Continuous Emissions Monitoring (CEMS) Applications available in Manitoba
-
Premium
Marine monitoring solutions
Marine monitoring is a variant of OPSIS general offers for continuous emissions monitoring (CEM) and process control. The special operating conditions on-board vessels call for special measures to comply with regulations and expectations. However, OPSIS has mastered this environment and has for many years successfully delivered systems for marine ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Gas analyzers and monitoring systems for aluminum production sector
Production of aluminum from its ores at aluminum smelters results in carbon dioxide CO2, carbon monoxide CO, sulfur dioxide SO2, and hydrogen fluoride HF gas emissions to the atmosphere. Read about our solutions for aluminum ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
-
Premium
Gas analyzers and monitoring systems for Power plants
Power plants are industrial facilities used to generate electric power with the help of one or more generators which convert different energy sources into electric power. Power plants need to monitor emissions continuously according to local emission regulations. Read about our solutions for the power ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
-
Premium
Gas flow management solutions for standard applications sector
Standard Applications of Gas Flow ...
By Environics, Inc. based in Tolland, CONNECTICUT (USA).
-
Premium
Continuous emissions monitoring solutions for waste to energy plants
Process control and emission monitoring in a waste to energy plant is a challenge. A large number of gaseous components need to be measured with high accuracy. Almost 100% uptime is required and the monitoring system needs to be easy to maintain and fast to calibrate. The OPSIS system is tested and approved to have the best performance and longest calibration intervals, and provides the waste to energy plant with an accurate analyser that will operate with a minimum of ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous emissions monitoring for brick plants
Process control and emissions monitoring in a brick plant is a challenge due to the high concentrations of HF. The HF is generated in the process and gas phase HF can reach 50 mg/m3 or more. To use an extractive system in this environment will demand a lot of ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous Emissions Monitoring System (CEMS) for Determination of a Gas
Continuous emission monitoring system (CEMS) is the total equipment necessary for the determination of a gas or particulate matter concentration or emission rate using pollutant analyzer measurements and a conversion equation, graph, or computer program to produce results in units of the applicable emission and transmit the information to the Continuous Emission Monitoring system. ...
By Enviro Solutions Technology Co.,Ltd based in Wuhan, CHINA.
-
Premium
Continuous emissions monitoring for real driving emissions
There are many cars that have a large impact on the environment in many places around the world. The emissions from fossil fuel cars are too high, and previous test methods have not given the full picture. Tests in a laboratory has, so far, been made indoors, in laboratories, and they do not match the reality, as they do not take into account the real driving conditions. Therefore, we have developed an accurate and reliable monitoring system that can measure the emissions in real life conditions. Based on our core ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous emissions monitoring solutions for steel plants
The nature of steel manufacturing processes places severe limitations on the monitoring methods that can be used. Aggressive environments combined with high levels of particulates and gases make the choice very ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous emissions monitoring for sulphuric acid production plants
The process control of a sulphuric acid plant needs good and reliable detection of gas phase sulphur dioxide (SO2). To measure SO2 is a challenge due to the corrosive environment and high concentration of SO2. Several places in the process needs to be monitored and to transport the sample gas is difficult. A large dynamic range is needed as the SO2 concentration can vary between 15% volume and a few mg/m3. Most systems installed need a lot of maintenance, sometimes as often as every ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous emissions monitoring solutions for H2S monitoring
To monitor H2S can be difficult. The UV absorption is without structure and the IR absorption has strong interference from H2O. The traditional way has been to remove all SO2 from the sample while keeping H2S, then convert H2S to SO2 ,and finally measure SO2 which then effectively yields the H2S concentration. The instruments used have often been ambient air SO2 analysers and extractive dilution systems. However, it is not unusual to experience practical problems with these type of ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Gas analyzers and monitoring systems for Raw gas measurements
Raw gases are untreated flue gases that have not passed through an emissions control technology system like selective catalytic reduction (SCR) or selective non-catalytic reduction (SNCR). They are generally measured for the sakes of process control and warranty tracking. Typically only a few components are measured but fourier transform infrared spectroscopy FTIR technology allows the measurement of all ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
-
Premium
Air pollution, emission and process monitoring systems for CEM solutions
With decades of industrial experience, our systems are designed and developed as a complete turnkey solution. From sample extraction, through analysis, data acquisition and report management, each system is configured to comply with the normative demands and technical constraints of our clients, specific to their ...
By ENVEA based in Poissy, FRANCE.
-
Premium
Gas monitoring instruments and systems for nitric acid process
Modern production method of nitric acid production may lead to generation of several different gaseous emission components, such as nitrogen oxides (NOx), ammonia NH3 and nitrous oxide N2O. Nitrogen monoxide is an intermediate gaseous product in manufacturing of nitric acid HNO3. NO is formed in a catalytic reaction between ammonia and molecular oxygen O2. But undesirable side reactions may result in formation of nitrogen dioxide NO2 and nitrous oxide N2O. The NO and NO2 emissions can be reduced by use of ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
-
Premium
Gas analyzers and monitoring systems for fertilizer and nitric acid production sector
Nitric acid is manufactured from ammonia and is a key chemical in the manufacture of fertilizers. This is the main reason why nitric acid is produced in such large quantities. The production process of nitric acid produces nitrogen oxides (NOx), ammonia (NH3) and nitrous oxide N2O ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
-
Premium
Continuous emissions monitoring solutions for power plants
OPSIS offers fully automated system solutions for continuous monitoring in power plants. The monitoring systems have been tested and approved by the German TÜV and the U.S. EPA among others, for the best performance and longest calibration ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Gas monitoring and dust monitoring
EM-5 series Continuous Emission Monitoring System (CEMS) Counting tail gas emission and realtime concentration NOX SO2 O2 Temperature pressure flow dust ...
By Hangzhou Chunlai Technology CO., Ltd. based in Hangzhou, CHINA.
-
Premium
Continuous emissions monitoring solutions for chemical industry
Process control and emissions monitoring in a chemical plant is a challenge due to corrosive gases, high dust load, and high temperatures. To use an extractive system in this environment will demand a lot of ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous emissions monitoring solutions for mineral wool production
Process control and emissions monitoring in a mineral wool plant is a challenge due to the presence of phenol and formaldehyde. To use an extractive system in this environment will demand a lot of maintenance. The OPSIS DOAS system is different and provides plants with an accurate analyser that will operate with a minimum of maintenance. The OPSIS DOAS system is based on a non-contact method using an optical measurement path that can operate across the ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Gas analyzers and monitoring systems for Compliance measurements
Several EU directives and national laws in European countries set requirements for continuous monitoring of flue gas emissions at power plants. The demand for emission measurements has only increased in recent years and the trend will undoubtedly continue. It is therefore increasingly important for power plants to have reliable information available on emission of air pollutants. A power plant’s license to operate can even depend on it. Because the reduction of emissions to desired levels requires ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you