize the necessity of operational efficiency. Our decades of trace level mercury analysis experience have enabled us to develop a system that achieves both of these critical goals.

Model VM-3000 Series - Mercury Vapor Monitor

by Mercury Instruments GmbH, Analytical Technologies     based in Karlsfeld, GERMANY

The VM-3000 Mercury Vapor Monitor measures the mercury concentration in gases continuously. It is used in the laboratory or can be installed at places where mercury has to be monitored. Industry people use the VM-3000 as well as university researchers or safety people. It is a great tool for plenty of different applications: work place monitoring, ...

Need help finding the right suppliers?

Let the XPRTs do the work for you