Gas Sampling Applications in Asia & Middle East

  • Premium

    Gas purification for the gas analysis industry

    By Umwelttechnik MCZ GmbH Distributor in Singapore, SINGAPORE.

  • Premium

    PTR-MS systems for medical sector

    PTR-MS are powerful tools for non-invasive, real-time breath gas analysis with many applications, such as screening for disease markers, study of pharmacokinetics or metabolic processes.

    By Ionicon Analytik Ges.m.b.H. Distributor in Beijing, CHINA.

  • Premium

    Laboratory instruments solutions for environmental industry

    The environmental challenges require internationally accepted standards, in which limits and test methods are defined. Metrohm instruments and applications comply with a lot of international environmental standards. Substances introduced into the environment are distributed among the environmental compartments water, soil (sediment), and air, as well as among the organisms living in them (biosphere). Only if we know the type and quantity of these contaminants can we protect the environment and its inhabitants.

    By Metrohm AG Distributor in BAHRAIN.

  • Premium

    Gas monitoring instruments and systems for stack testing

    Several EU directives and national laws in European countries set requirements for continuous monitoring of flue gas emissions at power plants. Further requirements are set on the quality assurance of the installed measurement systems at the plants. The relevant standard in this regard is EN 14181:2004, the quality assurance of automated measuring systems. The standard dictates how to determine that the measurement systems installed for continuous emissions monitoring at a plant operate according to the directives and regulations set. Two major parts of this on-going quality assurance cycle are the QAL2 and AST procedures. A test laboratory performs tests on the systems on-site, and determines whether the systems fulfill the set requirements or not.

    By Gasmet Technologies Oy Office in Kowloon, CHINA.

  • Premium

    Carbon Dioxide Monitoring for Indoor Air Quality

    Introduction: Accurate control of critical indoor environmental parameters is not only essential for the well-being and comfort of building occupants, but also has a major impact on energy efficiency. A multitude of parameters can affect indoor air quality (IAQ) from gases such as carbon dioxide, carbon monoxide and volatile organic compounds to particulates, humidity and bacteria such as legionella. Carbon dioxide is one of the greatest variables affecting indoor environmental quality since it is produced by people occupying the building. Carbon dioxide production is a function of the number, size and activity levels of the people present in the building. Local concentrations can therefore vary dramatically – for example when a meeting room is occupied, or while workers are on lunch or coffee breaks.

    By Edinburgh Sensors Ltd Distributor in Beijing, CHINA.

  • Premium

    Controlled Atmosphere Glove Boxes and Nitrogen Dry Boxes for Process Industry

    Glove boxes are designed for handling both hazardous substances and atmosphere sensitive materials. For controlled atmospheres, nitrogen dry boxes provide an isolated work environment for processing samples or handling air-sensitive materials while maintaining an anaerobic or other gas specific environment within the glove box. For work with hazardous materials, glove boxes provide a leak-tight environment protecting the user from exposure to potentially dangerous materials. Glove box applications include; anaerobic testing, biological research, catalyst research, hazard material contamination and pharmaceutical packaging.

    By Systech Instruments Ltd Office in Bangkok, THAILAND.

  • Gas Detection Solutions for GHG Monitoring

    Most sources of fugitive emissions are from multiple points rather than single point sources. So, open path area or perimeter monitoring provides more meaningful fugitive emissions data than an array of point sensors or a program of grab sampling. Point measurements may underestimate emissions because of missing locations with high gas concentrations, or conversely overestimate because they are located in areas of high concentrations. Grab sampling programs typically check only a small percentage of potential leak locations and extrapolate results to an entire facility. Wide margins of uncertainty are associated with such extrapolations. Open path monitoring provides continuously updated, real-time, integrated emissions across a facility boundary.This provides a complete picture of the fugitive emissions across that boundary,enabling identification of specific operations and times that give rise to higher emissions, and so enabling these emissions to be properly managed and controlled.

    By Boreal Laser Inc. Distributor in IRAN.

  • Air Quality Monitoring Equipment for Sample Handling Industry

    Within the field of gas analysis much time is spent looking at the accuracy and uncertainty in the detection technique. However, without appropriate sample handling, what you are measuring could potentially bear little or no relation to your original sample.

    By Signal Group Ltd Office in CHINA.

  • Measurement solution for multi-stream combustion research

    Protea supplied a complete turn-key measuring system for multi-point sampling in a University combustion research laboratory. Utilising the latest in FTIR spectroscopy, atmosFIR, a complete cabinet system was supplied containing: atmosFIR FTIR Gas analyser, Sampling System Control Module (SSCM), Heated Stream Selection Module (HSSM), Temperature Control Module (TCM), 4 heated sample lines, 4 heated sample probes, Embedded PC controller.

    By Protea Limited Distributor in Manama, BAHRAIN.

  • Filtration for Flue Gas Analysis and CEMS

    Three Steps of CEMS: 1st Step: Gas Sampling 2nd Step: Gas conditioning and treatment 3rd Step: Measurement/Calibration In first step, the function is to get sample gas and forward to 2nd step for treatment. During this step, it cannot block the probes and cannot result condensation of moisture. So a filter online back flushing should be equipped in this part. The filters to be used: 1, Filter is used to ensure the stability of system and reduce the maintenance 2, Filtration Grade: usually 2 or 3 micron 3, Temp. is around 0-180 deg C 4, Back flushing gas is heated, impulse flushing 5, Filter Material: Titanium Sintered, SS316L Sintered, PTFE sintered, Ceramic Membrane and so on 2nd Step Gas Treatment: #11;The coarse filters and the liquid particle filters The coarse and fine cartridge can filter the small particles in the gas and acid aerosol things to better protect the instruments. The micron can be 0.1micron, filtration rate can be up to 99.99%, two layers can be 99.9999%

    By Shanghai CMI Environmental Technology Co.,Ltd. based in Shanghai , CHINA.

  • Gas Detection Solutions for Aluminium

    Primary aluminium smelting generates large amounts of hydrogen fluoride gas (HF). Worker safety and ambient air quality concerns require that HF be monitored at several locations in smelters. Traditionally, a variety of chemical sampling methods have been used for HF monitoring in and around smelters. However, these methods are labour intensive and require ongoing maintenance and consumables. During the past decade, laser based HF analyzers have been replacing the traditional methods. Laser analyzers are compact, robust and reliable and provide accurate HF data. Fast response times that enable easy correlation of high HF emissions with work practices.

    By Boreal Laser Inc. Distributor in IRAN.

  • Measurement solution for CFC abatement control via two stream FTIR system

    CFC usage in industry

    Although the use of CFCs in domestic products has been widely phased out, CFCs chemicals still prove a vital ingredient in the production of insecticides and herbicides. Such products aim to increase the rate of crop production all over the world. All aspects of such a manufacturing process in relation to environmental impact must be well controlled. The use and pre-emission removal of CFCs in the intermediary steps of the insecticide production needs to be monitored with 100% efficiency.

    By Protea Limited Distributor in Manama, BAHRAIN.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you