Aerosols Applications available in Kyrgyzstan
-
Premium
Particle Measurement Instruments for Occupational Health and Industrial Hygiene
Dekati measurement solutions for occupational health and industrial hygiene include both portable and stationary PM measurement systems as well as solutions for overall industrial hygiene measurements according to ISO16000-34 and ISO16000-37. Our aerosol measurement solutions have been successfully used in various health and safety monitoring and research areas for over 25 years and today, our instruments are used globally by thousands of customers both in research and industry to measure different properties of ...
By Dekati Ltd. based in Kangasala, FINLAND.
-
Premium
Particle Measurement Instruments for Engine Emissions
Engine emission measurements are typically made in very different environments and conditions depending on the purpose of the measurement. Standardized and regulated particle emission measurements are made in test cell environments, PTI stations and on board a moving vehicles according the details described in the regulations and standards. For various research purposes, engine emissions can be measured in different conditions and even pre-DPF conditions. The requirements for the measurement instrument in these ...
By Dekati Ltd. based in Kangasala, FINLAND.
-
Premium
Environmental Pollution Monitoring and Control Systems for Weather & Climate
Measures the boundary layer wind field in real-time all-weather. Widely used for meteorological climate research, short-term weather forecast and model optimization, aerosol parameter inversion, low-level wind shear ...
By Qingdao Leice Transient Technology Co., Ltd. based in Qingdao, CHINA.
-
Premium
Coriolis Air Sampler for Research and Development
Coriolis air sampler collects biological particles in the air for fundamental research on biological airborne ...
By Bertin Technologies based in Montigny-le-Bretonneux, FRANCE.
-
Premium
Environmental Pollution Monitoring and Control Systems
Provides analysis of atmospheric mass flux, regional pollutant transport and diffusion, as well as research of aerosol distribution and transport flux in complex environment, to solve the air quality problems of cities and ...
By Qingdao Leice Transient Technology Co., Ltd. based in Qingdao, CHINA.
-
Premium
Monitors, gas analyzers solutions for semiconductor / microelectronics sector
Particle Measuring Systems (PMS) has the application expertise and particle monitoring instruments with the industry leading sensitivity you need to reduce yield loss. Particle Measuring Systems PMS can provide you with particle monitoring solutions to determine how clean your semiconductor or microelectronics manufacturing is. By continuously counting particles when and where products (water, chemicals, air) are at risk, we provide the global expertise and high-performance laser particle counters you count ...
By Particle Measuring Systems (PMS) based in Boulder, COLORADO (USA).
-
Premium
Particle Measurement Instruments for Air Quality Monitoring
Every day, unhealthy air quality affects lives of millions of people all over the world. Numerous studies have shown correlation between particle concentration and adverse health effects especially for sensitive groups of people. Whereas regulated fine particle concentration values in air often focus only on PM10 and PM2.5, a more detailed determination of particle characteristics if often needed to fully understand the link between PM and their effect on human health. To determine the source of the particles in ...
By Dekati Ltd. based in Kangasala, FINLAND.
-
Premium
Channel networks solutions for replacement of measurement with inverted syphon sector
Rectangular concrete channel, approx. 2.5 x 2.5 m (w x h). Part filled. Impoundage shield installed later in the channel with inverted syphon and EMF DN ...
By NIVUS GmbH based in Eppingen, GERMANY.
-
Premium
Cleanroom Solutions from Concept Smoke Systems
The correct functioning of HEPA filters is normally tested at the time of installation, as well as part of the routine maintenance programme. It is normally recommended that HEPA filters are checked at 14 month intervals or less, or immediately after filter changing. Where high efficiency filters are fitted, it is vital that the filter housing/sealing device does not allow particulate material to pass and thereby compromise the cleanroom environment that is being served. Testing is necessary since HEPA filters can ...
By Concept Smoke Systems | Concept Engineering Ltd. based in Maidenhead, UNITED KINGDOM.
-
Premium
Environmental data monitoring solutions for Research
Aerosol research is the study of the physical characteristics and behavior of an aerosol in a gas flow. ...
By Ecomesure based in Saclay, FRANCE.
-
Premium
Smoke generator device for clean room solutions
The correct functioning of HEPA filters is normally tested at the time of installation, as well as part of the routine maintenance programme. It is normally recommended that HEPA filters are checked at 14 month intervals or less, or immediately after filter changing. Where high efficiency filters are fitted, it is vital that the filter housing/sealing device does not allow particulate material to pass and thereby compromise the clean room environment that is being served. Testing is necessary since HEPA filters ...
By Concept Smoke Systems | Concept Engineering Ltd. based in Maidenhead, UNITED KINGDOM.
-
Applications and Air Pollutants Removed in the Textile Industry
Remove oil mists and blue haze from tenter frame ...
By Bionomic Industries Inc based in Mahwah, NEW JERSEY (USA).
-
Air Pollution Control System for Technology Sector Manufacturing
ERG provides a wide variety of air pollution control systems for microelectronic, speciality gases and optical fibres manufacturing plants. ERG’s purpose-designed gas cleaning systems are engineered to suit each application and supplied with a process ...
By ERG (Air Pollution Control) Ltd based in Horsham, UNITED KINGDOM.
-
Laser based remote sensing instruments for remote visibility / fog applications
Aerosol LIDARs can provide visibility measurement, including Slant Visual Range (SVR - visibility up the glide slope), Runway Visual Range (RVR), and Vertical Optical Range (VOR - visibility at the decision point). LIDARs offer remote detection, augmenting current sensors wherever visibility is an issue, including for airports, ports, and oil platforms. Using the same principle, they are also capable of detecting incoming ...
By Raymetrics S.A. based in Athens, GREECE.
-
Drinking water testing
Water is essential for life. It is part of the environment, being used in industrial processes and available as tap water. To secure the safety of water that is daily available, the amount of necessary microbiology tests to comply with regulatory requirements are increasing and are heavily relying on quick and accurate answers to confirm the identities of a broad selection of important ...
By Bruker Corporation based in Billerica, MASSACHUSETTS (USA).
-
PTR-TOFMS systems for Flux Measurement of BVOCs
The ultra-fast analysis capabilities of IONICON PTR-TOF instruments are essential for eddy covariance flux measurements, allowing to study deposition and emission rates of biogenic volatile organic compounds (BVOCs). ...
By Ionicon Analytik Ges.m.b.H. based in Innsbruck, AUSTRIA.
-
Aerosol and particle technology for environment industries
Fine dust is generated by industrial exhaust gases but in particular due to traffic. Environmental pollution is therefore caused particularly by exhaust gases of diesel-engined vehicles (diesel soot) but on the other hand also by abrasion of street, tyres and brakes and its ...
By Palas GmbH based in Karlsruhe, GERMANY.
-
High performance filtration & separation system for amine
There are a number of factors that affect the capacity and operation of a typical amine system. Solid or liquid contaminants in the system may cause foaming. The presence of foaming is typically addressed by the addition of expensive antifoam chemicals and/or by reducing the operating capacity of the amine system. In addition to this, the presence of contaminants in the system can foul heat exchangers and column packing or trays. These solid and liquid contaminants are either ingressed into the system with the ...
By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).
-
High performance separation system for glycol dehydration
Glycol dehydration is a liquid desiccant system for the removal of water from natural gas and natural gas liquids (NGL). It is the most common and economic means of water removal from these streams.Glycols typically seen in industry include triethylene glycol (TEG), diethylene glycol (DEG), ethylene glycol (MEG), and tetraethylene glycol (TREG). TEG is the most commonly used glycol in ...
By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).
-
High performance separation system for alkylation unit
The key aspects of an alkylation unit pertain to the amount of acid that needs to be made-up on a continuing ...
By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you