Exhaust Monitoring (Exhaust Gas) Equipment In Africa
-
PremiumManufactured by ENVEAbased in FRANCE
Rack 3U monitor using the TDL extractive technology to measure online the NH3 pre and/or post catalyst: SCR (Selective Catalytic Reduction) or SNCR (Selective Non-Catalytic Reduction) ENVEA is offering Laser Gas Detection (LGD) modules with exceptional advantages and value for the customer. Tunable Diode Laser Spectrometry (TDLS), ...
-
PremiumManufactured by ENVEAbased in FRANCE
), to reduce environmental impact and cost of reagents. To optimize this process, it is essential to use an emissions analysis system for simultaneous and continuous monitoring of NOx and ...
-
PremiumManufactured by ENVEAbased in FRANCE
The only system allowing the measurement of 1 or 2 independent streams in a single analysis ...
-
PremiumManufactured by ENVEAbased in FRANCE
Ultra-fast NH3 measurement (Ultra-fast response time : < 2 seconds). The use of the UV range for the measurement of NH3 has been specifically selected to avoid any interference with other major emission gases (CO, CO2, H2O etc..) that do not absorb in the ...
-
Manufactured by Rivertrace Ltdbased in UNITED KINGDOM
With the IMO’s 2020 global sulphur cap fast approaching, a popular solution to ensure compliance is to install an exhaust gas cleaning system (EGCS). For this, wet scrubber systems use wash water to remove the pollutants from the exhaust gas. Therefore the wash water being discharged must be monitored at all times to ensure it is ...
-
PremiumManufactured by ENVEAbased in FRANCE
Exists in single or dual stream version and “Ultra Low” version for low CO concentration measurements (0-10 to 0-50 ppm) Installed downstream a chiller, controlled at ...
-
PremiumManufactured by OPSIS ABbased in SWEDEN
The System M800 is tested and approved by international test institutes and measures SO2, CO2 and NOx using the reference methods NDUV and NDIR. A light emitter and receiver creates a light path across the internal diameter of the stack. From the receiver, the light is guided in an optical fiber to the ...
-
Manufactured by Organics Group plcbased in UNITED KINGDOM
With increasing environmental awareness and a tightening of statutory controls, the monitoring of exhaust gases emitting from landfill gas flaring and utilisation systems is becoming an increasingly important element of well-managed facilities. The recently prepared UK Environment Agency standards set limits for Carbon Monoxide, Oxides of ...
-
Manufactured by TSI Incorporatedbased in USA
TSI"s Series CA-6000 CA-CALC Single Gas Monitors are ideal exhaust gas analyzers for residential to commercial service technicians and safety inspectors measuring combustion exhaust gases. These exhaust gas analyzers are used to make direct and ambient exhaust gas measurements for tuning and preventative. Plant ...
-
Manufactured by Cirrus Research plcbased in UNITED KINGDOM
The CK:261S is a complete noise measurement kit containing a Class 1 Sound Level Meter that has been designed to meet the requirements of ISO 5130-1982 & §29 StVZO for the noise testing of motor vehicles. Designed to be used in workshops, garages and test laboratories alike, the CR:261S is a robust instrument that is simple to operate whilst providing the measurements needed. The CR:261S ...
-
Manufactured by Pulsar Instruments Plcbased in UNITED KINGDOM
The Model 91 (Class 1) or Model 92 (Class 2) noise testing sound meters are the ideal instruments to measure vehicle noise. On these models, the pre-amplifier can be removed from the instrument, connected via a cable and located next to the exhaust in the correct position. This allows the sound level meter to be read from the driver's seat ...
-
Manufactured by Sierra Instruments, Inc.based in USA
Our AirTrak 628S Thermal Mass Flow Meter was originally designed to work specifically with our BG3 Particulate Partial Flow Sampling System as an extremely fast, accurate, and repeatable engine air intake mass flow meter. In addition, the instrument has proven to be an excellent solution in all engine testing ...
-
Manufactured by TSI Incorporatedbased in USA
monitoring, research, exposure assessment, indoor air quality, filter testing, clearance testing, quality assurance and contaminant migration ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you