Only show results available in Virginia? Ok

Waste Gas Applications

  • Premium

    Waste to Energy

    We can treat the air streams from waste management plants, MBT (Mechanical Biological Treatment) reception and composting areas, Waste Water Treatment Plants (WWTP), Refuse Derived Fuel (RDF) Plants, gasification of waste, syngas, torrefaction, gas engines and biogas upgrading. In waste management plants and WWTP, we remove the odors that may be causing a nuisance to neighbors, with bioreactors using Biomass to degrade odorous components and where odors are particularly intractable or VOC emissions higher, thermal oxidizers to meet prescribed emission limits and odor levels. In RDF Plants, Syngas, Gasification, Gas Engine and Biogas Upgrading applications, we employ thermal oxidizers, particulate removal and DeNOX systems, for the control of VOC, NOx, CO and particulates to prescribed emission limits.

    By Babcock & Wilcox MEGTEC based in De Pere, WISCONSIN (USA).

  • Premium

    Humid, corrosive and malodorous waste gases

    CTP's expertise with different coating systems, and an energy-saving pre-heater, protect the installation from corrosion even when waste gases are humid.

  • Premium

    Several waste gas streams: Short, high concentration peaks and a constant |medium concentration

    Concentration peaks and liquid waste posed a tough challenge on the air pollution control system. With the CTP solution, this waste is not only disposed of but also reduces the burner energy considerably.

  • Premium

    Gas suction in landfills

    By Aerzener Maschinenfabrik GmbH based in Aerzen, GERMANY.

  • Premium

    Very large waste gas volumes with low contaminant concentration

    The CTP desorption allows for an especially high concentration factor which, in turn, reduces the cost of ownership and permits an auto-thermal operation (additional burner switched off) even when the contaminant concentration is low.

  • Premium

    Thermal waste gas purification of siliceous organic compounds

    The cleaning problem of the heat exchangers was solved. The contaminants were destroyed efficiently and economically while steam for the production process was generated at no additional cost.

  • Premium

    Fly Ash - Industrial Vacuum

    Fly Ash can cause many problems. The Vac-Con & Vector Pneumatic Vacuum systems can assist and solve many of these problems. Our high-performance vacuum systems are manufactured in three basic configurations: Truck mounted, Trailer mounted, and Fixed/static installed. Any of these systems can be integrated into the existing power plant design. All of our vacuum systems can be utilized to solve your plant’s fly ash removal/clean-up needs and can assist in many other maintenance projects. All can be tailored to fit into your power plant’s specific needs. Vac-Con Truck mounted Industrial vacuum systems are equipped with large storage debris tanks with self-cleaning intake filter systems. The Industrial Trucks vacuum the waste products through existing manifold piping or with hoses attached directly to the debris tank. When fully loaded, the truck can then drive directly to the disposal site and discharge the waste products. The Industrial Truck offers a great amount of flexibility of operation and can be utilized anywhere in your facility for many different types of normal and emergency maintenance operations. The Vac-Con Industrial Vacuum Truck can be utilized on both wet and dry materials. The same Vac-Con truck can be used for removing Fly Ash from your plant, coal from broken intake belt conveyors, or used to suck wet muddy material from storage lagoons. The Vector Trailer mounted Vacuum Systems are designed to be used in several locations around power plants. The Trailer mounted Vacuum Systems connect to Manifold piping located in key areas within your power plant. The Vacuum systems move the waste products from the plant and deposit these products into moveable storage containers. The loaded storage containers when full can then be moved to the disposal sites for discharge. Vector Static Mounted Vacuum systems are designed to vacuum and remove Fly Ash and other bulk waste products through manifold piping from operational areas of the plant and deposit these waste products into collection storage silos for later transport to disposal sites. The fixed vacuum systems are electric motor driven and are normally installed as a permanent addition to in-plant existing conveying systems. Please contact us with any requirements you may have. We will evaluate your request and respond with solutions specific to solve your problems and fit your needs.

    By Vac-Con, Inc. based in Green Cove Springs, FLORIDA (USA).

  • Premium

    Product and services for industrial - refineres industry

    For industrial customers, we offer cost-effective and environmentally attractive alternatives to oxidize, precipitate, segregate and remove unwanted pollutants, contaminants and by-products from waste streams and industrial processes. Whether using our time-proven CAIROX®, AQUOX®, and LIQUOX® permanganate-based products, our manganese based CARULITE® catalyst, or any of our other newly developed technologies, our long history and unmatched experience and environmentally friendly expertise provides customer specific solutions to many diverse industries.

    By Carus Corporation based in Peru, ILLINOIS (USA).

  • Premium

    Several waste gas streams: Highly contaminated oxygen-free waste gas,|and medium waste gas stream

    Explosive oxygen-free waste gases are disposed of and contribute to the oxidation process of the contaminants.

  • Premium

    Wastewater treatment solutions for waste sector

    IDRAFLOT flotation units are technological solutions which allow the separation of the suspended solids from wastewater coming from gas scrubber blow down (high concentration of SS) but also for the separation of low density compounds (oil and fats) which can be present in the streams collected by collectors. IDRAFLOT units can be easily installed also within small footprint collection centres.

    By IDRAFLOT based in Zoppola, ITALY.

  • Premium

    Industrial Solution for gasification & synthetic gas

    Gasification and synthetic gas production from various waste products are becoming increasingly important energy recovery technologies. Often, the synthetic gas contains various hazardous contaminants including H2S, HCl and other acids, heavy metals, and tars. The gas requires cleaning before it is introduced in the engine or boiler. Most of these processes generate significant concentration of tars. The tars can vary from very low molecular weight to large and complex chains.

    By Macrotek Inc. based in Markham, ONTARIO (CANADA).

  • Wilsa ElectroWaveTM - Oil Harvesting / Removal

    WILSA Harvests Oil from Tank Bottom Sludge at Disposal Well. ElectroWave™ Technology optimizes onsite processing and reduces costs associated with saltwater disposal operations by breaking waste emulsions and recovering additional oil.

    By Hudson Industries based in Warren, OHIO (USA).

  • Biogas for Cooking

    This solution comprises a Biogas Digester of desired capacity working with specific substrate as input. It may or may not have H2S scrubbing system, depending on the quantity of H2S in the biogas and the requirement by the customer for cleaning it. As the heating value of biogas is almost half that of cooking LPG, specially designed biogas burners are provided to improve cooking speed. Depending on the demand by the customer, a blower to increase gas pressure may be employed.

    By Kirloskar Integrated Technologies Limited based in Kothrud, INDIA.

  • Oxygen Generating Systems for Waste Gas Treatment in the Semiconductor, PV and LED Industries

    Waste gas treatment is an often overlooked but important function of Semiconductor, PV and LED fabrication. Several serious accidents have taken place in factories where no abatement was installed. Even today waste treatment is often seen as a cost rather than a safety issue. There are three main reasons why waste gas treatment is installed in factories: health and safety, environmental factors, and quality control.

    By Oxygen Generating Systems Intl. (OGSI) based in North Tonawanda, NEW YORK (USA).

  • Flares for Safe Disposal of Waste & Toxic Gases

    Our Flares are versatile in design & suitable for total destruction of waste gas/vapours. The waste gases/Vapours from petrochemical, WWTP, chemical plants have very high potential for environmental hazards. If allowed to released unburned into atmosphere. SIES offers flares and combustion systems for safe disposal of gases with high efficiency and reliability. System Designed to meet the API 521/537 norms High efficiency Burners with up to 99% thermal destruction Flares operable on fully automated, SCADA based solutions Customized & Cost effective project specific solutions Successful Installations of various types of flares at various locations.

  • Biofiltration

    Biological Aerated Upflow Filtration (BAF) for high efficient Waste Water Treatment in Refinery Industry with more than 20 reference plants and more than 20 years of experience

    By AquaBiotec based in Paris, FRANCE.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you