Air & Climate Applications available in South Africa

  • Premium

    Mass transfer and chemical separations applications for environmental plants

    Flue Gas Scrubbing, Waste Water Treatment, Drinking Water Treatment.

    By Raschig USA Inc. based in Arlington, TEXAS (USA).

  • Premium

    Continuous emissions monitoring in cement kilns

    Various pollutants form in the cement manufacturing process, especially when alternative fuels and waste-derived fuels are used. Typically a cement kiln using these fuels is a required to monitor hydrogen chloride (HCl). Gasmet CEM II is EN 15267-3 approved for HCl measurement in 0 … 15 mg/Nm3 range.High process temperatures result in generation of more nitrogen oxides (NOx) than in typical municipal waste incineration.

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Premium

    Laboratory instruments solutions for environmental industry

    The environmental challenges require internationally accepted standards, in which limits and test methods are defined. Metrohm instruments and applications comply with a lot of international environmental standards. Substances introduced into the environment are distributed among the environmental compartments water, soil (sediment), and air, as well as among the organisms living in them (biosphere). Only if we know the type and quantity of these contaminants can we protect the environment and its inhabitants.

    By Metrohm AG based in Herisau, SWITZERLAND.

  • Premium

    Monitoring of mercury in ambient air

    Mercury, being widespread in environment, has toxic effect on a human organism even at a low concentration. Therefore, quantitativ e determination of mercury in vari ous environments is one of the most important environmental monitoring problems. The use of a mercury analyzer RA-915M/RA-915+/RA- 915Light with Zeeman background correction provides di rect real-time continuous determination of mercury in air from 0.5 ng/m 3 within the overall possible range of me rcury concentration in ambient air.

    By Lumex Instruments Group based in Mission, BRITISH COLUMBIA (CANADA).

  • Premium

    Determination of the total mercury in a filtrate of wash-off samples from contaminated surfaces

    INTRODUCTION

    Quantitative determination of the total mercury content in filtrates of wash-off samples from the surfaces of walls, floors, equipment, and other facilities of m anufacturing areas is an effective method for the occupational safety monitoring.

    By Lumex Instruments Group based in Mission, BRITISH COLUMBIA (CANADA).

  • Premium

    Determination of proteins concentrations and their molecular weights

    INTRODUCTION

    The method enables fast separation of proteins according to their molecular weights (Mw) with subsequent protein quantification in pr otein-containing samples.

    By Lumex Instruments Group based in Mission, BRITISH COLUMBIA (CANADA).

  • Premium

    Direct atomic absorption mercury determination in tissues and biological samples

    INTRODUCTION

    Mercury and its compounds are highly toxic substances fo r humans. It occurs naturally and exists in various forms: elemental (or metallic); inorganic (e.g. mercuric chloride); and organic (e.g., methyl- and ethylmercury). These forms all have different toxicities and implications for health. Among naturally occurring mercury compounds, methylme rcury exerts a significant influence (neurotoxic action) on human health.

    By Lumex Instruments Group based in Mission, BRITISH COLUMBIA (CANADA).

  • Premium

    Chemiluminescense based analyzer for environmental applications

    Focuses on low NOx and NOx-related concentrations up to 100 ppm where high resolution is required. Parameters included are NO, NO2, NOx and NOy. Target applications are ambient air monitoring, indoor measurement, clean room measurement and atmospheric research.

    By ECO PHYSICS AG based in Duernten, SWITZERLAND.

  • Premium

    Circular Economy

    Our world economy is only 9.1% circular, leaving a massive Circularity Gap. This is an alarming United Nations statistic from the global Circularity Gap Report. Released this year, the Circularity Gap Report provides data and a framework for measuring and monitoring progress in bridging this gap, year by year. Tracking and targeting performance via the Global Circularity Metric helps us engage in uniform goal-setting and guides future action toward the greatest impacts.

    By thinkstep based in Leinfelden-Echterdingen, GERMANY.

  • Premium

    Erosion and dust control products for BMX

    Envirotac has been used for dust control / soil stabilization on numerous BMX tracks throughout the United States. Its not uncommon for Nationals to be hosted on an Envirotac stabilized surface. When constructing turns and jumps incorporate Envirotac into the soil to keep the shape of the jump or turn and have a dust free surface that will hold up to rain and snow.

  • Premium

    Erosion and dust control products for heavy haul road stabilizer

    Used on heavy haul roads, Envirotac prevents dust, wear, and erosion. Further, it helps saving water, preventing equipment damage due to dust, preventing loss of tire tread due to road wear and reducing emissions from equipment that would normally be used to maintain the road.

  • Premium

    Mass flow devices for industrial sector

    Axetris mass flow devices are used in a variety of industrial applications: Leak Tester, Thin Film Coating, CO2-Laser.

    By Axetris Ag based in Kaegiswil, SWITZERLAND.

  • Premium

    Machine condition monitoring for municipalities

    Overview

    Cities and towns are often responsible for maintaining critical assets such as water and wastewater treatment facilities and power generation plants. Oil analysis on this critical equipment as part of a robust maintenance program is a very cost effective way of failure avoidance. Additionally, greater emphasis on environmental conservation and a focus on delivering critical services while operating under reduced budgets leads municipalities to activate these programs. Spectro oil analysis...

    By Spectro Scientific based in Chelmsford, MASSACHUSETTS (USA).

  • Premium

    Mercury monitoring for isotopic abundance by the ICP-MS

    Studies of real-world ecosystems are very complex. Mercury species inter-conversion as well as mercury deposition and evasion are constantly occurring. One technique to help sort out the processes is to trace reactions using natural Hg isotopes. Either by enriching a system with a particular isotope or determination of isotopic ratios as a technique of source identification, isotopes are a powerful tool for investigation. The 

    By Tekran Instruments Corporation based in Toronto, ONTARIO (CANADA).

  • Premium

    Erosion and dust control products for transportation

    Envirotac line of polymers have been used to construct roads around the world. Our polymers cross link the soils at a nano level creating a tough durable surface that will stand up to Heavy Haul trucks and the daily grind of vehicular traffic. If you are using Chlorides, Lignin`s, or Enzymes, make the switch to a superior road stabilizing technology.

  • Premium

    Erosion and dust control products for staging yards

    If you have a large project both temporary or permanent and you need a staging yard, Envirotac line of polymers is a perfect product for you. The beginning phases of a project are usually the most dusty and when you want to keep your neighbors happiest and not complaining about your big new project. It is great for keeping dust down and stabilizing the area giving your area the strength it needs to support heavy equipment.

  • Premium

    Laser gas detection for research

    Axetris laser gas detection OEM modules are used in a variety of research applications: Climate Change Research, Environmental Research.

    By Axetris Ag based in Kaegiswil, SWITZERLAND.

  • Premium

    Erosion and dust control products for unpaved road stabilizer

    Our Envirotac line of polymers have been used on roads around the world. Used with in-situ material, Envirotac will increase the CBR, increase compaction, reduce soils permeability, create a dust free surface, and increase traction even when wet, all at a fraction of the cost of asphalt, importing rock base, maintaining with water and using bitumen.

  • Premium

    Landfill Alternative Daily Cover Equipment

    Save time, labor, and SPACE in the management of your landfill. Designed specifically for use in the extreme environments of landfills, the LF120 HydroSeeder®, an exclusive FINN Landfill Solution™, is an efficient solution for applying alternative daily cover (ADC), as well as the application of materials to control odor, dust and erosion. The LF120 will cover the average open face in less than 1 hour using only one tank load. A tower discharge distance up to 180 feet allows for efficient ground coverage. Maneuveri...

    By FINN Corporation based in Fairfield, OHIO (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you