low nox scr Articles

  • NOx Control on a Budget

    National, regional and local regulations to reduce NOx emissions have prompted the development and implementation of a number of NOx control technologies – from selective catalytic reduction and low-NOx burners to overfire air and flue gas recirculation. Induced flue gas recirculation (IFGR), a design derivative of conventional forced flue gas recirculation, has demonstrated NOx reductions as ...

  • The Chemical Aspect of NOx Scrubbing

    With the passage of the 1990 Clean Air Act Amendments, many chemical and metal industries and utility producers will now be required to further limit the amount of NOx (Nitrogen Oxides) produced. NOx is a precursor to ozone in the atmosphere, and is believed to be a major contributor to acidic deposition (acid rain). Formation of ozone: NOx is produced in a variety of ...


    By CR Clean Air Group, LLC

  • Combinations of Measures for Reduction of NOx & Nanoparticles of a Diesel Engine

    Reduction of NOx- and particle emissions of Diesel engines is worldwide an important challenge for the engineers. Some unregulated components, like NO2, NH3 and naoparticles NP came in the focus of attention in the last years.Application of EGR and / or SCR can lower NOx, using RME (Bxx) can increase NOx. What happens with NP, parameter which enters in some further steps of exhaust gas ...


    By Vestlandsforsking

  • NOx in Non-Utility Industries - Part II - Control options and monitoring methodology

     This the second in a two-part series. Part I, which appeared in our June 2001 issue focuses on air emission origins of nitrogen oxides (NOx) in non-utility industries. Choice of the NOx control technology is dependent on many factors, including regulatory requirements, technical feasibility, cost and public perception. Figure 1, compiled based on publications [1-5], presents a summary of ...


  • Fast, simultaneous and continuous monitoring of NOx and NH3 in DeNOx applications

    In DeNOx systems using urea injection with ammonia (NH3) as a reducing agent, the flow rate and control of NH3 must be continuously adjusted and controlled to prevent excess NH3 emissions (slip), to reduce environmental impact and cost of reagents. To optimize this process, it is essential to use an emissions analysis system for simultaneous and continuous monitoring of NOx and NH3. For preparing ...


    By Environnement S.A

  • Insitu analysis of ammonia slip and water vapor using a tunable diode laser for SCR/SNCR optimization and boiler tube surveillance in power plants

    ABSTRACT Environmental Regulations driven by the 1990 Clean Air Act require Power Plants to reduce NOx emissions. SCR's and SNCR's reduce NOx emission by injecting ammonia into the combustion flue gas. which ideally reacts with the NOx to form H?0 and Nj. The efficiency of the SCR SNCR is determined by monitoring the outlet for excess NH3. referred to as NH3 slip. The flue gas sample ...

  • NOx in Non-Utility Industries - Part I NOx in Non-Utility Industries - Part I - Air emission origins, best control solutions and monitoring methodology for nitrogen oxides

     Problems with reducing nitrogen oxides (NOx) are widespread in the general process industries. These industries, together with medium size utility and power generators contribute about 15 percent of global NOx emissions. The emission sources addressed include various heaters employed in chemical and petrochemical plants, nitric and sulfuric acid plants, glass furnaces, iron and steel mills, ...


  • Pharmaceutical Manufacturer Turns NOx Regulations Into an Opportunity – With a 6-Figure Annual Chemical Savings as a Bonus.

    This project was for a major manufacturer of a tabletted OTC analgesic. The manufacturing process was being redesigned, and a critical aspect of the work was the re-engineering of a reactor in the initial stage of manufacturing. The client’s original process, which used nitric acid to dissolve a metal, exhausted virtually 100% nitrogen oxide (NO), a toxic, wholly non-water-soluble gas that reacts ...


    By Tri-Mer Corporation

  • LaCygne - GSG™ Graduated Straightening Grid Performance

    KCP&L’s LaCygne Generating Station provides 1,532 MW of peak power to customers from the site south of Kansas City. LaCygne Unit 1 is an 815 MW B&W cyclone boiler with Over-Fire Air (OFA) and SCR NOx controls, and the second oldest WFGD installation in the country. LaCygne Unit 2 is a 717 MW B&W PC boiler with Low NOx Burners (LNB), OFA, and ESP particulate control. ...


    By Fuel Tech, Inc.

  • Reaching Euro VI emissions limits

    The requirements of low and lowest detectable exhaust analysis has prompted Eco Physics to launch a broad range of analyzers for NO/NOx detection. Emissions tuning is one of the targets of the EURO VI regulations as well as US EPA 2010, which are: Reduction of Particulate Matter (PM) and reduction of Nitrogen Oxides (NOx). In the past 15 years – since the first European regulation for exhaust ...


    By ECO PHYSICS INC.

  • Minimizing ammonia consumption in DeNOx plants – Case Study

    Flue gas denitrification Combustion processes result in emissions that can be harmful to the environment, in particular carbon dioxide (CO2), sulfur dioxide (SO2), nitric oxides (NOx), and dust. Therefore, measures are implemented in power stations and other plants comprising combustion processes to reduce emissions. For flue gas denitrification, besides front-end primary ...

  • Los Angeles County Sanitation Districts: Siloxane Removal

    Los Angeles County Sanitation Districts have long been involved with recovering landfill and digester gas for energy to power turbines and internal combustion engines. Their experience led them to identify performance issues associated with these gases. One particular challenge is siloxanes. Cyclic organic silicon monomers (siloxanes) used in the manufacture of personal hygiene, health care and ...


    By Pioneer Air Systems

  • Tuning Your Boiler for Fuel Savings – Out with the Old in with the New Technology

    The USA has about 811,000 MW of installed generation and over 52% of our Electric power is produced by aging coal fired power plants. The average utility boiler furnace was designed about 30-40 years ago. According to DOE records, the average boiler in 1974 was fired with 80% bituminous coal. Now, western PRB coal is much more prevalent and represents about 50% of total coal ...

  • Federal transport rule — the “new cair” round 1

    On August 2, 2010, EPA proposed the long- awaited replacement for the Clean Air Interstate Rule (CAIR), which was rejected in 2008 by the D.C. Circuit Court of Appeals. Now called the Transport Rule (TR) by EPA, the new rule revises the CAIR approach to conform with the court ruling. In this first version (Round 1) of TR, overall emission budgets for NOX are similar to the initial period in CAIR; ...


    By Trinity Consultants

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you