Particulate Equipment For Air And Climate In South Africa
-
PremiumManufactured by Anguil Environmental Systems, Inc.based in USA
The standard Anguil inlet filter plenum consists of stages of filtration to prevent particulates from entering your oxidizer and negatively affecting ...
-
PremiumManufactured by Anguil Environmental Systems, Inc.based in USA
The Anguil Thermal Recuperative Oxidizer destroys Hazardous Air Pollutants (HAPs), Volatile Organic Compounds (VOCs), and odorous emissions discharged from various industrial processes using thermal oxidation and heat recovery. Anguil’s thermal recuperative oxidizers incorporate flexible heat exchanger arrangements, from cleanable tubes ideal for applications with particulates, to shell ...
-
PremiumManufactured by Anguil Environmental Systems, Inc.based in USA
The Anguil Emission Concentrator is an adsorption system designed to concentrate large volume, low concentration process exhaust into a much smaller, higher concentrated air stream. The greatly reduced flow with higher Volatile Organic Compound (VOC) concentration is sent to a thermal or catalytic oxidizer for VOC destruction. The destruction device can then be much smaller in size, significantly ...
-
PremiumManufactured by Anguil Environmental Systems, Inc.based in USA
The Anguil Self-Cleaning Ceramic Filter (SCCF) collects, volatilizes and destroys particulate and condensable organics emitted from industrial process streams. It can be used independently as a filter media on hot and cold process streams or coupled with an oxidation module for total odor, Volatile Organic Compound (VOC) and Hazardous Air Pollutant (HAP) ...
-
PremiumManufactured by ENVEAbased in FRANCE
QAL1 approved ProScatterTM particulate CEM for the extractive sampling and measurement of particulate in saturated wet gas streams. Continuous Particulate Monitoring for saturated wet stack applications typically found after wet scrubbers, wet electrostatic precipitators and wet flue gas desulphurisation ...
-
PremiumManufactured by Particle Measuring Systems (PMS)based in USA
Compressed gases are viewed as critical utilities in many industries when in direct product contact or in the clean room environment. Control of the environment where Pharmaceutical and Cosmetic products are manufactured is a key element of ISO and GMP Standards worldwide. The absence of viable contamination is considered a critical quality attribute due to its potential to dramatically impact ...
-
PremiumManufactured by ENVEAbased in FRANCE
The last generation of Cairsens micro-sensors for Particulate Matters (PM) monitoring operates without any influence from moisture in ambient air. They measure PM1 and PM10 concentrations, with increased precision for PM2.5. The Cairsens allows a year of continuous maintenance-free operation, even in highly polluted and humid atmospheres. Thanks to its robust and miniature design, it is fully ...
-
PremiumManufactured by ENVEAbased in FRANCE
Suitable for industrial processes controlled with dry scrubbing and high efficiency bag filtration. The PCME QAL 991 uses unique ElectroDynamic™ Probe Electrification technology, which outperforms alternative probe electrification technologies by extracting a specific frequency band of the induced AC signal. This patented feature ensures confidence in accurate and representative data by ...
-
PremiumManufactured by AMETEK Land Instruments International Ltdbased in UNITED KINGDOM
Dust and opacity monitor, designed for measuring dust emission concentrations in combustion applications where automatic calibration checks are not required. The 4200+ is the most accurate and reliable monitor available for dust and opacity measurements in combustion applications not requiring automatic calibration checks and regulatory compliance. Optimised for multi-process plants using common ...
-
PremiumManufactured by ENVEAbased in FRANCE
Continuously monitors particulate flow for signs of filter damage or broken filter bags. Compact and cost effective. The Dusty C has been specially developed to monitor clean sides after filters with high reliability and without time delay for filter breaks. It can be used in metallic ducts in which dust particles will be detected in the gas flow. Its area of application begins at dust levels ...
-
PremiumManufactured by ENVEAbased in FRANCE
The QAL 260 series is suitable for measuring dust concentrations in Combustion, Incineration and other industrial stacks and is compliant with EN 14181. Having a 0-15 mg/m³ certification range, the QAL 260 sensor can be used at low or high dust levels. Due to dynamic ranging, the sensor is also suitable for much higher dust levels found in Power, Cement and Metals smelting ...
-
PremiumManufactured by OPSIS ABbased in SWEDEN
The PM10 monitor version of OPSIS’ SM200 particulate monitor provides accurate and reliable automatic measurements of PM10 particulate fraction concentrations in ambient air, as well as sampling of the PM10 particulate fraction for subsequent manual ...
-
PremiumManufactured by AMETEK Land Instruments International Ltdbased in UNITED KINGDOM
Simple, lightweight dust and opacity monitor designed to measure emission levels in combustion processes where regulatory compliance is not required (for sale in Asia only). The 4200 dust and opacity monitor is AMETEK Land’s compact, cost-effective solution for the continuous monitoring of dust, smoke and particulates in a wide range of industrial applications. NOTE: The 4200 is currently ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
The ACME Basket strainer consists of a removable screen that can easily be removed from the top. Basket Strainers are used to trap suspended solids and particulate too large to be caught by most filter media. Basket strainers temporarily disrupt?a?system?when cleaning is ...
-
Manufactured by Dürr Systems, Inc.based in USA
Inorganic pollutants and particulates can be treated using a broad range of absorption technologies also known as “scrubbers”. Various different scrubber designs are available depending on the application. For example, venturi, rotation and dynamic scrubbers are used for the abatement of particulates - even at high temperatures and extremely sticky conditions - where fabric filters ...
-
Manufactured by Saubatech (Pty) Limitedbased in SOUTH AFRICA
During the elution process, activated carbon that is deemed too fine for re-use is removed. This fine carbon residue contains on average between 50 to 200 grams of Gold per ton. In the past these carbon fines were discarded, or had to be recovered in chemical plants that cannot achieve industrial scale and had high operating ...
-
Manufactured by BASF Catalystsbased in USA
BASF's Diesel Oxidation Catalyst (DOC) technology controls emissions of hydrocarbons (HC), carbon monoxide (CO) and particulate matter (PM) from diesel ...
-
Manufactured by SKCbased in USA
The BioLite, up to 30.5 L/min or sonic flow, area sample pump provides indefinite run times using a 230-V AC adapter for sampling particulates and bioaerosols. The pump is ideal for use with the SKC BioSampler and asbestos cassettes. CE marked Not UL Listed for intrinsic ...
-
Manufactured by HORIBA Europe GmbHbased in GERMANY
The APDA-371 automatically measures and records airborne particulate concentration levels (in milligrams or micrograms per cubic meter), using the industry-proven principle of beta ray attenuation. Thousands of this Dust Analyzer units are currently deployed worldwide, making the unit one of the most successful air monitoring platforms in the ...
-
Manufactured by SKCbased in USA
The AirChek® 52, 5 to 3000 ml/min, easy-to-use personal sample pump provides up to 12-hour run times for sampling particulates and gases/vapors. The pump is ideal for use with sorbent tubes, filter cassettes, size-selective samplers, and impingers. UL Listed for intrinsic ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you