Geophysics Equipment in South Carolina

Serving South Carolina | Near South Carolina
265 Results found
  • Category: Soil & Groundwater ×

  • Subcategory: Geophysics ×

  • Location: USA ×

  • Location: South Carolina ×

Model GGT-3 - Geophysical Transmitter

by Zonge International     based in Tucson, ARIZONA (USA)

Constant current supply.Used for time / frequency domain IP, Resistivity, CR, TEM, CSAMT.Broad-band: DC to 8 kHz (standard).Output up to 1000 V, 15 A.Fast turn-off time: 125 £gsec (300 x 300m loop).Drives a loop or grounded dipole.Sealed construction for operation in wet environments.Compact modular design.Optional internal time base

Dynamic Cone Penetrometer (DCP)

by Durham Geo Enterprises     based in Stone Mountain, GEORGIA (US) (USA)

The original Dynamic Cone Penetrometer (DCP) was developed in 1959 by the late Professor George F. Sowers. The DCP uses a 15 lb (6.8 kg) steel mass falling 20 in (50.8 cm) that strikes the anvil to cause penetration of a 1.5 in (3.8 cm) diameter cone (45° vertex angle) that has been seated in the bottom of a hand augered hole. The blows ...

IMPAC - Integrated Multi-Parameter Airborne Console

by Pico Envirotec Inc.     based in Concord, ONTARIO (CANADA)

Integrated Multi-Parameter Airborne Console IMPAC is a NEW real-time data acquisition and navigation system designed for airborne geophysical exploration and environmental science applications. IMPAC combines the field proven technology found in Pico Envirotec's AGIS-XP and MMS-4 instruments into a single rack-mountable enclosure. IMPAC follows ...

AGCOS - Model GTS-1 - Multifunction Transmitter for Geophysical EM surveys

by Advanced Geophysical Operations and Services Inc. (AGCOS)     based in North York, ONTARIO (CANADA)

Transmitter GTS-1 is intended for work from an alternating current single-phase network with the voltage 220 V and frequency 50 Hz on loading with the resistance 10 - 1000 ohm.

ConeTec - CPT Trucks

by ConeTec     based in Richmond, BRITISH COLUMBIA (CANADA)

Features; 25-35 ton Thrust Capacity. 4 Point Leveling Jacks. On Board Decon Facilities. Stainless Steel Laboratory Interiors. Onboard Air & 110v Electricity. Rear View Cameras. CPT Monitoring Camera. Seismic Beams for Vs Measurements. Positive Air-Shutoff.

Geonics - Model G-TEM - Modular TDEM System

by Geomatrix Earth Science Ltd     based in Leighton Buzzard, UNITED KINGDOM

The Geonics G-TEM is a modular TDEM system offering advanced quality control and analysis features to assist operators obtain reliable near surface resistivity soundings. Through incorporating a Laptop PC into the receiver the G-TEM enables the operator to integrate GPS positioning to aid layout and accurately record each sounding location. In ...

Iris Instruments - Model Promis - Multi Frequency EM System

by Geomatrix Earth Science Ltd     based in Leighton Buzzard, UNITED KINGDOM

The Promis is a modern implementation of the Slingram technique which uses a coil to produce a primary magnetic field, this is linked by a cable to a receiver sensor at distances between 20 and 200m. The receiver coil measures 3 in-phase components and one out of phase component of the secondary magnetic field induced by ground conductors. ...

Vertek - Grouting Tools and Cone

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

To meet the growing needs of various contractors and state and federal agencies Vcrtck offers our self grouting tools which allow grouting of CPT holes while removing the rods. Vertek offers two types of grouting tools to fit your needs.

Model PEG-40 - Propelled Energy Generator

by Environmental Equipment & Supply     based in Harrisburg, PENNSYLVANIA (USA)

The PEG-40, Propelled Energy Generators are streamlined and highly portable seismic energy sources specifically designed for a multitude of applications within the fields of geology, geophysics, civil engineering, and more. PEG systems propel the hammer to a high velocity by utilizing simple and effective elastomer band technology. Comprised of ...

Vertek - Speed Lock Rods

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

Unsurpassed Strength - Vertek manufactures a full line of CPT push rods with our proprietary Speed Lock dual-lead thread design. Speed Lock Rods provide unsurpassed joint strength- up to 50% stronger than industry standard Vthreads. Our unique rope thread design uses less of the available wall thickness and balances the strength between the male ...

Need help finding the right suppliers?

Let the XPRTs do the work for you