Only show results in Virginia? Ok

Emissions Control equipment for Air and Climate

  • Premium

    Anguil - Emission Concentrator with Integrated Oxidizer

    Typical air pollution control projects focus on the capture mechanism and a destruction device. With regulations driving towards higher capture efficiencies, combustion devices must treat larger volumes of air with lower concentration of pollutants. The Anguil rotor concentrator is an adsorption system designed to concentrate large volume, low ...

    By Anguil Environmental Systems, Inc. based in Milwaukee, WISCONSIN (USA). from Thermal & Catlytic Oxidizers Product line

  • Premium

    Anguil - Off-Gas Treatment Systems

    The remediation division of Anguil Environmental Systems (formerly known as Global Technologies) is focused on treating emissions and water contaminants extracted from below the earths' surface.  Formed shortly after the 1990 Clean Air Act targeted emissions associated with the extraction of polluted compounds from contaminated ...

    By Anguil Environmental Systems, Inc. based in Milwaukee, WISCONSIN (USA).

  • Premium

    Model SAM32 E - Multi-Parameter Data Acquisition System

    Module for the acquisition of multiple signals (serial, logic analog inputs & outputs). Module for the acquisition of multiple signals (serial, logic analog inputs & outputs). Model SAM32 E is a sub-unit of a complete system of acquisition, storage and processing of analog and logic data. Its internal microprocessor enables it to ...

    By Norditech Pty Ltd based in Arndell Park, AUSTRALIA. from Emission Monitoring - Multigas Stationary Monitoring Systems Product line

  • Premium

    Munters - MAC Air Cleaner

    Ammonia is a natural residual product from livestock production and because of environmental regulations many farmers are facing limits for ammonia emission – especially when they increase their animal production. In order to make it possible for farmers to enlarge their production in areas with ammonia restrictions, Munters has developed ...

    By Munters based in Amesbury, MASSACHUSETTS (USA). from Pollution Control & VOC Abatement Product line

  • Premium

    Rotary Concentrator Systems

    Lowest Cost Technology for controlling VOC emissions from low concentration exhaust streams. Concentrator technology combined with an RTO system is the most cost effective solution for high volume and low VOC concentration process streams.

    By Catalytic Combustion Corporation based in Bloomer, WISCONSIN (USA). from VOC Control Catalysts Product line

  • Premium

    Amine Stripper Off Gas Oxidizer

    Reduce methane and VOC emissions, control odors and be a good neighbor. Contact Catalytic Combustion Corporation today for a quotation on a suitable Amine Stripper Off Gas Oxidizer for reducing methane, VOC’s and odoriferous compounds from your gas processing operations.

    By Catalytic Combustion Corporation based in Bloomer, WISCONSIN (USA). from VOC Control Catalysts Product line

  • Premium

    Catalyst for Consumer Products and Appliances

    Catalysts to control emissions from consumer appliances or to produce heat from the flameless catalytic oxidation of a hydrocarbon fuel. Catalytic Combustion Corporation is a leading supplier of catalysts in the consumer products market. We have designed catalysts for the purpose of generating heat from various liquid fuels. One such line of ...

    By Catalytic Combustion Corporation based in Bloomer, WISCONSIN (USA). from Catalyst Product line

  • Premium

    JCT - Model JCE-2 Ex - Midi Sample Gas Compressor Cooler

    Applications: For operation in Ex-zone 2. For extractive gas analysis. For emission and process monitoring. Continuous drying of sample gas to a precise low and constant outlet dew point. Minimises water vapour cross sensitivities and volumetric errors.

    By JCT Analysentechnik GmbH based in Wiener Neustadt, AUSTRIA. from Ex-approved Product line

  • Premium

    Catalyst for VOC Control

    Catalyst for high levels of VOC control for catalytic oxidizers and other process equipment. The use of catalyst to control VOC emissions has a long and successful history since the introduction of the 1990 amendments to the Clean Air Act.  CCC will evaluate your emissions and recommend a catalyst configuration and formulation to achieve ...

    By Catalytic Combustion Corporation based in Bloomer, WISCONSIN (USA). from Catalyst Product line

  • Premium

    Model C-Press - Screw Press for Efficient Sludge Dewatering

    The C-Press is the latest result of more than 20 years of experience in designing and manufacturing screw presses. By combining multiple ANDRITZ SEPARATION dewatering technologies, its uniquely compact design and its purpose developed features enables easy, operator-free sludge dewatering together with low energy and maintenance costs.

    By ANDRITZ Separation - ANDRITZ Group based in Graz, AUSTRIA. from Screw and Belt Presses Product line

  • Premium

    Model MVS 2M - Multi-Channel CEMS Management System

    MVS 2M is a multichannel system allowing to distribute two, three or four channels of fluids to an analysis cabinet named Stand-by Measurements Group (GMS). The GMS is composed of one or several analyzers, its function is to stand in for the Duty Measurement Group (GMT) if it is not available (calibration control or failure).

    By Norditech Pty Ltd based in Arndell Park, AUSTRALIA. from Emission Monitoring - Multigas Stationary Monitoring Systems Product line

  • Premium

    EmiControls - Model E46 - Emission Controls Unit

    The E46 is proposed as an effective solution to increase the Evaporation of at least 10-12 times that normally would occur on the covered surface. The atomization of the water takes place by pumping the water through special nozzles designed to exploit the Venturi effect to aspirate air so as to obtain drops with a high Evaporation potential. The ...

    By EmiControls based in Bolzano, ITALY. from Emission Controls Product line

  • Premium

    Beltran - Fume Coalescer - Fiber Bed Equipment

    Performance: Submicron particulates are emitted at various points in many industrial and chemical process. Conventional scrubbers and other mechanical collectors depend on kinetic forces, requiring high-energy inputs to collect particles smaller than about 2 microns.

    By Beltran Technologies, Inc. based in Brooklyn, NEW YORK (USA).

  • Premium

    EmiControls - Dust Controllers And Odor-Absorbing Machines

    Mobile or fixed dust controllers and odor-reducing machines. In addition to customized nozzle system installations, EmiControls also offers standardized dust controllers. Turbine models are made as well as dust-control lances. Both work in the same way. The nozzles generate a fine mist which binds the dust particles at source. All the models are ...

    By EmiControls based in Bolzano, ITALY. from Emission Controls Product line

  • Premium

    EmiControls - Model V12 - Dust Abatement Sprayers

    The V12 is an all-purpose, powerful and environmentally-friendly dust-control solution. With its 52° tilt angle and 360° pivoting angle, the high-performance turbine is geared up for the widest possible operating range. Special nozzles with a ceramic insert generate a fine mist which is highly effective at binding the dust particles at ...

    By EmiControls based in Bolzano, ITALY. from Emission Controls Product line

  • Premium

    EmiControls - Model V22 - Dust Abatement Sprayers

    The new and restyled V22 is the most powerful dust-suppression machine in EmiControls’ product range. Due to its long projection range and integrated 350° pivot function, it is most suitable for dust-control applications covering large areas. The patented nozzle head and the outer nozzle ring generate a finely atomized mist, which binds ...

    By EmiControls based in Bolzano, ITALY. from Emission Controls Product line

  • Premium

    EmiControls - Model L3 - Dust Abatement Sprayers

    The L3 lance is the first dust-control lance on the market. It is a compact and user-friendly solution for close-range applications. It works without a turbine, allowing it to get near to the source of dust. The spray action can be narrow and flat, fan-shaped or cylindrical, depending on the requirements in any given case. With its flexible spray ...

    By EmiControls based in Bolzano, ITALY. from Emission Controls Product line

  • Premium

    EmiControls - Model V7 - Dust Abatement Sprayers

    The V7 is the the V12 dust controller’s little sister. The patented nozzle head on the V7 is fitted in the axial direction in the turbine and achieves a much higher projection range than comparable nozzle configurations. It has a booster pump and can therefore also be used with the turbine switched off. The user-friendly remote control ...

    By EmiControls based in Bolzano, ITALY. from Emission Controls Product line

  • Premium

    EmiControls - Model V12SM - Dust Abatement Sprayers

    The V12Sm is the mobile solution to all your dust problems. It was designed on a platform so as to be loaded by any truck with a 6m (20 foot) loading bridge. It is the ideal solution for all the applications where the lack of water and power does not allow the use of standard equipment. The system can operate autonomously up to a maximum of 8 ...

    By EmiControls based in Bolzano, ITALY. from Emission Controls Product line

  • Premium

    EmiControls - Model V12S - Emission Controls Unit

    The fully-automatic V12S offers a universal, powerful and super silent environmentally-friendly dust control solution. The high-performance turbine with linear injection geometry of the water is an optimal solution for very precise throw. The turbine has the ability to run at 2 speeds giving the turbine the flexibility to throw the atomized water ...

    By EmiControls based in Bolzano, ITALY. from Emission Controls Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you