Only show results in Texas? Ok

Air & Climate Applications

  • Flame Photometer for Measurement of Sodium, Potassium and Calcium in Fresh Fruit

    In most cases, it was found that flame photometry was well suited for the determination of sodium, potassium and calcium in fresh fruits, using the wet washing technique as given below.

    By BWB Technologies based in Newbury, UNITED KINGDOM.

  • Flame Photometer for Measurement of Low Concentrations of Sodium in Cement

    This method allows the direct measurement of low levels of sodium without prior extraction procedures, which minimises possible sources of contamination.

    By BWB Technologies based in Newbury, UNITED KINGDOM.

  • Laser Gas Monitor for Emissions Monitoring

    The Environnement S.A Laser Gas Monitor Extractive version can monitor trace level gas concentrations (ppb resolution) at 1 Hz or faster. The LAS 300 RK is designed to deliver high performance in applications where rapid, accurate measurements are essential; CEMS, process control, atmospheric and environmental monitoring, and the protection of personnel.

    By TDL Sensors Ltd/ ENVEA based in Manchester, UNITED KINGDOM.

  • NDIR Carbon Dioxide (CO2) Monitoring

    Carbon dioxide has a wide range of commercial uses, from the production of lasers to the carbonation of soft drinks. This gas has become a topic of interest because it is classified among the greenhouse gases, gases which impact the Earth's environment when they reach high concentrations in the atmosphere. We propose solutions for medical diagnostics (out-breath control) and for ecological monitoring (control of carbon dioxide, exhaust gases in the atmosphere).

    By LED Microsensor NT based in Saint-Petersburg, RUSSIA.

  • Industrial solutions for the carbon dioxide (CO2) lasers

    Carbon Dioxide (CO2) lasers are high power lasers, usually used for cutting of ferrous and non-ferrous metals. High-performance gas flow control is a key requirement for achieving high cutting performance with CO2 lasers. Gas flow control plays an important role for mixing key gases at a number of locations with a CO2 laser: Beam Generation: The gas mixture used as the emitting medium usually consists of CO2, He and N2. Most laser manufacturers specify a minimum required purity for the beam generation gas...

    By Axetris AG based in Kaegiswil, SWITZERLAND.

  • Online monitoring solutions for the determination of CO/CO2 in vent gases

    Determining levels of CO and CO2 and their respective ratio in the oxychlorination reactor contributes to overall process efficiency. The on-line analyzer system uses a selective CO/CO2 measurement by means of multi-wavelength infrared with automatic optical span possibility.

    By AppliTek NV based in Nazareth, BELGIUM.

  • Monitoring industrial trade discharge for wastewater treatement industry

    Industry has had to respond to the requirements of progressive environmental legislation such as the Urban Waste Water Directive, IPC, IPPC and now the EPR (Environmental Permitting Regulations). As successive legislation becomes more stringent, discharge consents have been progressively tightened, and the need for self-regulation has become more important. As a consequence, on-line instrumentation has been installed throughout waste-water industry to continuously to provide trade discharge monitoring and perform...

    By Pollution & Process Monitoring Ltd based in Sevenoaks, UNITED KINGDOM.

  • Water measurement systems & sensors for flood warning

    Isodaq’s low-cost Isodaq telemetry data logger RTUs integrated with our telemetry data acquisition and alarm-message forwarding systems together provide the ideal solution for early warning of key events such as floods, pollution or CSO overflows.

    By Isodaq Technology - Hydro-Logic Group based in Bromyard, UNITED KINGDOM.

  • CH4 Monitoring in Air

    CH4 (Methane) is a colorless, odorless natural gas that is used in a wide variety of industrial applications such as power generation and chemical production. It is also a byproduct of many biological and geological processes, fracking, and gas drilling. It is highly flammable and creates amounts of carbon monoxide as its combustion byproduct. Methane needs constant monitoring in waste water treatment (for co-generation) and to ensure proper process control (e.g. to determine burning efficiency). A quality CH4...

    By Unisearch Associates Inc. based in Concord, ONTARIO (CANADA).

  • Industrial solutions for cooling water contamination

    Problem: Large quantities of water are used for cooling in industrial manufacturing. To prevent scaling, corrosion and biofilm in the cooling system, inhibitors and biocides are regularity dosed. Make-up water is continuously added to the system to balance the loss of water from evaporation. As water is added, the concentration of chemicals is diluted and the quality of water changes.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Industrial solutions for water reuse optimization

    Problem: With rising water costs, greater water scarcities and increasing environmental compliance regulations, reuse of water is becoming widely practiced in the manufacturing industry. For most industries, some form of treatment is required to ensure water meets standards for reuse.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Water quality monitoring for municipal drinking water industry

    Real Tech offers solutions that can provide substantial benefits to drinking water treatment plants. Continuous online monitoring can ensure water quality standards are met without the need for chemical overdosing while maintaining high confidence in the safety of the treated water. Significant cost savings can be achieved by optimizing coagulant dosage, reduced sludge production and reduced energy requirements.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Monitoring solvent levels in pharmaceutical waste water using a Lonestar portable analyzer

    Bacteriological biodegradation is used to treat certain waste water streams however excesses of some solvents will poison the bacteria reducing their efficiency. Consequently there is value in being able to quickly measure concentrations of these critical solvents so they can be pretreated/diluted to protect the bacteria.

    By Owlstone Nanotech, Inc. based in Norwalk, CONNECTICUT (USA).

  • Water and wastewater treatment solutions for cooling water treatment sector

    Cooling water treatment: Many industrial facilities rely on effective cooling to function properly. Today’s trend is not only to reduce the consumption of water during cooling, but also to optimise its quality and environmental friendliness. A good cooling water treatment provides operational efficiency, reliability and increases the lifespan of your machinery.

    By Aquarex WATERPROFIT s.r.o. based in Uherské Hradište, CZECH REPUBLIC.

  • Identifying and analyzing chemical compounds solutions for indoor air monitoring industry

    Measurement of continual and one-time emissions in indoor air and characterization of remediation methods. Studies have demonstrated that indoor air is even more polluted than outdoor air and has devastating effects on health. This is an important concern in that we spend around 80% of our time in closed or confined spaces: homes, offices, schools, transportations and so on. Indoor air quality degradation results from materials such as paints, glues or woods; emitting low but continuous concentrations of chemical...

    By AlyXan based in Juvisy-Sur-Orge, FRANCE.

  • High performance separation system for lube oil industry

    Many lube oil recovery processes create aqueous and hydrocarbon emulsions that are difficult to separate by means of conventional liquid/liquid separations technology. Accomplishing the desired separation requires that these emulsified droplets be captured. Conventional coalescers are unable to provide the degree of brightness and clarity associated with good separation due to the inability to capture and remove the most penetrating droplets that indicate carry-over. Pentair Porous Media technologies have been...

    By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).

  • Early warning systems for drinking water

    Drinking water supply and distribution systems around the world (a critical and interdependent component of a nation’s infrastructure) are vulnerable to both intentional and accidental contamination. Unusual water quality may serve as a warning of potential contamination. The available physico-chemical sensors utilize general water quality parameters, such as free chlorine, oxidation reduction potential (ORP), total organic carbon (TOC), turbidity, pH, dissolved oxygen, chloride, ammonia, nitrate to detect...

    By microLAN B.V. - Aqualabo Group based in Waalwijk, NETHERLANDS.

  • High resolution weather data for the energy market

    Better decision making through accurate weather data and state of the art technology. The energy sector is highly sensitive to changes in weather and events that are hard to forecast like storms, fog, snowfall or freezing rain can lead to huge losses. Meteomatics develops pioneering technologies and uses latest scientific methods to deliver highly accurate weather data for every location on the globe.

    By Meteomatics AG based in St. Gallen, SWITZERLAND.

  • Environmental monitoring solution for fertilizer plants

    Measurement of particulates, SO2, NOX, ammonia, fluorides and greenhouse gas emissions from the fertilizer industry requires careful selection of instruments. Ecotech offers a complete monitoring solution tailored to this industry.

    By Ecotech - ACOEM Group based in Knoxfield, AUSTRALIA.

  • Air Quality Monitoring Equipment for Sample Handling Industry

    Within the field of gas analysis much time is spent looking at the accuracy and uncertainty in the detection technique. However, without appropriate sample handling, what you are measuring could potentially bear little or no relation to your original sample.

    By Signal Group Ltd based in Camberley, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you