membrane separation Equipment in Finland

Served | Office inNear
150 Results found
  • Category: Water & Wastewater ×

  • Subcategory: Membrane Filtration ×

  • Keyword: membrane separation ×

  • Location: Europe ×

  • Location: Finland ×

ENVOPUR - Model EDI - Electrochemical Deionisation

by EnviroChemie GmbH Technology for Water     based in Rossdorf, GERMANY

Electro-deionization (EDI) is based on the engineering principle of electrodialysis. It is an electrochemical separation process in which ions from a low concentration solution pass through a special membrane to a solution of higher concentration. The activating force is an electric field between cathode and anode.

CPA: High Salt Rejection

by AUXICOLOR, S.A.     based in TERRASSA (BCN), SPAIN

HYDRANAUTICS, the global leader in membrane innovations, uses cutting edge technology to improve and protect the quality of life around the word. Since 1963, Hydranautics has been committed to the highest standards of technology research, product excellence and customer fulfillment. Hydranautics entered the reverse osmosis water treatment ...

ProMinent - Nanofiltration Systems

by ProMinent Group - ProMinent GmbH     based in Heidelberg, GERMANY

Nanofiltration is based on the same principle as reverse osmosis. The difference: the separation line is slightly lower. Ions solved into the water are less filtered than with reverse osmosis. This saves operation costs. Typical salt rejection rates are at ca. 80 – 85%. Here, polyvalent ions (e.g. Ca, Mg) are kept back better than univalent ...

Convergence Inspector - Model MBR - Membrane Bio Reactor

by Convergence Beheer B.V.     based in Enschede, NETHERLANDS

The Convergence Inspector Membrane Bio Reactor is based on the conventional wastewater process. The separation of micro-organism is performed by filtration by membranes. The Membrane Bio Reactor system is user-specific for a variety of characterization processes/experiments. All the Convergence Inspectors are fully customized. Almost every type of ...

Membrane Filter Plates Standard Welded

by Klinkau GmbH + Co     based in Marktoberdorf, GERMANY

Klinkau Membrane Filter Plates Standard welded aree primarily used for applications with homogeneous chamber fillings and standard process parameters. This design requires a minimum cake thickness after squeeze of 1/3 of the initial cake thickness. The innovative combination of membrane filter plate and chamber filter plate (mixed pack) reduces ...

Membrane Filter Plates Empty Chamber Welded

by Klinkau GmbH + Co     based in Marktoberdorf, GERMANY

Klinkau welded membrane filter plates Empty Chamberwelded design is the type of membrane plate for more difficult applications and allows squeezing into an empty or underfilled chamber without damages to the membrane. This Empty Chamber system is especially suited for filtration processes with uncontrollable chamber fillings and variable batch ...

DryDisk - Solid Phase Extraction (SPE) Disks & Barrels for Separation Membrane

by Horizon Technology, Inc.     based in Salem, NEW HAMPSHIRE (USA)

DryDisk Separation Membranes offer a much more efficient means of drying solvents in organic extractions than sodium sulfate. Because it is a physical separation rather than a chemical process to remove residual water from organic solvent extracts, DryDisk Separation Membranes eliminate the problems inherent with chemical drying such as retention ...

CO2 Separation Unit

by SEE ALGAE Technology GmbH (SAT)     based in Vienna, AUSTRIA

Engineering is based on market available technology.Significant reduction in gas volume required, as raw stack-gas contains only approximately 5-15% CO2.CO2 is separated from stack-gas via a membrane system with very low energy consumption.CO2 content after separation is approximately 80%.CO2 is stored in a buffer tank providing a steady and ...

Membrane Technology

by KÜHNI AG     based in Allschwil 2, SWITZERLAND

Kühni has increased its activities in the field of thermal separation technology by the addition of membrane processes such as pervaporation / vapour permeation, membrane-based extraction / absorption and the pressure driven processes reverse osmosis, nano- and ultrafiltration.

Membrane Filters

by BOKELA Ingenieurgesellschaft für Mechanische Verfahrenstechnik mbH     based in Karlsruhe, GERMANY

The dynamic membrane filtration with the DYNO Filter is a very versatile and high-performing cross flow process for micro-, ultra- or diafiltration of micro- to nano-sized particles in slurry. Tasks like, separation of solids, concentration or, washing. of highly concentrated slurries are performed by the DYNO Filter with high throughput capacity ...

Related Terms for membrane separation

Need help finding the right suppliers?

Let the XPRTs do the work for you