Topics

Sections

vacuum sewer Equipment in Cyprus

10 Results found
Order by:
Recommended | 
Alphabetical

RoeVac - Vacuum Sewer Systems

by Roediger Vacuum GmbH

High groundwater table, low population density, flat terrain (lack of natural slope); unfavourable soil conditions like sandy, unstable or rocky ground are the ideal circumstances to use RoeVac® vacuum sewer systems. In areas along rivers, lakes or coasts as well as in water protection zones, vacuum sewer systems are often the only choice. ...

SIVAC - Vacuum Sewer Systems

by Sekisui SPR

The vacuum sewer system consists of a vacuum station, valve chamber package and vacuum pipeline. The specific name of the system differs according to the manufacturer of the vacuum valves adopted in the system. Unlike gravity flow systems in general, the main sewer pipeline in the vacuum sewer system are maintained in vacuum condition at all times ...

SEWAIR-MAXI - Air and Vacuum Sewer Valve

by Flomatic Corporation

Cast iron body-stainless steel trim. Threaded female x female connections. NITRILE (Buna-N) seat. Large orifice equals inlet size. Eliminates vacuum in waste water pipeline.Temp Max: 150° F (65 C)Inlet Pressure Max: 300 PSI.

Valve Chambers

by Iseki Vacuum Systems

Sewage flows from the building through normal gravity pipes into the lower section, or wet sump, of the interface valve chamber. As the level of the effluent within the wet sump rises the pressure inside the sensor pipe increases.  This is transferred through the flexible tubing to the top section of the Redivac interface valve, known as the ...

Vacuum Station

by Iseki Vacuum Systems

The vacuum station houses the vacuum pumps, collection vessel, sewage discharge pumps and the system control panel. The sewage travels through the vacuum sewer until it reaches the vacuum station where it is held in the collection vessel which acts as a temporary reservoir. The sewage level rises within this vessel to a pre determined level at ...

RoeVac - Vacuum Station

by Roediger Vacuum GmbH

All vacuum sewer lines are connected to the vacuum collection vessel installed at the central vacuum station, where vacuum pumps create the required negative pressure (approx. –0.6 bar). The vacuum vessel can be placed inside or buried outside the vacuum station. Discharge pumps transport the wastewater from the vessel to the wastewater ...

RoeVac - Collection Chambers

by Roediger Vacuum GmbH

The water tight RoeVac collection chamber is manufactured in MDPE with three different designs available for the following loading conditions: pedestrian load, flood-proof and pedestrian load, flood-proof and traffic load up to 40 t. In all designs the vacuum valve unit is kept separate from the wastewater sump ensuring the RoeVac vacuum valve ...

Vacuum Sewerage System

by Flovac

Differential air pressure is the driving force in Flovac vacuum sewer systems. The vacuum sewer lines are under a vacuum of -50kPa to -70kPa created by the vacuum pumps located at the vacuum pump station. The pressure differential between the atmospheric pressure and the vacuum in the sewer lines of 50kPa - 70kPa provides the energy required to ...

The Collection Chamber

by Flovac

The Collection Chamber connects the homes to the vacuum sewer system. Wastewater flows by gravity from four to six homes into a collection chamber. Located above the sump is a 90mm (3')  vacuum interface valve which is pneumatically controlled and operated. As the sewage level rises in the sump, air trapped in the 50 mm diameter sensor pipe ...

Vacuum Pump Station

by Flovac

The vacuum station essentially sucks the sewage and air to a central point and then pumps the sewage to its intended location. The vacuum station has duty and standby vacuum pumps that create a vacuum in the vacuum sewer lines and an enclosed collection tank. When the vacuum mains deliver sewage and air to the pump station, Sewage pumps transfer ...


Air & ClimateEnergy & RenewablesEnvironmental ManagementHealth & SafetyMonitoring & TestingSoil & GroundwaterWaste & RecyclingWater & Wastewater