particulate monitoring technology Articles

  • Selection of Particulate Monitors

    The installation and operation of continuous particulate emission monitors in industrial processes has become well developed and common practice in industrial stacks and ducts over the past 30 years reflecting regulatory monitoring requirements. It supports requirements originating from LAPPC (Local Air Pollution Prevention and Control), IPPC (Integrated Pollution Prevention and Control), WID ...


    By PCME Ltd

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...

  • A Special Issue of the Journal of the Air & Waste Management Association on the Particulate Matter Supersites

    This special issue of the Journal of the Air & Waste Management Association contains 15 peer-reviewed scientific papers from the specialty conference Particulate Matter Supersites Program and Related Studies, which was held in February 2005 in Atlanta, GA. Other peer-reviewed papers will appear in companion issues of the Journal of Geophysical Research, Aerosol Science and Technology, and ...

  • Monitoring Environmental Quality

    ' In order to determine the effectiveness of actions to improve environmental quality it is necessary to be able to measure relevant environmental parameters at a level of detail which is accurate enough to distinguish the anticipated changes. However, the establishment and maintenance of monitoring systems is time-consuming and expensive and therefore the scale of such systems needs to be kept ...


    By The World Bank

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By SIGRIST - PHOTOMETER AG

  • A preliminary review of gas-to-particle conversion monitoring and modelling efforts in the USA

    Ammonia and inorganic acid gases emitted from livestock and poultry operations, manure treatment, handling and application can affect air quality by the formation of secondary fine particles. The process of gas-to-particle conversion (GTPC) of relatively short-lived gaseous ammonia to more persistent fine particles can affect local and regional air quality far away from the agricultural sources. ...


    By Inderscience Publishers

  • Measuring SO2 ship emissions with an ultraviolet imaging camera

    Over the last few years fast-sampling ultraviolet (UV) imaging cameras have been developed for use in measuring SO2 emissions from industrial sources (e.g. power plants; typical emission rates ~ 1–10 kg s−1) and natural sources (e.g. volcanoes; typical emission rates ~ 10–100 kg s−1). Generally, measurements have been made from sources rich in SO2 with high concentrations ...

  • Is it time to upgrade the PM2.5 federal reference method?

    The fine particulate matter (PM2.5) Federal Reference Method (FRM) has in many respects been a great success. When the method was implemented, there was some doubt that the state and local monitoring agencies that routinely provide air quality data would be able to manage a program, which often distinguishes one location from another by just a few μg/m3. As it turns out, data from the FRM ...

  • Simultaneous determination of PM fractions, particle number and particle size distribution in high time resolution applying one and the same optical measurement technique

    Abstract The Fidas fine dust monitoring systems comprise an optical aerosol spectrometer, which is characterized by very good instrument characteristics, and utilize a sophisticated approach to convert the measured information on particle number and particle size into mass concentrations. As monitoring of PM requires reliable and quality-controlled performance of the measuring systems, ...


    By Palas GmbH

  • Minimising Risks to Air Quality and Regulatory Compliance With Total Filter Management

    It has been shown in recent studies that as much as 25% of the total site operating budget (excluding raw material costs) for a typical medium-large dosage-form manufacturing facility will be spent on compliance measures for internal quality systems and external regulatory activities. (1) Market realities indicate that the pharmaceutical companies will need to address the overall cost of ...


    By GVS Filter Technology

  • Dye and Pigment Manufacturing Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Least-Cost Approaches to Reducing Acid Emissions

    ' The costs of meeting sulfur emission targets can be high. It is essential, therefore, that countries adopt policies which (a) minimize the net economic and social costs of reducing emissions to the agreed target levels, and (b) maximize the overlap between measures designed to reduce acidifying emissions and those addressing other forms of air pollution. This note discusses alternative ...


    By The World Bank

  • Sample Handling Strategies for Accurate Lead-In-Soil Measurements in the Field and Laboratory

    ABSTRACT The inhomogenous lead-in-soil matrix can present serious obstacles to accurate sample collection and handling. In typical lead-in-soil measurement, particle size related errors in sampling and sample handling often exceed all other sources of error. The magnitude of error can vary widely depending on the particulate nature of the lead contaminant and the effectiveness of control ...

  • CEMS: An Overview

    We've written an overview to where CEMS are required, types of site that require CEMS and future requirements. Continuous Emissions Monitoring Systems are used to continuously collect, record and report data from industrial process operators that produce emissions to air. CEMS are used as a means to comply with ...


    By a1-cbiss

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you