cone penetration Equipment

9 Results found
  • Category: Soil & Groundwater ×

  • Subcategory: Soil Monitoring ×

  • Keyword: cone penetration ×

Cone Penetration Test (CPT)

by Zebra Environmental Corporation     based in Lynbrook, NEW YORK (USA)

The cone penetration test (CPT) is an in situ testing method used to determine the geotechnical engineering properties of soils and delineating soil stratigraphy. The test method consists of pushing an instrumented cone tip first into the ground at a controlled rate (usually 2 centimeters/second). The resolution of the CPT in delineating ...

Cone Penetration Testing Equipment

by Gregg Drilling & Testing, Inc. and Gregg In Situ, Inc.     based in Signal Hill, CALIFORNIA (USA)

Gregg Drilling & Testing, Inc. (Gregg) offers a wide range of geotechnical and environmental cone penetration testing (CPT) and geophysical testing equipment. Cone penetration testing is a process whereby soil characteristics are determined when a cone penetrometer is driven into the subsurface. The CPT provides a rapid, reliable and ...

Vertek - Model VTK 10cm2 - Digital Cone

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

Rugged and Reliable Vertek’s Digital Cones provide simple, easy-to-use CPT measurements in a compact system. Since analog-to-digital conversion is preformed downhole, the bulkiness of cabling and uphole electronics are reduced, and noise problems associated with cable length and low voltage signals of analog systems are eliminated. ...

Dynamic Cone Penetrometer (DCP)

by Durham Geo Enterprises     based in Stone Mountain, GEORGIA (US) (USA)

The original Dynamic Cone Penetrometer (DCP) was developed in 1959 by the late Professor George F. Sowers. The DCP uses a 15 lb (6.8 kg) steel mass falling 20 in (50.8 cm) that strikes the anvil to cause penetration of a 1.5 in (3.8 cm) diameter cone (45° vertex angle) that has been seated in the bottom of a hand augered hole. The blows ...

Penetrograph for Field Measurement Equipment

by Eijkelkamp Agrisearch Equipment     based in Giesbeek, NETHERLANDS

The penetrograph is a devise for determination of the penetration resistance of the ground. The standard set is equipped with various penetration cones, recorder pens, probe rods and recording charts. The entire set, including spare parts, instructions, cone check and the tool are packed in an aluminium carrying/transport case. Every penetrograph ...

Eijkelkamp - Pocket Penetrometer

by Eijkelkamp Agrisearch Equipment     based in Giesbeek, NETHERLANDS

The 'pocket penetrometer' is specifically used to determine the penetration resistance of top layers (measuring depth 5 mm) and of samples in the field or in the laboratory. Measuring range 0.5 MPa.

Penetrologger with GPS and Soil Moisture Sensor

by Eijkelkamp Agrisearch Equipment     based in Giesbeek, NETHERLANDS

The resistance to penetration is a means of determining the ground load-bearing capacity, and the ease with which roots will grow through the ground (important when agricultural, rural- and civil engineering techniques are involved). The resistance to penetration is a mechanical characteristic that, given a certain texture, depends on changing ...

Vertek - Model LVUV Series - Lights and Fuel Fluorescence Detection (FFD)

by Vertek Cone Penetration Test Equipment     based in Randolph, VERMONT (USA)

Vertek's LVUV Series lights are the highest power UV lights on the market. They have the longest battery and lamp life and the kit contains everything you need to start working right away.

Peat Sampler

by Eijkelkamp Agrisearch Equipment     based in Giesbeek, NETHERLANDS

The stainless steel peat sampler is in fact a kind of gouge auger. The peat sampler is pushed into the soil manually. The sample containing part is a half cylinder. The peat sampler distinguishes itself from the standard gouge auger as its cone is massive. 1The sample containing section is sealed off by a plate (fin) that can pivot around the axle ...

Need help finding the right suppliers?

Let the XPRTs do the work for you