Geophysics Equipment in Malawi

Serving Malawi | Near Malawi
214 Results found
  • Category: Soil & Groundwater ×

  • Subcategory: Geophysics ×

  • Location: Africa ×

  • Location: Malawi ×

Model GGT-3 - Geophysical Transmitter

by Zonge International     based in Tucson, ARIZONA (USA)

Constant current supply.Used for time / frequency domain IP, Resistivity, CR, TEM, CSAMT.Broad-band: DC to 8 kHz (standard).Output up to 1000 V, 15 A.Fast turn-off time: 125 £gsec (300 x 300m loop).Drives a loop or grounded dipole.Sealed construction for operation in wet environments.Compact modular design.Optional internal time base

AGCOS - Model GTS-1 - Multifunction Transmitter for Geophysical EM surveys

by Advanced Geophysical Operations and Services Inc. (AGCOS)     based in North York, ONTARIO (CANADA)

Transmitter GTS-1 is intended for work from an alternating current single-phase network with the voltage 220 V and frequency 50 Hz on loading with the resistance 10 - 1000 ohm.

Bartington - Model Grad-01-1000L - Vertical Component Magnetic Gradiometer

by Geomorph Instruments     based in Piraeus, GREECE

The Grad-01-1000L is a vertical component magnetic gradiometer for archaeological and geophysical surveys and UXO detection. It is designed for use alone or as one element in a gradiometer array for rapid data collection over large areas. An open interface is provided to allow settings to be adjusted by the user. Resolution which is mostly limited ...

Electric Conductivity Sensor (ECPT)

by Geotech AB     based in Askim, SWEDEN

With the ECPT sensor you measure the conductivity of the soil while performing standard CPTU test. Test results can be used for analysing salinity and detection of pollutants. The electric conductivity sensor is mounted on Geotechs 10 cm2 CPTU probes. The adapter consists of an array of four ring electrodes (Wenner configuration, i.e. with equal ...

Vertek ConeSipper - Simultaneous In-line Sampling Module

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

Simultaneous In-line Sampling -The Vertek ConeSipper module attaches directly behind a standard CPT cone to obtain gas or water samples as the CPT probe is advanced, saving substantial money and time by eliminating duplicate soundings. Developed and patented by Westinghouse Savannah River Corporation (WSRC) and Applied Research Associates, Inc., ...

Vertek - Speed Lock Rods

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

Unsurpassed Strength - Vertek manufactures a full line of CPT push rods with our proprietary Speed Lock dual-lead thread design. Speed Lock Rods provide unsurpassed joint strength- up to 50% stronger than industry standard Vthreads. Our unique rope thread design uses less of the available wall thickness and balances the strength between the male ...

Vertek - Grouting Tools and Cone

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

To meet the growing needs of various contractors and state and federal agencies Vcrtck offers our self grouting tools which allow grouting of CPT holes while removing the rods. Vertek offers two types of grouting tools to fit your needs.

Vertek - Modular Soil Sampler

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

Vertek’s patented Soil Sampler is built for reliable, cost-effective retrieval of soil samples in difficult geologies and is designed to be deployed by most common CPT equipment.

Seismic CPT (SCPT)

by Geotech AB     based in Askim, SWEDEN

Seismic test are carried out to measure shear (S wave) and compression wave (P wave) velocities in soils. The SCPT method combines the seismic test with results from the CPTU probe, and will give you a good basis for evaluation of a number of critical soil properties, e.g. the risk for liquefaction. The wave is normally generated at the ground ...

AGCOS - Model GEPARD-4A - 4-Channel Multifunction Geophysical EM Receiver

by Advanced Geophysical Operations and Services Inc. (AGCOS)     based in North York, ONTARIO (CANADA)

GEPARD-4A geophysical EM receiver is based on the world’s latest computer, electronics and communication technologies, and is used for accurate and sensitive registration of electric and magnetic fields at wide frequency range. This system is multifunctional and can be effectively used for many electromagnetic geophysical methods, such as ...

Need help finding the right suppliers?

Let the XPRTs do the work for you