Water & Wastewater Pumps Equipment in Nevada

Served | Office inNear
3654 Results found
  • Category: Water & Wastewater ×

  • Subcategory: Water & Wastewater Pumps ×

  • Location: USA ×

  • Location: Nevada ×

Model 57000 Series - Bladder Pumps

by GeoPump, Inc.     based in Medina, NEW YORK (USA)

GeoPump dedicated bladder pumps meet rigid U.S. EPA requirements for ground water monitoring, while offering the highest flow rates of any bladder pump of equivalent size. This enhanced performance results from an offset center tube and check valves which produce a straight water path. The larger bore and unrestricted flow path combine to produce ...

Gear pumps

by Imo Pump     based in Monroe, NORTH CAROLINA (USA)

CIG (Crescent Internal Gear) pumps are produced primarily for fluid power applications and aircraft fuel test stands. They are available in multiple stages for very high pressure or moderate pressure on very low viscosity fuels. Pumps are also available in double pump configurations which share a common inlet port but deliver two independent flows ...

Model 5600 Series - Bladder Pumps

by GeoPump, Inc.     based in Medina, NEW YORK (USA)

Available in a wide range of sizes and capacities to meet virtually any pumping situation, GeoPump 5600 Series Bladder Pumps meet all EPA requirements for representative ground water monitoring in both portable and dedicated situations.

Model LPH - Liquid Ring Vacuum Pumps

by SIHI Pumps Americas liquid & Vacuum Pumps     based in Grand Island, NEW YORK (USA)

The SIHI 'LPH' series liquid ring vacuum pumps are reliable pumps that can be used in a variety of applications. The vacuum pumps have one moving part, the impeller and shaft assembly, and no internal metal to metal contact. The 'LPH' series are available in a single stage (low to medium vacuum) and two stage (medium to high vacuum) configurations ...

Viscotherm - Pump Units

by Viscotherm AG     based in Hinteregg-Zürich, SWITZERLAND

VISCOTHERM designs and builds pump units to match the required Rotodiff. The pump units are driven by an electric motor, which in turn drives the hydraulic pump.

Immersible Pump

by Hidrostal Holding AG     based in Neunkirch, SWITZERLAND

Our immersible type has independent cooling that enables the motor to run either in a wet well or dry well. Hidrostal do not use product for cooling so our motors do not suffer from overheating problems that can occur when product is circulated around the motor,( a method commonly used by other manufacturers).

Model Series A - Muncher

by NOV Mono - Mono Pumps Ltd     based in Audenshaw, UNITED KINGDOM

The reliable Series 'A' Muncher is well proven in its ability to effectively macerate raw sewage, sludges, sewage screenings and industrial process flows. Available for pipeline or channel installations, the shaft speed of 85 rpm offers low cutter tip speeds and therefore dramatically reduces wear rates in comparison to high speed macerators. The ...

2X-A Two Stage Rotary Vane Vacuum Pumps

by Great Wall Industry Holding Limited     based in Wenling, CHINA

2X Series rotary vane vacuum pump. its structure is equipped to use eccentric rotor and the stator chamber pot sliding in the rotor by spring tension and separatist wall close to the two stator vane. stator will be divided into two working chamber, rotary vane while expanding capacity to gas inhalation, while another volume continued to narrow. ...

xd Single Stage Direct Drive Rotary Vane Vacuum Pumps

by Great Wall Industry Holding Limited     based in Wenling, CHINA

XD series as a single-stage rotary vane vacuum pump mechanical structure simple, easy, convenient maintenance access to a wide range of vacuum in the use of capital equipment. It pumps the same volume of work and the general principles, Shaft is a concerted installed in the pump body in a position eccentric rotor component, Journal of the three ...

Gear Pump

by Colfax Corporation     based in Richmond, VIRGINIA (USA)

Gear pumps, such as the Crescent Internal Gear (CIG) Pump by Imo, are fixed-displacement pumps used mainly in hydraulic power applications as well as other more specialized applications like aircraft fuel test stands. Gear pumps can be engineered with multiple stages for very high pressure or moderate pressure on very low viscosity fuels.

Need help finding the right suppliers?

Let the XPRTs do the work for you