dry flue gas Equipment

47 Results found
Only show results available in Virginia?
OK
  • Category: Air & Climate ×

  • Subcategory: Flue Gas ×

  • Keyword: dry flue gas ×

Inova Semi Dry Flue Gas Treatment Process

by Hitachi Zosen Inova     based in Zurich, SWITZERLAND

Semi Dry: Simple, Effective and Waste Water Free. The semi dry flue gas treatment process removed acidic gaseous contaminants by neutralisation with hydrated lime dust. Heavy metal compounds and organic contaminants, such as dioxins and furans, are separated by adsorption onto activated carbon in the same process step.

Dry Flue Gas Desulfurization (SDR) System

by Ducon Technologies Inc.     based in Liverpool, NEW YORK (USA)

Ducon supplies Semi-Dry Removal (SDR) type Dry Flue Gas Desulfurization (FGD) Systems as well as Dry Injection type systems. The SDR systems are custom designed to absorb gaseous pollutants utilizing a spray dryer and a baghouse filter. Ducon's specially designed air atomizing nozzles provide the liquid reagent slurry into the spray dryer for high ...

Sorbacal - Model HSH - Single-Pass Dry Flue Gas Treatment

by Lhoist Group     based in Limelette, BELGIUM

Sorbacal HSH is a calcium hydroxide specifically developed for the single-pass dry flue gas treatment. It differs from Sorbacal H with a higher specific surface area (SSA): 15-18 m²/g for Sorbacal H and 25 m²/g for Sorbacal HSH. Sorbacal HSH was developed for the specifications of the Brazilian market and is produced in Brazil today.

Quasi-Dry Flue Gas Cleaning (Spray Absorption)

by DrySoTec GmbH     based in Essen, GERMANY

For the quasi-dry flue gas cleaning, suspensions or solutions are distributed in the flue gas flow by means of a spray absorber with rotary distributor or two-component nozzles. The acid flue gas components are absorbed in alkaline droplets with simultaneous water vaporization. For the separation of organic pollutants and heavy metals, an ...

Dry Flue Gas Cleaning (Dry Absorption, Conditioned Dry Absorption)

by DrySoTec GmbH     based in Essen, GERMANY

In the process of dry flue gas cleaning, the flue gas, if necessary, is moistened and cooled upstream of the actual reaction stage. This is done, on the one hand, for protecting the filter (temperature) and, on the other hand (if lime is used), for moistening the flue gas up to the dew point range. In order to bind the pollutants contained in the ...

Xerosorp For Dry Scrubbing Flue Gas Treatment Process

by Hitachi Zosen Inova     based in Zurich, SWITZERLAND

The dry scrubbing flue gas treatment process is designed to remove acidic gaseous contaminants by absorption with sodium bicarbonate. Due to the very high reactivity of sodium bicarbonate, only a small stoichiometry amount is required. The process is nearly independent of temperature and thus enables maximum energy recovery.

ITK Envifront - Model TAS - Dry Flue Gasses Adsorption System

by ITK Envifront AB     based in Växjö, SWEDEN

The ITK Envifront TAS process is developed for cleaning of flue gasses through so called dry adsorption and is specially suited for crematories, small waste incineration plants or hazardous waste incineration plants. The system is dimensioned for plants with a size of 100-2000 kg/h, with a medium to high utilitization.

Model GCEM4100 - Multi Channel Extractive Flue Gas Analyser

by Codel International Ltd     based in Bakewell, UNITED KINGDOM

The GCEM4100 is a hot extractive analyser for difficult flue gas monitoring applications. It uses infrared absorption spectroscopy to measure up to seven pollutant species in a single self-contained unit. Many conventional extractive systems require the sampled gas to be cleaned and dried to a very high standard prior to analysis, invariably ...

Gas Cooling and Drying System for Flue Gas Treatment

by Hofstetter BV     based in Schiphol-Rijk, NETHERLANDS

The gas temperature and moisture content is conditioned to the required level by cooling and condensation of the moisture in the gas. Depending on the required conditions air fin gas coolers or chiller systems are used to cool and condense the gas. After cooling/condensation the moisture droplets are removed from the gas with moisture ...

THERMOX - Model WDG-IVM/IQ - Smart Flue Gas Analyzers

by Ametek Process Instruments - THERMOX     based in Pittsburgh, PENNSYLVANIA (USA)

The WDG-IVM analyzer measures oxygen, combustibles and methane in natural gas-fired applications. It is ideal for gas-fired power boilers or for those using natural gas during start-up and shutdown. With this analyzer, you can monitor oxygen and combustibles for maximum fuel efficiency. In addition, the methane detector can be used for purge and ...

Dry Scrubber

by Santes Ltd. Co.     based in Temelli, TURKEY

In dry scrubber the absorption agent (usually lime or sodium bicarbonate) is fed into the reactor as a dry powder. In the reactor, gaseous pollutants are absorbed by the agent. The dose rate of reagent may depend on the temperature as well as on reagent type. In the design of SANTES Flue Gas Treatments, generally sodium bicarbonate is used as the ...

Dry Scrubbing Systems

by Carmeuse Lime     based in Pittsburgh, PENNSYLVANIA (USA)

Spray Dryer Absorption (SDA) is a dry scrubbing process that is generally used for low-sulfur coal. SDA FGD systems are typically located after the air preheaters, and the waste products are collected either in a baghouse or electrostatic precipitator. However, to achieve sulfur dioxide (SO2) reduction above 80% with good reagent use, the dry ...

Baghouse Filter Systems

by Götaverken Miljö AB, part of Babcock & Wilcox Vølund A/S     based in GÖTEBORG, SWEDEN

We have installed baghouse filter systems in installations for the incineration of both municipal and environmentally hazardous waste in biofuel-fired installations and applications within the mining industry. The primary purpose of baghouse filter systems is usually the removal of dust and, by introducing an additive, the removal of acidic ...

Bag Filter

by Santes Ltd. Co.     based in Temelli, TURKEY

In dry sorption processes the absorption agent (activated carbon) is fed into the reactor as a dry powder. The dose rate of activated carbon may depend on the temperature as well as on reagent type and brand. The reaction products generated are solid and need to be deposited from the flue-gas as dust in a subsequent stage, normally a bag filter. ...

Wet Scrubber

by Santes Ltd. Co.     based in Temelli, TURKEY

Wet scrubbers are used to absorb soluble gases into water or other liquids such as solutions and to remove particulates from gas streams by contacting with water or other liquid. The flue-gas flow is fed into water, hydrogen peroxide, or/and a washing solution containing part of the reagent (e.g. sodium hydroxide solution). In order to eliminate ...

Waste Incineration Plant

by Simatek A.S     based in Soroe, DENMARK

Throughout the past hundred years incineration plants for municipal waste have continuously been developed technologically. From the old days' incineration plants with a remarkable impact on the environment, today's state-of-the-art plants are pro-environmental and energy-generating units.Even small-sized plants are generating and supplying ...

Comfort Cooling – District Cooling Chillers

by Götaverken Miljö AB     based in GÖTEBORG, SWEDEN

The demand for cooling in buildings is increasing. The reasons are, besides the demand for comfort, the improved insulation of buildings nowadays and the increasing number of heat-producing Machines as computers and other Electronic Equipment. This provides district heating companies with new business opportunities based on the same concept as ...

IMR - Model 500 - Portable Flue-Gas Dryer

by IMR Environmental Equipment, Inc.     based in St. Petersburg, FLORIDA (USA)

Permeation dryer. Comes with heated hose, gas-sampling probe, filter, rugged case.

Swenson - Flue Gas Dry Scrubbing Systems (FGD)

by Swenson Technology, Inc.     based in Monee, ILLINOIS (USA)

The Swenson Flue Gas Dry Scrubbing System (FGD) is designed to remove sulfur dioxide, hydrogen chloride and other contaminants from flue gas. The FGD system consists of an alkali (Na or Ca) feed preparation, spray dryer, and dry collector (fabric filter or electrostatic precipitator). Alkali feed is atomized by means of a two-fluid nozzle or ...

Flue Gas Treatment System

by Joseph Egli AG     based in Oberurnen, SWITZERLAND

Depend on the environmental and economical request we design the flue gas treatment. Two principal of adsorption came to the fore, wet and dry adsorption. In case of emission there are mainly to standards requested: US EPA Standard, European Standard according the Guideline 2000/76/EC, Mostly both of the standards can be achieved by a dry or wet ...

Need help finding the right suppliers?

Let the XPRTs do the work for you