Geophysics Equipment in Netherlands Antilles

Served | Office inNear
186 Results found
  • Category: Soil & Groundwater ×

  • Subcategory: Geophysics ×

  • Location: Latin America ×

  • Location: Netherlands Antilles ×

Model GGT-10 - Geophysical Transmitter

by Zonge International     based in Tucson, ARIZONA (USA)

Broadband, constant-current, time and frequency domain, medium-power geophysical transmitter.

Model GGT-3 - Geophysical Transmitter

by Zonge International     based in Tucson, ARIZONA (USA)

Constant current supply.Used for time / frequency domain IP, Resistivity, CR, TEM, CSAMT.Broad-band: DC to 8 kHz (standard).Output up to 1000 V, 15 A.Fast turn-off time: 125 £gsec (300 x 300m loop).Drives a loop or grounded dipole.Sealed construction for operation in wet environments.Compact modular design.Optional internal time base

Geonics - Model EM34-3 - Electromagnetic Land Geophysical Equipment

by Geomatrix Earth Science Ltd     based in Leighton Buzzard, UNITED KINGDOM

The EM34-3 is a fast, simple to operate, cost-effective instrument for the engineering geophysicist, geologist and hydro geologist alike and has been particularly successful for mapping deeper groundwater contaminant plumes and for groundwater exploration.

Geonics - Model G-TEM - Modular TDEM System

by Geomatrix Earth Science Ltd     based in Leighton Buzzard, UNITED KINGDOM

The Geonics G-TEM is a modular TDEM system offering advanced quality control and analysis features to assist operators obtain reliable near surface resistivity soundings. Through incorporating a Laptop PC into the receiver the G-TEM enables the operator to integrate GPS positioning to aid layout and accurately record each sounding location. In ...

AGCOS - Model GTS-1 - Multifunction Transmitter for Geophysical EM surveys

by Advanced Geophysical Operations and Services Inc. (AGCOS)     based in North York, ONTARIO (CANADA)

Transmitter GTS-1 is intended for work from an alternating current single-phase network with the voltage 220 V and frequency 50 Hz on loading with the resistance 10 - 1000 ohm.

AGCOS - Model MARY-24 - Multifunction Low-Frequency Geophysical EM Receiver

by Advanced Geophysical Operations and Services Inc. (AGCOS)     based in North York, ONTARIO (CANADA)

Measuring instrument MARY (Multifunctional receiver for electrical and electromagnetic prospecting) represents the newest development in the field of creation of the portable geophysical equipment. Compactness and simplicity of use of the device are combined with opportunities which until recently were inherent in only large-sized ...

SonaVision Mercury - Scanning Sonar System

by Seafloor Systems, Inc.     based in El Dorado Hills, CALIFORNIA (USA)

Mercury is a high resolution, miniature sonar and is designed for use on the smallest of ROV's, without compromising accuracy. It is available either as a compact, all in one unit or as a split head with remote electronics. Manufactured as standard in a pressure housing for use up to 300m water depths, there are options for operation at 1000m, ...

AMS - Dynamic Cone Penetrometer

by Art’s Manufacturing and Supply, Inc. (AMS Inc.)     based in American Falls, IDAHO (USA)

The most widely accepted, portable method for evaluating strength and density of soil, in situ. The dynamic cone penetrometer uses a 15 lb. (6.8 kg) drive mass falling 20 in. (50.8 cm) that strikes the anvil to cause penetration of 1.5 in (3.8 cm) diameter cone (45 degree vertex angle) that has been seated in the bottom of a pre-augered hole. The ...

Iris Instruments - Model Promis - Multi Frequency EM System

by Geomatrix Earth Science Ltd     based in Leighton Buzzard, UNITED KINGDOM

The Promis is a modern implementation of the Slingram technique which uses a coil to produce a primary magnetic field, this is linked by a cable to a receiver sensor at distances between 20 and 200m. The receiver coil measures 3 in-phase components and one out of phase component of the secondary magnetic field induced by ground conductors. ...

Vertek - Grouting Tools and Cone

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

To meet the growing needs of various contractors and state and federal agencies Vcrtck offers our self grouting tools which allow grouting of CPT holes while removing the rods. Vertek offers two types of grouting tools to fit your needs.

Need help finding the right suppliers?

Let the XPRTs do the work for you