Waste to Energy Equipment in Iceland

Serving Iceland | Office in IcelandNear Iceland
677 Results found
  • Category: Waste & Recycling ×

  • Subcategory: Waste to Energy ×

  • Location: Europe ×

  • Location: Iceland ×

Model WT2 - Wood Waste Heater Unit

by Wood Waste Technology Ltd     based in Stafford, UNITED KINGDOM

The WT2 is the entry level unit and a very popular choice for the smaller workshop. The small footprint, ease of installation and being virtually maintenance free make it the obvious choice for workshops up to around 2500ft². Manufactured using the same high quality materials as the larger WT range of heaters means the customer gets ...

Model WT10 - Wood Waste Heater Unit

by Wood Waste Technology Ltd     based in Stafford, UNITED KINGDOM

The WT10 is the middle unit of the double pass heat exchange models and will produce 300,000btu/hr of warm air, enough to heat a workshop of up to 7500ft². Once again the WT10 is fully compliant with the clean air act without an oil or gas afterburner. As with all the WT range these units are the most robust, heavy duty heaters available in ...

Talbott - Model T500 - Wood Burning Heater Reconditioned

by Wood Waste Technology Ltd     based in Stafford, UNITED KINGDOM

Talbott T500 (500,000btu/hr) wood burning heater reconditioned.Wood waste heater with new heat exchange, Re-lined firebox, Re-insulated cabinet, Re-wired. 3 month warranty.

Cogeneration

by Montealto     based in Córdoba, SPAIN

Cogeneration technology generates both electricity and usable heat. It is useful in industrial facilities where vapour and/or hot water are needed and, in general, in any facility that uses heat or cold, or in facilities where waste heat can be recovered to generate electricity. In Spain, cogeneration technology, like other renewable energies, ...

CTP - Multi Fuel Burners

by Chemisch Thermische Prozesstechnik GmbH / CTP Air Pollution Control     based in Graz, AUSTRIA

Multi Fuel Burner: Multi fuel burners can be employed in a wide range of applications for gaseous and fluid combustibles, or liquid waste with a high combustion heat level.

Exergy - Flue Gas Dryer

by Swedish Exergy AB     based in Gothenburg, SWEDEN

The Exergy Flue Gas Dryer was developed to meet the needs of the industry for the utilisation of latent heat in flue gases from boilers. The dryer consists of feeding and discharge equipment, a separation cyclone and specially designed drying conduits. The bio-mass is fed in hot flues gas stream and gets in direct contact with flues gases. The ...

VMpress - Kaiserslautern Plant

by VMpress s.r.l.     based in Ovada, ITALY

The plant in Kaiserslautern is fed with appr. 40,000 t/a of municipal solid waste, but it has been conceived for the treatment of up to 100,000 t in the event that the waste supply area should be extended.Municipal waste is unloaded in the reception area and directly fed into the hopper of extruder press by means of a grab bucket.The extruder ...

Model WT5 - Wood Waste Heater Unit

by Wood Waste Technology Ltd     based in Stafford, UNITED KINGDOM

The WT5 is the smallest of the double pass heat exchange models and is a fully exempt appliance to burn chipboard, MDF, hardwood and softwood off-cuts without the need of a costly afterburner, even in city centres and built up residential areas. With a full refractory lined firebox and highly efficient double pass heat exchange with fully welded ...

Model WT15 - Wood Waste Heater Unit

by Wood Waste Technology Ltd     based in Stafford, UNITED KINGDOM

The WT15 is the largest of the hand fired units and is still the most popular heater in the wood working industry since its launch. The reason for its popularity is, as with the other WT heaters, the robust design, low servicing costs and high heat output Once again the WT10 is fully compliant with the clean air act without an oil or gas ...

Model 2248 - Vertical Compactors

by Compactors Incorporated     based in Hilton Head Island, SOUTH CAROLINA (USA)

The Model 2248 Vertical Compactor compacts directly into 64 gallon wheeled cart. It reduces cost through waste reduction and recycling. Safe and easy to operate. No lifting or double handling. Space saving and energy efficient. Achieves as much as 6:1 compaction. Patently safe and simple to operate. Can be mobile. Minimum space requirements.

Need help finding the right suppliers?

Let the XPRTs do the work for you