Ammonia Control Applications

15 Results found
Only show results available in Virginia?
OK
  • Category: Air & Climate ×

  • Subcategory: Ammonia Control ×

NH3 Monitoring in Air

by Unisearch Associates Inc.     based in Concord, ONTARIO (CANADA)

NH3 (Ammonia) is a colorless gas with a distinctive pungent smell. Ammonia monitoring is essential in coal-fired power plants, where NH3 is used to reduce NOx emissions. The ammonia consumes all of the NOx, but its high concentration that is needed for these purposes also starts reacting with other things and in the process can clog up filters and cause premature failure of expensive SCR equipment and pre-heaters. Not to mention that these high levels create an irreparable damage to the environment.

Final effluent monitoring for wastewater treatment industry

by Pollution & Process Monitoring Ltd     based in Sevenoaks, UNITED KINGDOM

Industry and municipal waste-water (sewage) treatment plants have had to respond to environmental legislation such as the Urban Waste Water Directive, IPC, IPPC and now the EPR (Environmental Permitting Regulations). As successive legislation becomes more stringent, discharge consents have been progressively tightened, and the need for self-regulation has become more important. As a consequence, on-line instrumentation has been installed throughout waste-water industry to continuously to provide final effluent monitoring and perform water analysis for key consent parameters.

Applications and Air Pollutants Removed in the Metallurgical and Metal Finishing Industries

by Bionomic Industries Inc.     based in Mahwah, NEW JERSEY (USA)

From Aluminum to Zinc in the Metals Industry, Bionomic offers field proven extensive line of equipment and systems for; capturing acid gases, ammonia and alkaline mists from metal cleaning, treatment, etching and finishing operations including chemical milling. Acid and NOx emissions from pickling, anodizing, chemical milling and precious metals dissolving operations. Systems for HCL recovery from pickling lines, special scrubbing equipment and chemistries for NOx removal. Zinc galvanizing and electrogalvanizing line emissions. Removal of fine metallic particulate including tars from smelters and sinter plants as well as particulate emissions from blast, reverberatory and other furnaces. 

Nitrification & Denitrification

by Cleveland Biotech Ltd.     based in Stockton on Tees, UNITED KINGDOM

Waste Water Treatment Plants, Fish ponds or tanks and Odours.

Incineration Industry Emissions Monitoring & Analysis

by Procal - Parker Hannifin Corp     based in Peterborough, UNITED KINGDOM

Monitoring of emissions from incinerators is a demanding application for Continuous Emission Monitoring Systems. The emissions produced are highly corrosive, some of the gases are soluble and, because the waste being burnt is constantly changing, the resulting stack gas temperature varies widely.

Industrial Solution for petrochemical, oil & fertilizer

by Macrotek Inc.     based in Markham, ONTARIO (CANADA)

Refineries and chemical plants increasingly face stringent environmental regulations in today’s industry while also consistently attempting to maximize output efficiency. Macrotek offers customized scrubbing technology designs to meet each unique refining application. An experienced engineering team and proven emission control technologies make Macrotek ideal for the extensive scope of refining processes.

Applications and Air Pollutants Removed in the Fertilizer Industry

by Bionomic Industries Inc.     based in Mahwah, NEW JERSEY (USA)

Wet Scrubbers, dry collectors, wet electrostatic precipitators and complete engineered systems for urea, MAP, DAP, TSP and AN Plant rotary dryers and coolers, reactors and ammoniation granulators, pug mills, rock acidulation, curing, storage and material handling operations to control emissions of: particulate, including phosphate rock dust, ammonium phosphate, ammonia, nitric acid, NOx, phosphoric acid, hydrogen fluoride, silicon tetrafluoride, sulfuric acid, removal. Complete systems for scrubbing and recovery/reconcentration of fluorosilicic acid up to 25% concentration.

Measurement solution for high NH3 monitoring from wastewater

by Protea Limited     based in Middlewich, UNITED KINGDOM

Protea was asked to supply a high level ammonia (NH3) measurement system for a waste water treatment plant. The reflux drums at the inlet to two ammonia stripping towers needed to be measured continuously. Protea designed a solution based around our Solus TDLAS analyser platform and a high level dilution system. The Solus analyser was configured for NH3 measurements in the range 0-500ppm. A dilution system incorporating special dilution probe and 19` control panel was installed before the analyser. This gave a dilution level of 600:1, enabling the NH3 analyser to measure in the range 0-30% Volume.

Ammonia (NH3) monitoring

by Ecotech Pty Ltd     based in Knoxfield, AUSTRALIA

Ammonia is a compound featuring a nitrogen molecule attached to three hydrogen molecules (NH3). It is a colorless gas with a characteristic pungent smell similar to human urine, as urine contains a large amount of ammonia in it.

Waste gas treatment for the LED industry

by DAS Environmental Expert GmbH     based in Dresden, GERMANY

Market analysts predict sustained growth in demand in the LED industry. After LED backlighting for the small LC displays of mobile phones and the LC displays of larger screens in the television market, the next potential growth market is the lighting industry: Sales of LEDs in this market in 2012 are almost USD 3.5 billion – thus nearly doubling since 2010. Analysts are expecting a growth of more than USD 7 billion in 2014 and believe that the total market for LEDs should peak at USD 17.7 billion.* A mass market of this scale for LEDs also means increasing emissions that need to be abated by specific waste gas treatment systems at the point of use. In the manufacture of products based on innovative light emitting diode (LED) technology, ammonia and hydrogen are used in large quantities as process gases. The environmental engineers at DAS have recognised this market trend and developed new solutions such as LARCH for waste gas treatment in MOCVD processes.

Nitric Acid Production Emissions Analysis

by Procal - Parker Hannifin Corp     based in Peterborough, UNITED KINGDOM

The Procal 2000 emissions analyser measures Oxides of Nitrogen for process control purposes, typically upstream of the N2O abatement reactor where typical pressures can be as high as 10 barg.  The analyser can be supplied in both in situ and extractive configuration to suit customers’ requirements.

Industrial water Ammonia & Arsenic removal from water

by PuriTech Ltd     based in Herentals, BELGIUM

Nitrogen is a nutrient essential to all forms of life as a basic building block of plant and animal protein. Nevertheless, too much of it can be toxic. The processes used for the removal of ammonium ions from drinking waters include ion exchange. PuriTech`s ION-IX system can be broken up into 4 distinctive zones with each zone operating continuously. The resin is initially loaded with the Ammonia ions (and partially calcium and magnesium)in the adsorption zone. As the ION-IX multi-port valve rotates, the resin that has been saturated with Ammonia ions (and some calcium and magnesium ions)moves into a one-bed displacement zone with softened water to ensure hard water does not cause precipitation within the multi port valve.

radiello™ Passive Sampler as a Tool for the Measurement of Atmospheric Ammonia Concentrations and Dry Deposition

by Sigma-Aldrich Co., LLC     based in Bellefonte, PENNSYLVANIA (USA)

The radiello ammonia sampler impregnated with phosphoric acid represents a low-cost, reliable and simple tool for assessing the atmospheric deposition of ammonia at parts per billion (ppb) concentration levels.

Ozone generators for aquaculture applications

by Absolute Systems Inc.     based in Edmonton, ALBERTA (CANADA)

Ozone provides both economical and ecological advantages to the Aquaculture industry. Ozone oxidation of aqua-farms improve water quality, destroys organics,  and increases DO levels which result  in faster growth rates, decreased death tolls, and provides an overall healthier and safe environment for fish.

Need help finding the right suppliers?

Let the XPRTs do the work for you