Water Aeration Equipment in Ireland

Serving Ireland | Office in IrelandNear Ireland
853 Results found
  • Category: Water & Wastewater ×

  • Subcategory: Water Aeration ×

  • Location: Europe ×

  • Location: Ireland ×

Venturi AirJet Aeration

by Landia     based in Lem, DENMARK

Landia’s extensive range of submersible mixers and mixer/aerators add supplementary possibilities to optimize aeration efficiency and oxygen transfer. Sufficient mixing is achieved, solids remain suspended and thoroughly mixed with oxygen enriched effluent, thus enhancing aerobic digestion and improving process efficiency and final effluent ...

Aerator Performance Testing

by Air Products PLC     based in Walton-on-Thames, UNITED KINGDOM

The performance of aeration equipment is critical to the successful operation of an activated sludge process. Often, in building a new plant, the performance of such equipment must be tested against the manufacturers specification in terms of power used for the quantity of oxygen transferred to the water.

ENVICON - Membrane Disc Diffuser

by Envicon Klärtechnik GmbH & Co. KG     based in Dinslaken, GERMANY

Depending on their characteristics, disc diffusers are either surface diffusers or plate diffusers.

Aerator

by Hubert Stavoren B.V.     based in STAVOREN, NETHERLANDS

Vertical shaft low speed Hubair aerator. The Hubair aerator consists of a flat saw tooth shaped plate to which twelve blades are fitted. The top of each blade has been reversed and bends outwards at an upward angle of 35 degree. This influences the direction of water ejection.

SCM Tecnologie - Model AGV Series - Surface Aerators

by SCM Tecnologie     based in San Giorgio, ITALY

The high-speed floating aerators are designed for lagooning, variable level tanks, water storage basins and and for mixing tanks in general.The water pumping action results in the transfer of the oxygen obtained from the water chipping.The units may be easily added or relocated to other uses as changing customer requirements may require.The system ...

Model MXN - Recirculation Pumps

by SCM Tecnologie     based in San Giorgio, ITALY

The MXN series recirculation pumps are based on the same principle of the MX-gi/ii series. The recirculation pumps are used to transfer large volumes of water from adjoining tanks in presence of average (not high) head values.

Aeration - Coarse Bubble Diffusers

by Environmental Remediation Equipment Inc. (ERE)     based in St. Leonard, QUEBEC (CANADA)

The Coarse bubble diffusers produce 1/4 to 1/2 inch bubbles which rise rapidly from the floor of a wastewater treatment plant or sewage treatment plant tank. They are typically used in air stripper chamber, grit chambers, equalization basins, chlorine contact tanks, and aerobic digesters, and sometimes also in aeration tanks. Coarse bubble ...

AIRE-02 Polaris - Aerator

by Aeration Industries International (AII)     based in Chaska, MINNESOTA (USA)

The Stainless Steel Buster! You asked for it and Aeration Industries has delivered. To combat the unpredictable and rising stainless steel prices, the AIRE-O2 Polaris® Aerator is made of a hightly engineered composite material. The Polaris offers the same essential design features and advantages as the original AIRE-02® aspirator model.

Submersible Mixer

by Pro-Equipment, Inc.     based in Waukesha, WISCONSIN (USA)

PRO-MIX submersible mixers are used for mixing of various liquids including sludge homogenization and suspension of bottom sediments. They prevent sediments and/or floating layers and create flow velocity to transport liquids.

Disc Aerator

by IFO Vattenrening, AB     based in Bromma, SWEDEN

The rubber membrane in IFO´s aerators is fitted with a large number of very small slits. Under working pressure, the rubber membrane expands thereby opening the slits and allowing the air quantity necessary for effective oxygenation to pass through. The smaller the holes the smaller the air bubbles and the better the oxygenationcapacity. ...

Need help finding the right suppliers?

Let the XPRTs do the work for you