sludge discharge Equipment in Estonia

Served | Office inNear
142 Results found
  • Category: Water & Wastewater ×

  • Subcategory: Sludge Management ×

  • Keyword: sludge discharge ×

  • Location: Europe ×

  • Location: Estonia ×


Partial Sludge Drying

by ANDRITZ Separation - a division of the Andritz Group     based in Waddinxveen, NETHERLANDS

Many wastewater treatment plants are coping with a waste stream of digested sludge. The sludge is normally dewatered by means of a centrifuge or belt filter press. After dewatering the sludge has a typical dry solids content of approx. 20 - 25%, which is very suitable for thermal treatment in a ANDRITZ paddle dryer.

ASTIM - Chamber Filter Press

by ASTIM Manufacturing Inc.     based in Tavsanli Köyü, TURKEY

Pressure filtration is a very cost effective way of producing sludge cakes with high DS concentrations, along with an extremely high degree of clarity in the filtrate. Because of the simplicity and flexibility, the chamber filter press is the most used and reliable machine for solid / liquid separation and sludge dewatering plants. ASTiM chamber ...

SRS Crisafulli - Integrated Floating Discharge Line

by SRS Crisafulli, Inc.     based in Glendive, MONTANA (USA)

To carry the dredged sludge from the FLUMP or Rotomite to the designated disposal site, typically on land, the FLUMP uses a Crisafulli Integral Floating Discharge Line (CIFDL). The Discharge Line is modular, offered in either 15 foot or 20 foot rigid lengths, and 5 foot flexible lengths, and is one of three styles – i.e., (1) aluminum pipe ...

AutoBATCH - Combined Wastewater Treatment and Sludge Dewatering System

by Ovivo (Formerly Eimco Water Technologies)     based in Salt Lake City, UTAH (USA)

The AutoBATCH system is a complete treatment plant package, combining wastewater treatment and sludge dewatering in one operator-friendly unit. The AutoBATCH system creates value by its simplicity and the fact that it uses only one specially blended powdered chemical. The chemically treated wastewater produced is separated from the solids by ...

Amston Filter Press For Dewatering Sludge

by Ovivo (Formerly Eimco Water Technologies)     based in Salt Lake City, UTAH (USA)

The Amston filter press is a recessed plate pressure filter used for dewatering sludge. A low dose of polymer is often required to assist dewatering. The Amston filter presses require a lower polymer input than belt presses due to their use of higher pressures and finer cloths.

FlooBelt - Belt Filter Press For Water And Wastewater Sludges

by Ovivo (Formerly Eimco Water Technologies)     based in Salt Lake City, UTAH (USA)

Ovivo’s FlooBelt belt filter press is technology used for the dewatering of all kinds of water and wastewater sludges. The FlooBelt belt filter press is proven technology with extensive number of deliveries.

Enviroquip - Belt Filter Press & Gravity Belt Thickener

by Ovivo (Formerly Eimco Water Technologies)     based in Salt Lake City, UTAH (USA)

The Ovivo family of Belt Filter Press and Gravity Belt Thickener dewatering products demonstrates a superior level of consistency in design, geometry, and configuration. Our equipment provides exceptional dewatering performance, mechanical reliability, long-life durability, and user friendly features.

Strainpress - Model SP - Sludge Cleaner

by Huber Technology Inc.     based in Huntersville, NORTH CAROLINA (USA)

The STRAINPRESS is a horizontal pipe-shaped coarse material separator which consists of inlet and driving zone, screening and press zone and finally a discharge section with a conical pressure regulating device. The coarse material is separated continuously under pressure and periodical cleaning of the screening zone by backwashing is not ...

Vibrating Fluidised Bed Dryers

by Euroby Limited     based in Worthing, UNITED KINGDOM

Euroby's Vibrating Fluidised Bed Dryers are used world-wide by the plastics, chemicals, food and fodder and minerals and soils industries. The dryers are designed and manufactured in Austria by Binder + Co and benefit from the following features: economically efficient, dried products are of uniform quality and size, high availability, units ...

ROTAMAT - Model RoS 3 - Sludge Dewatering Screw Press

by Huber Technology UK     based in Chippenham, UNITED KINGDOM

The Screw Press consists in a cylindrical wedge wire basket. A preceding flocculation reactor ensures a sludge flock quality that allows dewatering of the sludge flocks and stabilises the flocculated sludge. The free water drains through the basket whilst the solids inside the basket are conveyed gently upwards through the inclined basket by a ...

Need help finding the right suppliers?

Let the XPRTs do the work for you