calibration system Equipment in United Kingdom

72 Results found

Current filtering criteria

You can remove a filter by clicking on the x
  • Category: Air & Climate ×

  • Subcategory: Air Monitoring ×

  • Keyword: calibration system ×

  • In: Europe ×

  • In: United Kingdom ×

Environics - Model Series 6100, 6103 & 9100 - Ambient Air Calibration Systems

by Air Monitors Ltd.     based in Severn Drive, Tewkesbury, UNITED KINGDOM

Environics Ambient Monitor Calibrators with Ozone Generators facilitate dynamic calibration of ambient air analyzers. These instruments automatically perform zero, precision, span and multi-point calibrations using NO, NO2, SO2, CO, O3, hydrocarbons and other gases of interest. All ozone generators are factory calibrated using a NIST traceable ...

AutoRAE - Portable Calibration Systems for Gas Detectors

by Air Monitors Ltd.     based in Severn Drive, Tewkesbury, UNITED KINGDOM

AutoRAE is an auto-calibration, bump test and charging system for RAE Systems gas monitors. AutoRAE cradles are available for the QRAE, QRAE Plus, MultiRAE Plus, EntryRAE and MiniRAE 2000.

MKS Instruments - Model PVS6E - Portable Vacuum Calibration System

by MKS Instruments, Inc.     Office in Crewe, UNITED KINGDOM

The PVS6E consists of up to three MKS Baratron® Type 690 High Accuracy Absolute capacitance manometers as transfer standards and a high vacuum pumping system, mounted in a sturdy transportable cart. The PVS6E provides NIST traceable calibrations over the pressure range from 10-5 to 1000 mmHg and can be used to calibrate capacitance manometers, ...

Model MG101 - Panametrics Hygrometer Calibration System

by Alba Instrumentation Ltd.     based in Warwickshire, UNITED KINGDOM

The MG101 hygrometer calibration system is used to generate precise, repeatable levels of water vapor in a carrier gas stream. This primary dew/frost point generation system achieves an accuracy of ±1.8°F (±1°C) within a continuously adjustable range. The MG101 employs the elementary principle of gas dilution. Dry gas is ...

Model MCS200 - Modular Test And Calibration System

by Beamex Oy Ab     Office in NEWTOWN UNTHANK, UNITED KINGDOM

The MCS200 is a modular test and calibration system for workshops and laboratories. MCS200 offers efficient and ergonomic facilities for the maintenance of process instruments.

Norsonic - Model Nor1504A - Calibration System

by Norsonic AS     Distributor in UNITED KINGDOM

Acoustical and electrical calibration of sound measuring instruments, measuring microphones and sound calibrators in accordance with the applicable national and international standards.

Model CAL291 - Precision Acoustic Calibrator

by Larson Davis, a division of PCB Piezotronics     Office in UNITED KINGDOM

The Model CAL291 is a dual channel Sound Calibrator. It is designed for measuring the residual intensity of sound intensity measurement systems. The following specifications apply: - When used with external signal generators the CAL291 Calibrator shall produce matched dual channel outputs of: ٠Sinusoids; Pink/White BB Noise. ٠1/3 ...

SKC - Model 220 Series - Bios Defender

by SKC Limited     based in Dorset, UNITED KINGDOM

Now more than ever, modern industry requires precisely-honed process control systems. Requirements, standards and competition have become so demanding, and the margin for error so slim, that for many organisations, ±2% or ±3% of reading standardised accuracy is no longer enough.

Landcal - Model R1200P - High Temperature Portable

by AMETEK Land     based in Dronfield, UNITED KINGDOM

Portable Reference Source - 350 to 1150 °C/650 to 2000 °F. LANDCAL R1200P is a high stability portable, blackbody reference standard source. R1200P can be used for both on-site or laboratory calibration of a range of short wavelength thermometers, such as System 4 and Fibroptic radiation thermometers.

Landcal - Model R1500T - High Temperature Transport

by AMETEK Land     based in Dronfield, UNITED KINGDOM

High Temp. Transportable blackbody reference source. LANDCAL R1500T is a high temperature, transportable blackbody radiation source designed for calibration of a range of thermometers such as System 4 and Fibroptic thermometers. R1500T is a reference standard source giving a resolution of ±1°C/2°F.

TAPI - Model T751 - Portable Zero Air System

by Enviro Technology Services plc     based in Stroud, UNITED KINGDOM

The Model 751 is a fully self-contained portable source of clean, dry air for use with dilution calibrators. It removes particulate and potential interferents from ambient air to create zero air suitable for calibration. It can also be used to provide purge air for permeation tube ovens.

Tekran - Model 2505 - Mercury Vapor Primary Calibration Unit

by Enviro Technology Services plc     based in Stroud, UNITED KINGDOM

The Tekran Model 2505 Mercury Vapor Calibration Unit is an ultra-precise and accurate closed-vessel, saturated gaseous mercury source. The 2505 utilizes a thermoelectrically cooled mercury reservoir and dual temperature sensors calibrated against a US National Institute of Standards and Technology (NIST) traceable source producing exceptionally ...

EiUK - Model LPC 200 - Electronic Pressure Calibrator

by Eurotron Instruments (UK) Ltd. (EiUK)     based in Daventry, UNITED KINGDOM

The EiUK LPC 200 fully documenting Pressure Calibrator provide unmachted pressure measurement and fexibility over any competive unit. It provides 0.025% FS accuracy (up to 1000 bar) on his internal interchangeable isolated stainless steel pressure sensor. A selection of more than 30 pressure modules for gauge and absolute pressure measurements ...

Model LPC 300 - Documenting Process Calibrator

by Eurotron Instruments (UK) Ltd. (EiUK)     based in Daventry, UNITED KINGDOM

The EiUK LPC 300 fully documenting Pressure Calibrator provide unmachted pressure measurement and fexibility over any competive unit. It provides 0.025% FS accuracy (up to 1000 bar) on his internal interchangeable isolated stainless steel pressure sensor. A selection of more than 30 pressure modules for gauge and absolute pressure measurements ...

TAPI - Model T703 - Photometric O3 Calibrator

by Enviro Technology Services plc     based in Stroud, UNITED KINGDOM

The Model T703 is a microprocessor controlled ozone calibrator for precision gas analysers. It can deliver concentrations from 50 ppb to 5 ppm at flows from 1 LPM to 5 LPM. The Model T703 has two major components; the ozone generating device and the photometer. The ozone generator produces ozone by passing zero air over a UV lamp. Flow rate and ...

TAPI - Model T700 - Dynamic Dilution Calibrator

by Enviro Technology Services plc     based in Stroud, UNITED KINGDOM

The T700 is a microprocessor based calibrator for precision gas analyzers. Using highly accurate mass flow controllers combined with compressed sources of standard gases, calibration standards are provided for multipoint span and zero calibrations using up to 4 gas sources.

Model P 4 - Pneumatic Pressure Pump

by SIKA Dr. Siebert & Kühn GmbH & Co. KG     Office in Milton Keyne, UNITED KINGDOM

The test pumps and pressure generators are designed to enable the direct connection of all pressure systems to be tested using adapters. The test sample is easily connected using the rugged industrial hose with integrated quick coupling and supplied adapters. The reference is fitted directly at the top of the pump using a positioning adapter. The ...

Model VC120 - Vibration Calibrating System

by Metra Mess- und Frequenztechnik in Radebeul e.K. (MMF)     Distributor in Great Dunmow, UNITED KINGDOM

Rapid and easy calibration of vibration measuring systems. Measurement of frequency response. Built-in signal conditioner with transducer sensitivity display. Built-in accumulator for mobile use. Traceable to PTB standard.  PC controlled via USB. ASCII command set for external control

Remote Calibration

by Envirologger Limited     based in Twyning, UNITED KINGDOM

For users wishing to automate and remote control zero and span checks AQ WEB offers a direct gas cylinder injection system. When connected to the optional zero / span system the web logger controls a sequence at programmable preset intervals or remotely on demand. Sample air is directed via an inert PTFE (FEP) valve block to which is connected a ...

Rion - Model NC-74 Class 1 - Acoustic Calibrator

by ANV Measurement Systems     based in Milton Keynes, UNITED KINGDOM

The Rion NC-74 is a Class 1 (IEC 60942) Acoustic Calibrator. Rion designed and manufacture this precision device which is ideal for field calibration of sound level meters with standard half inch (or 1 inch) microphones. Class 1 performance is assured by the atmospheric pressure compensation system built in to the NC-74. The NC-74 is small, ...

Need help finding the right suppliers?

Let the XPRTs do the work for you