Regenerative Thermal Oxidizer System (Thermal Oxidizers) Equipment Available In Latin America
-
Manufactured by Branch Environmental Corporationsbased in USA
In a Regenerative Oxidizer, an effort is made to get the absolutely highest possible energy recovery. This type of design is aimed at low concentrations of organics. Since you can recover a very high percentage of the energy, you can operate with low fuel use. This has to be balanced against any cases where you might actually encounter much ...
-
based in AUSTRIA
The VOXcube purifies organic (VOC) and specific inorganic pollutants in the waste gas. The system is suitable for flow rates up to 125.000 Nm³/h, with a wide variety of concentrations and contaminants. For waste gas temperatures from -20°C up to ...
-
Manufactured by AirProtekt Limitedbased in UNITED KINGDOM
A wide range of industrial processes generates Volatile Organic Compounds (VOCs) as a consequence of using organic compounds as solvents or reactive chemicals. In addition to causing localised odour problems VOCs are implicated in a wide range of environmentally damaging processes, including the generation of low-level ozone and smog. For this reason legislation has been introduced in many ...
-
based in AUSTRIA
The perfect CTP-solution for a combined cleaning of organic pollutants (RTO) and nitrogen oxides (SCR) at high efficiencies. The RTO-i-SCR is suitable for flow rates up to 300.000 Nm³/h at raw gas temperatures up to ...
-
based in AUSTRIA
The perfect CTP solution as an air pollution control treatment for increased solid matter content (dust), sticky substances or corrosive components in the waste gas. The AutoTherm is suitable for flow rates of up to 300,000 Nm³/h, independent of the concentration and the nature of the contaminants. For waste gas temperatures from -20°C up to ...
-
based in AUSTRIA
The perfect CTP-solution for combined cleaning of low laden organic waste gas flows and high caloric off gas and/or liquids even without LEL protection. The Hybrid-RTO is especially suitable for small flows at concentrations > LEL, which occur continuously or discontinuously. Design of the raw gas injection is possible in ...
-
Manufactured by Eisenmann Environmental Technology GmbH - Deurotech Groupbased in GERMANY
Since it uses very little additional energy, regenerative thermal oxidation (RTO) is a highly efficient exhaust air clearing system. In the Eisenmann solution, the complex valve system is replaced by a special air diffuser system with rotating distributor with a high rate of availability and low ...
-
Manufactured by CECO Environmentalbased in USA
Adwest has installed over 1400 flameless regenerative thermal oxidation devices around the world. It has provided thermal oxidation solutions with low cost and high benefit for clients (EPC turnkey project), which effectively reduces the emissions of volatile organic compounds (VOCs), gaseous toxic smog, acid ...
-
Manufactured by Alliance Corporationbased in USA
From a Standard 20’ ISO Cargo Container to Fully Installed and Oxidizing Your VOC’s in an Afternoon. The BOXIDIZER by Alliance Corporation is an economical Regenerative Thermal Oxidizer that achieves a new level of transport simplicity for domestic and export markets. The BOXIDIZER RTO builds upon the proven designs ...
-
Manufactured by Alliance Corporationbased in USA
The KRONUS Regenerative Thermal Oxidizer by Alliance Corporation offers the benefits of high heat recovery and process application flexibility of regenerative thermal oxidization, designed in an economical modular package to create an outstanding overall value in emissions control equipment. The ...
-
PremiumManufactured by Anguil Environmental Systems, Inc.based in USA
Widely considered to be the most energy-efficient oxidizer, Anguil's Regenerative Thermal Oxidizer (RTO) uses ceramic media to recover upwards of 97% of the available energy. What makes our RTO so popular is its ability to repurpose the thermal energy generated during operation to reduce operating costs and ...
-
Manufactured by Pollution Systems Inc.based in USA
Air Pollution Control using a Regenerative Thermal Oxidizer (RTO) is most appropriate in process applications with lower concentrations (up to 10% LEL) of Volatile Organic Compounds (VOCs) and air flows higher than 5000 SCFM. The chief benefits of installing a Regenerative Thermal Oxidizer Media ...
-
Manufactured by QTech Data Systems (NZ)based in NEW ZEALAND
The DATRAN XL4 Plus RTU is based on our fully redesigned industrial grade real-time operating system (RTOS). Supporting over 65,000 data points, the XL4 Plus RTU is ideally placed to provide telemetry and control for Modbus or AB- DF1 PLCs, industrial equipment supporting Modbus, and many other sensors and ...
-
Manufactured by WK ASIA-PACIFIC ENVIRONMENTAL PTE.LTD.based in GERMANY
This combination of a RTO + Adsorber will be used for large air-flows with low VOC concentrations. The VOC will be first adsorbed on the surface of the concentrator. Later it will be desorbed with an up to 30 times smaller air-flow. This high-concentrated volume-stream will be treated then in a RTO. Very consumable-friendly ...
-
Manufactured by Dürr Systems, Inc.based in USA
The patented technology of thermal oxidation for siloxane containing gases. During the oxidation of siloxane-laden exhaust, silicon dioxide (SiO2) will be created. This tends to be very sticky and fluffy in nature and typically results in clogging of the heat exchanger media in regular RTO systems. DeSiTHERM™ avoids this ...
-
Manufactured by Air-Clear LLCbased in USA
System, such as, RTO, Catalytic, and Thermal Systems. Air Clear has several Pre-filter systems operating on our oxidizer systems and other air pollution control manufacturer’s oxidizers. When particulate loading is very high Air Clear offers three effective Pre-Filtering ...
-
Manufactured by Dürr Systems, Inc.based in USA
for the start-up. The most popular sizes of ROxiTHERM™ regenerative thermal oxidiser (RTO) systems are also available in standardised ROxiTHERM™Classic form, pre-assembled in the workshop and supplied off-the-shelf in shortest delivery times. For high input concentrations a hot gas bypass can be installed and for double air flows a ...
-
Manufactured by SECO USA, Inc. | InHand Electronics Incorporatedbased in USA
Based on the NXP™ i.MX 6 SoloX processor, SECO USA created the Fury-X single board computer (SBC). This embedded system enables space- and power-optimized circuitry for real time control and cloud communication for Internet of Things (IoT) and other high reliability applications. The Fury-X offers a wide variety of peripheral ...
-
Manufactured by Pingxiang Annareach Technology Co., Ltd.based in CHINA
Over the past few decades, several different types of heat transfer media (ceramic package) have been used for RTOs. Three main categories are random packing, monolithic structured block and corrugated structure packing. Ceramic blocks ( regenerative material) are widely used in the RTO projects, which is one of the air pollution control ...
-
Manufactured by Nuova Idropress S.p.Abased in ITALY
The Vertical Block Moulding Technology A direction opened by Nip way back in 1971 ! Suitable for Densities of 6 ÷ 80 kg/m³ (0.37 ÷ 5.0 lb/ft³) For Block size between 1,0 x 0,5 x 1,0 m (40 x 20 x 40 in) and 8,0 x 1,4 x 2,6 m (315 x 55 x 102 ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you